型片

The targets shapes include: tube, sheet, powder, plate, rectangle and wreath which can also provide metalized and bonding service for the customers.

靶型有：管状，片状，粉状，圆盘形，平面矩形，环形，规格齐全，也可为用户提供金属化和帮定服务。

"Investigation and Development of Miniaturized Chip...

47，281，可应用在无线区域网路之小型化晶片型双频带通滤波器的。。。

The seeds of Adzuki bean were irradiated by 60 Co γ ray of 0～700Gy.The results showed that:(1)The sub\|lethal dose(LD 50 )was 389Gy and the early seedling leaf at M\-1 showed incised,chlorotic,yellow,mosaicand curly edge.The absorbed dose was related with the rate of misshaped leaf.Chromosomal aberration, chromosome bridge and fragment of M\-1 in the tip were observed.If the seed was irradiated with 400Gy,the rate of abnormal cell at the root was more than 10%.The relationship between pollen fertility and irradiation dose was negative correlated.

本试验研究结果表明：60 Coγ射线辐照小豆种子的半致死剂量平均为 3 89Gy ，且M1生长初期叶片性状有明显的叶面缺刻、叶色缺绿、叶形不对称、叶缘卷曲、花叶、黄叶等致变现象，各种畸型叶出现频率与辐照剂量大小有关；M1根尖细胞中有多种染色体畸变类型，以染色体桥和断片频率较高，辐照剂量在 40 0Gy以上时根尖细胞异常率达 1 0 %以上；植株花粉育性与辐照剂量呈极显著负相关，京农 2号植株花粉育性达 5 0 %时的辐照剂量为 3 78Gy。

A stability of hue had been gradually concentrated within a certain range accompanying with the increase of opaquing ceramic thickness.

使用TC—PHG型全自动测色色差计测定样品片的x、Y、△L^＊值，研究不同品牌不透明层厚度与色度的关系。

The objectives of this paper were to investigate the simulation and design of continuous multiple-station rolling forming process for a U-Section Steel Bar by CAE software-DEFORMTM Due to the limitation of elements number using a short strip 120mm went through all the stations to simulate the real continuous rolling forming on factory The roller gap was fixed as 0 30mm roll speed was 20 rad/sec and progressive angles were all equal for each rolling process which were the formed angle divided by by the number of station Three rolling processes were selected with 6 9 and 12 stations respectively During simulation processes two cases occurred Case A the strip was through a single station Case B the strip across two stations Because the strip laterals side was stretched and twisted during the process The model of case B closer to the practical process than case A and the calculated stress and strain on the tip of U section for case A were lower than these for case B by up to 15% From the result of case B for each process the stress for 12-station process was smallest 9-station process second and 6-station process next Because less-station can save larger cost and forming time but the bigger stress and strain for 6-station caused wrinkles on lateral sides not found on 9-station and 12-station Therefore 9-station process was a more suitable design than 12-station process smaller stretched and twisted and stress The progressive angles for 12-station was 7 5?

本文主要是以DEFORMTM有限元素软体模拟U型钢片连续道次成型与单一道次成型以确认单一道次模拟的是否可取代连续道次模拟之研究。因DEFORMTM 软体对於网格元素上的限制故使用较短素材120mm通过所有的成型站以模拟工厂实际连续成形方法。辊轮间隙固定为0 3mm；辊轮转速为20 rad/sec；弯曲角度的方法为将成型角度平均除以成型站数。有三种辊轮成型方式被选择分别为6站，9站，与12站。在模拟的过程中有两种现象会产生 Case A，素材通过单一成型站。Case B，素材会通过两个成型站。因为在模拟过程中素材的两端会有拉应力与扭力。Case B的模拟比Case A像实际的制程，并计算应力与应变在U型断面的Tip部中可发现Case A比Case B低约15%。从Case B的每站的结果可以得知，12站的成型应力最小，9站次之，6站最后。

Wang Lei Group always adhere to the "system innovation, management innovation, technological innovation," self-developed high-tech high-finned tubes, wires electromagnetic environment-friendly, clean-water pipes of copper, brass, thread, air conditioning and refrigeration with brass, Pai copper, copper strip and a series of high-quality products.

