基带

It was a rectangular piece of woolen or linen fabric sewn partway up the sides and fasted on each shoulder by a tied belt.

基同通过将长方形的羊毛或亚麻面料两侧缝合，肩部用别针固定而成。毛制多利克基同，上端折叠，腰部系带。

Moreover, the hot compressive deformation behavior of the RS/PM AZ91 magnesium alloy and AZ91 alloy matrix composite were also investigated, the conclusions are drawn as follows:1. The processing parameters of the atomization-twin rolls quenching technology were optimized as follows: the diameter of the nozzle 1mm, the wheel velocity 25m/s, the pressure of atomization gas 0.3MPa and Ar gas for melt injection 0.1MPa. The RS AZ91 alloy flakes exhibited fine and uniform microstructures. When the flakes were extruded at 673K, extruded velocity of 0.1mm/min and extrusion ratio of 25:1,the magnesium alloy rods with clean surface, uniform dimension and excellent mechanical properties were obtained.2. The RS AZ91 magnesium alloy powders prepared by atomization-twin rolls quenched technology exhibited fine equiaxed grains with the grain size of 1-3μm, the phase constituent included supersaturate solid solution phaseα-Mg and miner fineβ-Mg_(17)Al_(12) phase. The as-extruded materials also exhibited equiaxed grains with the size of 5-7μm and a large number of fineβ-Al_(12)Mg_(17) and fewer AlMg_2Zn phases were detected in the alloy.

本文还研究了快速凝固/粉末冶金AZ91镁合金热压缩变形流变应力行为，快速凝固/粉末冶金法原位生成Mg_2Si增强AZ91镁基复合材料，经过系统的研究，获得如下结论：1、雾化-双辊急冷法在下列工艺参数组合下：双辊线速度25m/s；喷嘴直径1mm；熔体压射压力0.1MPa；雾化气体压力0.3MPa。，可获得宏观尺寸细小、微观组织均匀细小、综合性能优良的的快速凝固AZ91镁合金细碎箔带，快速凝固箔带在挤压温度为673K、挤压速度为0.1mm/min，挤压比为25：1时，可获得的外表光洁、尺寸均匀、组织性能优异的镁合金棒材。2、雾化-双辊急冷法制备的AZ91镁合金粉末态为细小等轴晶组织，晶粒尺寸1-3μm，组织为α-Mg过饱和固溶体和微量的细小β-Mg_(17)Al_(12)相组成；粉末挤压棒材为等轴晶组织，晶粒尺寸5-7μm，组织中含有大量细小的β-Al_(12)Mg_(17)以及AlMg_2Zn析出相，室温力学性能，抗拉强度383MPa，屈服强度275MPa，断后伸长率7.5%。

Inflorescence glabrous or matted ferruginous villous and shortly whitish tomentose (whitish hairs mostly on pedicels); peduncle 2.5-5 cm; thyrse conic or cylindric-conic, 10-30 cm, 6-10 cm wide at base; branches 2.5-5 cm, 4-12-flowered; pedicels 3-6 mm.

花序无毛或簇生具铁锈色长柔毛和短带白色被绒毛的(带白色毛多数在花梗上的)；花序梗2.5-5厘米；聚伞圆锥花序圆锥或者圆筒状圆锥形，10-30厘米，6-10厘米宽的在基部；分枝2.5-5厘米，4-12花；花梗3-6毫米。

According to the H NMRstudy, it was found that the protons on the cyclopentadienyl ring of 〓 were not splitted, but when one proton on the cyclopentadienylring was substituted by methyl, that is in〓 complexes, thefour protons on the ring were splitted into four groups,the 〓 between the onesignal and the others is large, the total splitting is over 2ppm. The splittings werealso affected by the halides linked with the titanium, they increase according to theorder of CI, Br, I. By the study of the 〓 Sn NMR, it is found that the chemicalshifts of 〓 are present in low field. It is assume that the large space strain causesthe angles of the tin linked with ligands deviate from the normal tetrahedral anglesresults low field shift for 〓Sn. And by MS study,there were no molecular ions for 〓 complexes in the spectra. However, for 〓 when X=CI,Br,NCO and Ar is tolyl or phenyl group,there were molecular ions,but theirabundances were very small,and no that for the iodide was found.

