垂直的位置

The system adopted active tracking,namely calculate the input angle of the tracking device in advance,the angle is correspondent to the sun position some moment.Photoelectric sensors react the sunlight that putting on different position of the platform, feedback electrical signal.Then single-chip applys the subprogram and sends out pulse to step motors according to the signals,can control the rotate angle and direction of the step motor. The mechanism has realized the automatic track to the sun, so that the trackers top flat board can be always vertical to the sunlight and arrive the furthest receiving energy.

系统采用主动式跟踪，即预先计算好对应于某时刻太阳位置的跟踪机构的输入角度，通过跟踪器上平台不同位置上摆放的光电传感器感受该太阳位置的光照，反馈回电信号，单片机根据该信号调用子程序发出脉冲对步进电动机的转动角度和方向进行控制，实现了机构对太阳的自动跟踪，使跟踪装置的上平台始终处于垂直于光照方向，达到了能量最大限度的接收。

The apparatus regards the laser beam, emanating from the laser device, which can emit the perpendicular laser to the earth, as the measuring norm. The facula on the autodyne, which clings to the guide way during the measuring, is sampled to computer with a CCD camera and an image acquisition card. By computer image proce~sing, the measuring apparatus can identify the displacement of the facula center .By this way it determines the verticality error of the guide way at the measuring position, which can be recorded automatically at the same time.

该测量仪以激光自动安平垂准仪发出的激光为基准，紧贴导轨运行的接收装置上的光斑经CCD相机和图像采集卡采集到计算机后，通过计算机图像处理识别出光斑中心的位移量来确定电梯导轨在测量位置的垂直度偏差，同时自动记录测量所在位置。

The result shows that the technical style of our athletes used is that stride length is shorter and stride frequency is larger,the buckjump time of our players is located at the floor level of the foul limit,the knee angel is unwind from touchdown on upright phase,in the sprint phase,the kneel angel is blurry from touchdown to upright phase,the uprightness displacement of body center and vertex are higher than the international athletes, this since stretching to leave a ground of opportune moment to be partial to early and making an effort action insufficiency with leg driving of the ankle joint relevantly, also with the leg put of front stretch is not enough active at the touchdown ground moment.

结果表明，我国运动员在后半程中，运用的是步长较短，步频较快的技术风格；腾空时间总体上处于犯规时限的下限，膝关节从着地瞬间直至垂直支撑面保持了可见的伸直状态，但在最后冲刺阶段，膝角出现了模糊伸直过程；身体重心垂直位移、头顶位置上下起伏均高于世界优秀运动员平均水平，这既与踝关节后蹬伸展离地时机偏早、用力动作不充分有关，也与着地瞬间摆动腿前摆后的前伸着地动作不够积极有关。

The method is :there are two perpendicular axes whose distance are controlled ,one is the axis of work table, the other is fixed with a microscope for aiming.

该测量方法是：两个相互垂直且间距可调的数控回转轴，一轴与工件的回转中心重合，另一轴上固定可移动的瞄准显微镜，当显微镜瞄准被测孔时，两轴的转角由各自的圆光栅测出，两轴之间的角度位置确定曲面壳体零件上小孔的孔位置，同时采用CCD摄像头，利用图象处理技术实现小孔的尺寸测量。

Using stereomicroscope, we observed the fracture line direction and location as well as the angle between the fracture line and the attrite plane. The data was compiled into statistics and analyzed. The results revealed that most of the vertical root fractures occurred in teeth with severe attrite crown and flat root. Numerous bucco-lingual oriented fractures occurred in the mesial root of molars, and we found three non-endodontically treated cases with mesio-distal oriented fractures in the palatal roots.

结果发现，两组的垂直牙根断裂均好发於牙冠严重磨耗（77.4-88.2%）且扁平的牙根（61.8-75.8%）上，以大臼齿的近心牙根发生率最高（64-85.7%），多为颊舌侧走向（91.2-91.9%），且於未根管治疗组别亦发现三例腭侧根断裂，走向为较宽的近远心方向，显示牙根断裂会沿著牙根较宽的方向发生；同时，未经根管治疗而产生垂直牙根断裂的牙齿具有根叉位置较低的现象（61.8%），牙根於比例上有较短小的特徵。

For the tetracene overlayer near to a monolayer, formation of a parquet-like pattern was observed.

当分子长轴取向垂直于[1-210]方向并且其质心位于密排原子列上两个Ru原子的短桥位时，该位置是它的次佳吸附位，在该位置的吸附能为4.19 eV。

First, the color-image was preprocessed with grayscaling, smoothing. The vertical gradient components of the image were found using the vertical mask of Sobel operator. Then the candidate areas with sufficient amount of edges were determined by calculating the gradient of edges. After finding possible vehicle candidates, the proposed method measured the prominent vertical symmetry of candidate areas and verified all possible candidates, as symmetry is an important feature of vehicle. The proposed method also figured out the vertical axis of symmetry and the width of the candidate vehicle.

算法首先对图像进行灰度化、平滑去噪等预处理，使用Sobel算子垂直方向掩模计算图像感兴趣区域内的边缘梯度，确定候选区域；而后根据车辆图像垂直边缘具有对称性的特点，分析候选区域的对称性强弱，并计算其对称轴位置和车辆宽度。

Compared with the sail style and the hang style, the hitch kick style have advantages to join the front swing and trig swing of swing leg tightly, to speed the buffer and stretch of take-o?leg, to acquire more vertical muzzle velocity and to decrease losing of horizontal velocity, which results in more velocity and more angle when take o?.and more vertical height of body center, has advantage to obtain better result.

走步式空中技术能在起跳过程中通过紧密衔接的摆动腿加速前摆和制动前摆，加快起跳腿的缓冲和蹬伸动作速度，促进身体重心获得更大的垂直速度，而且水平速度没有更多的损耗，从而获得更大的腾起速度和腾起角，腾起时身体重心的垂直位置更高，最终取得优异成绩，促进跳远起跳技术朝着快速积极的方向发展。

A movable plane is built that is perpendicular to the projection of sightline in xz plane; a radial from camera position to mouse point is built and the mouse wheel is used to control the forward and backward movement of the movable plane along the sightline direction; the intersection point of the mouse radial and the movable plane can be moved to any position in 3D space by moving the moveable plane; the coordinate of the intersection point of the radial and the moving plane is calculated, taken as the new coordinate of the object to be moved which is added into the romance pipeline, and the object movement can be implemented.

论文摘要：为优化虚拟三维管理领域的物体移动操作，实现利用鼠标完成物体在三维空间中任意点的移动过程，引入可移动平面的概念，在三维空间建立垂直于视线在xz平面投影的可移动平面；建立1条从摄像机位置到鼠标位置的射线，由鼠标滚轮控制可移动平面在视线方向上的前后移动；通过移动可移动平面，使鼠标射线与可移动平面的交点可以到达三维空间中的任意位置；计算射线与可移动平面的交点坐标，将其作为待移动物体新坐标放入渲染流水线，从而完成物体移动。

Using density functional theory, the adsorption of cyanide on the different sites of Cu(100) surface was studied with end-on and side-on geometries.

采用密度泛函方法，以原子簇Cu14 为模拟表面，对CN自由基分子在垂直和平行Cu( 10 0 )表面不同位置的吸附情况进行了研究，结果表明：通过原子C垂直吸附在表面的顶位是其最佳吸附方式，吸附后CN键振动频率发生蓝移；而其它吸附方式中CN键振动频率均发生红移。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。