垂直轴
- 与 垂直轴 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
For example, the limb s of anticline you have just measured dip toward opposite direction and the dip angles are basically identical. In profile, the anticline has a vertical axial plane. This type of fold is called upright fold.
例如,你们刚才测量的那一个背斜,它的两翼向相反方向倾斜,倾角基本相等,在横剖面上,这个背斜的轴面是垂直的,这种轴面直立的褶皱叫做直立褶皱。
-
Once the Device Context has been initialized, the origin of the coordinates is usually the upper-left corner of the output rectangle, while the x coordinate axis is horizontal right and the y coordinate axis is vertical downward, with both using pixel as unit.
一个设备上下文被初始化之后,其坐标系原点通常是输出矩形的左上角,而 x 轴水平向右,y 轴垂直向下,并以象素为单位。
-
The results showed that the buckling in the plane perpendicular to the axle is the reason for the super high anisotropy.
结果表明纳米管束在垂直于轴向的面内屈曲是造成面内模量远小于轴向模量的主要原因。
-
Because the optical system of optical characteristics and the nature of the launch of the optical microscope is not the true meaning of the linear shift-invariant systems, the PSF is usually perpendicular to the optical axis in the xy plane was the distribution of radial symmetry, but the direction along the z axis significant expansion.
因为光学系统的特点和发射光的性质决定了光学显微镜不是真正意义上的线性移不变系统,所以PSF通常在垂直于光轴的x-y平面上呈径向对称分布,但沿z光轴方向具有明显的扩展。
-
One or more plane sections (8,9) and part cylinders (10,11) connecting to the plane sections (8,9) are formed at the outside (7) of the capillary using for fixing the fiber, all the part cylinders (10,11) are formed with a single center axis and the same radius, meanwhile a patchhole (3) of the inserting fixed fiber (2) is formed in the deflected position of the center axis and in the vertical direction of the first plane section (8) which is used as the standard.
在光纤固定用玻璃毛细管(1)的外面(7)形成有一个或多个平面部(8、9)和与该平面部(8、9)连接的一个或多个局部圆筒面(10、11),该所有的局部圆筒面(10、11)都是以单一的中心轴和相同半径形成的,同时在与作为基准的第一平面部(8)垂直的方向上从中心轴偏离的位置上形成有插入固定光纤(2)的插入孔(3)。
-
If there is an input rotation rate on the vibrator,an induced voltage proportional to the angular rate will be produced in the direction perpendicular to the plane composed by the polarization axis and the input angular rate axis according to the Coriolis effect.
由PZT薄膜材料做成的平板沿厚度方向极化并受电激励产生厚度伸缩振动,当一输入角速度作用于振子,根据哥氏效应,则在极化轴和输入角速度轴组成的平面垂直方向上产生一正比于输入角速度大小的感应电压。
-
The orthographic projection of thread will produce when the axis of thread is vertical to optical axis, which can reflect the real shape and size of thread, but the experiment and calculation show that the spiral line of thread will shield part of the teeth contour in projecting plane, and so to cause a projection with flaw.
当线的轴是垂直的时候,线的正字法发射将会生产对光学的轴,能反映真正的形状和线的大小,但是实验和计算表演线的螺旋形线将会在突出的飞机中保护牙齿等高线的部份和如此用缺点引起发射。
-
Three axes are of equal length and are symmetrically placed in one plane, and the fourth axis is perpendicular to the others.
三个轴是有相等的长度并且被相称性地放在一个飞机之内,而且第四个轴与其余者成垂直。
-
Fetal transverse position when the longitudinal axis of the vertical longitudinal axis and the mother is the most fetal position is not conducive to giving birth.
横位时胎儿纵轴与母体纵轴相垂直,是最不利于分娩的胎位。
-
D1.1 of the AISI Specification limits the maximum longitudinal spacing of connections to ... where smax = maximum permissible longitudinal spacing of connectors L= unbraced length of compression member rI = radius of gyration of I-section about the axis perpendicular to the direction in which buckling would occur for the given conditions of end support and intermediate bracing rcy = radius of gyration of one C-section about its centroidal axis parallel to the web.....
因此,AISI规范第D1.1节限定连接的最大纵向间隙为:,式中 smax =连接体允许的最大纵向间隙 L=抗压构件的自由长度 rI =工字钢对垂直于给定端承和中间肋条件下可能产生纵向弯曲方向的轴的回转半径 rcy =一段U型钢对其平行于筋的质心轴的回转半径。。。。。。。
- 推荐网络例句
-
We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.
索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称;三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起,称之为挽歌体诗人或者史诗诗人,他们被称为诗人,似乎只是因为遵守格律写作,而非他们作品的模仿本质。
-
The relationship between communicative competence and grammar teaching should be that of the ends and the means.
交际能力和语法的关系应该是目标与途径的关系。
-
This is not paper type of business,it's people business,with such huge money involved.
这不是纸上谈兵式的交易,这是人与人的业务,而且涉及金额巨大。