钛上的卤素对茂环氢的裂分也有影响，依〓，Br，I顺序，卤素对茂环氢的裂分依次加大；通过对〓的研究发现，以上这些化合物〓的化学位移都出现在低场，认为大的空间张力造成的锡的键角偏离正常的锡的四面体键角是造成〓化学位移出现在低场的原因；对这些化合物质谱的研究发现，〓系列化合物得不到分子离子峰，而〓系列的化合物，当X=〓，NCO和苯环上不带取代基或只带甲基时，则出现分子离子峰，但丰度很低，而相应的碘化物和其它化合物则没出现分子离子峰。

Wherefore I have brought him forth before you, and ecially before thee, O king Agria, that, after examination had, I might have somewhat to write.

因此我带他到你们面前，也特意带他到你亚基帕王面前，为要在查问之后，有所陈奏。

And on the morrow, when Agria was come, and Bernice, with great pomp, and was entered into the place of hearing, with the chief captai, and principal men of the city, at Festus' commandment Paul was brought forth.

25：23 第二天，亚基帕和百尼基大张威势而来，同着众千夫长，和城里的尊贵人，进了公厅。非斯都吩咐一声，就有人将保罗带进来。

The geometry structures have been optimized by semiempirical method AMI, on the base of this, the electronic properties and energy band structure of typical polymers were performed by EHMACC. The influence of photo-electricity on PPV-like electroluminescent polymers substituted by alkyloxy and cyano were discussed.

采用半经验AM1方法优化体系的几何结构，在此基础上，对典型的聚合物采用EHMACC程序计算能带结构，讨论烷氧基和氰基取代对PPV类电致发光聚合物光、电性质的影响。

The study of their precise UPb geochronology and characteristics of rock associations shows that (1) small amount of EarlyTriassic (~248 Ma) volcanic rocks were preserved and cropped out in the area, which consist mainly of thin bed of andesitic rocks intercalated with minor basaltic andesites; that (2) the MiddleTriassic magmatism was characterized by extensive felsic igneous rocks with minor basalts interbedded in the middle of volcanic sections in part of areas, and the late MiddleTriassic rhyolites and main body of Lincang granitic batholith have the same extrusive/intrusive time with the age of ~230 Ma; that (3) the LateTriassic volcanic sequences are principally composed of basalts with minor interlayered rhyolites, exhibiting typical characteristics of bimodal volcanics.

三叠纪岩浆作用广泛发育于澜沧江南带，锆石UPb年代学结果及岩石组合特征显示：(1)该区残留有少量的早三叠世火山岩(约248 Ma)，主要为一套薄层的以安山岩为主的火山岩；(2)中三叠世以大规模的酸性岩浆作用为主，部分地段的中部夹有少量的玄武岩，其中晚期的流纹岩与该区出露巨大的临沧花岗岩基主体具有一致的形成时代(约230 Ma)；(3)晚三叠世则以基性火山岩为主，夹少量流纹岩为特征的&双峰式&火山岩组合。

In this paper, a series of 4,5-dithiacrown ether annulated 1,3-dithiole-2-thiones 8a~8d were prepared via condensing 4,5-bis-1,3-dithiole-2-thione (7) with 1,ω-dimercapto polyglycol derivatives in high dilution. The obvious template effect was found during the synthesis of 8c-8d.

在高度稀释条件下，经4，5-二溴甲基-1，3-二硫杂环戊烯-2-硫酮(7)和多缩乙二醇的1，ω-二巯基衍生物的缩合反应，方便地合成了4，5-位带二硫杂冠醚残基的2-硫代-1，3-二硫杂环戊烯的衍生物8a~8d，中间体硫杂冠醚8c~8d的合成中有明显的&模板效应&。

In this paper, a series of 4,5-dithiacrown ether annulated 1,3-dithiole-2-thiones 8a~8d were prepared via condensing 4,5-bis-1,3-dithiole-2-thione (7) with 1,ω-dimercapto polyglycol derivatives in high dilution. The obvious template effect was found during the synthesis of 8c-8d.

在高度稀释条件下，经4，5-二溴甲基-1，3-二硫杂环戊烯-2-硫酮(7)和多缩乙二醇的1，ω-二巰基衍生物的缩合反应，方便地合成了4，5-位带二硫杂冠醚残基的2-硫代-1，3-二硫杂环戊烯的衍生物8a~8d，中间体硫杂冠醚8c~8d的合成中有明显的&模板效应&。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。