宏磊集团始终坚持&制度创新、管理创新、技术创新&，自主研制开发了高科技高翅片管、环保型电磁导线、洁净型铜水管、内螺纹铜管、空调与制冷用铜管、铜排、铜扁线等一系列高品质产品。

Some annuals with good scents are sweet alyssum, the large flowering tobacco "Nicotiana Sylvestris", the Regal Lily, which flaunts clusters of trumpet-shaped white flowers, and velvety purple heliotrope.

有一些一年生植物能够散发出很香的味道，例如香雪球，例如在那盛放的Nicotiana Sylvestris，例如那在一片喇叭型的白花和柔软的向日葵中倍显尊贵的百合。

Its low processing temperature, plasticization time is short, can be used for asbestos PVC plastic flooring material and crowded, non-filled rolling film, calendering film, printing film, artificial leather, gas tubes, rubber, the coating thatch cloth, foam sheet, profiles , pipe, foam and a variety of shoe materials, plastic poly vinyl acetate emulsion adhesives, etc., as well as some cable granulation industry.

其加工温度低，塑化时间短，可用于PVC石棉地板料和挤塑料、非填充压延薄膜、压延膜、印花膜、人造革、煤气管、橡塑条、涂塑苫布、泡沫片材、型材、管材、发泡以及各种鞋料，聚塑醋酸乙烯乳液粘合剂等以及部分电缆造粒行业。

By the combination of experimental results with theory of crystal growth, some growth models and growth mechanisms were proposed. Research results confirmed that pillar-shaped TaC whisker with spherical droplet at the end grew via a vapor-liquid-solid mechanism, pillar-shaped whisker with pyramid-like end was formed via a vapor-solid mechanism, awl-shaped TaC whisker with zigzag end formed via a liquid-solid mechanism, awl-shaped TaC whisker with growth step at the end has a growth mechanism of screw dislocation mechanism. The growth mechanism of dumbbell-shaped MgO nanowhisker and NaCl particle-decorated MgO nanowhisker is VS; C and MgO powder-yielded MgO nanowhisker was formed via a VLS mechanism, Mg powder-yielded MgO microwhisker and MgO microsized or nanosized crystal sheet grew via a VS mechanism. In the Si and SiO〓 nanostructures, Si nanowires formed in higher-temperature zone grew via oxide-assistant mechanism, while Si nanowires or nanorods formed in lower-temperature zone have a growth mechanism of VLS, and the growth mechanism of SiO〓 nanowires is VS.

研究确定呈平直柱状且头部带有球形颗粒的TaC晶须是通过气-液-固机制生长；头部呈之字型的锥状TaC晶须则通过液-固机制生长；晶须头部为四棱锥状的粗长TaC晶须的生长机制是VS机制；顶端呈锥状且有生长台阶的TaC晶须通过螺位错机制生长；哑铃状氧化镁晶须和氯化钠颗粒修饰的氧化镁纳米晶须的生长机制是气-固机制：当采用C+MgO粉提Mg源时形成的氧化镁纳米晶须的生长机制是VLS，而采用直接热蒸发Mg粉时得到的氧化镁微米晶须的生长机制为VS，纳米和微米晶片的生长机制均为VS机制；在高温区，硅纳米线的生长机制是助氧化机制，在低温区硅纳米线和纳米棒的生长机制是VLS机制，而氧化硅纳米线的生长中VS机制占主导地位。

Exhibits:Plastil soft\rigidpipe drink straw pipe extrusion machine, Plastil imitate rattan extrusion machine, Plastil making granule(single/twin screw)extruder, Plastil flat\solid super plank extruder, Plastil soft rigid abnormal profile extrusion machine, TPU\TPR Rubber band extrusion machine, PP Bale strap extrusion machine, PP\PC Hollow shutter extrusion machine

展出内容：塑胶软、硬管、饮料吸管押出机，塑胶仿藤押出机，塑胶造粒押出机，塑胶片、板、超厚板押出机，塑胶型材押出机，TPU、TPR橡筋押出机，PP打包带押出机，PP、PC中空板押出设备

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。