坯

The slag-adjusting agent has the function of slag adjust.deoxidation,desulfurization and encrusting matter removal in steel so that it has greatly improved the quality of casting block.

由于该调渣剂有改渣、脱氧、脱硫及去除钢渣中夹杂物的作用，因此大大改善了铸坯质量。

The results show that the fluidity of extruded state alloy is the lowest.

半固态坯的流动性能是获得优质、复杂制件的基础和关键。

In order to meet the need of high speed continuous casting,the moulding powder demands lower viscosity,lower crystallization temperature,lower intenerating and melting temperature,high melting rate,optimum basicity and chemical composition.

高速连铸保护渣的物化性能不同于普通连铸，应具有低粘度、低结晶温度、低软化及熔融温度、较快的熔化速度以及合适的碱度和化学成分等特性，以满足高拉速的需要，减少生产事故，提高铸坯质量。

Through studying the intenerating and flowing character,the relative displacement of crystal grain of glass ceramics-ceramics composite material,the temperature field distribution law when the compound flat was heated,pressed and bent was discussed.

本文通过研究微晶玻璃-陶瓷复合材料在高温下软化流动的特征和晶粒相对位移的特点，论述了复合平板加热、加压弯曲过程中的温场分布规律，并由此制定出合理的温度制度，使复合板微晶表面和坯体在合理的温度制度、温场分布制度下同步弯曲成为所设计的曲面。

The green body's bending strength was 3.916MPa after jelling and drying under special temperature and time using nitric acid as a curing agent.

以硝酸为固化剂在一定的温度及时间内胶凝固化并干燥，可以得到抗弯强度为3.916MPa的生坯。

Comparing 10 kinds of fat liquors, the penetrability of fat liquoring agents in the chrome-free pigskin garment leather, and the physical-mechanical properties of fatliguored chrome-free leather were studied.

对比研究了磺化油加脂剂STO、SEO、SHO、KS-1和6种常用加脂剂在无铬鞣猪皮服装革中的渗透情况及其加脂后坯革的物理-机械性能。

Compared with 6kinds of single component in fat liquors,the penetribility of 4 kinds of sulfonated fat liquoring agents STO,SEO,SHO,SS-1 in the chrome-tanned leather,and the physical-mechanical properties of chrome-tanned leather after fat liquoringwere studied.

以6种常用加脂剂单一组分为参比，研究了四种磺化油加脂剂STO、SEO、SHO、SS-1在铬鞣革中的渗透情况及其加脂后坯革的物理-机械性能。

The results show that a certain degree of increase of SiC content was helpful for nitrification of TiSi2, and SiC particles were nitrified during the SHS p.

结果表明：SiC在一定范围内增加有利于TiSi2的氮化，且含40%SiC和50％SiC的压坯在燃烧合成过程中发生了SiC的氮化反应。

The results show that a certain degree of increase of SiC content was helpful for nitrification of TiSi2, and SiC particles were nitrified during the SHS process in the samples of green compacts with 40% SiC and 50% SiC diluent.

结果表明：SiC在一定范围内增加有利于TiSi2的氮化，且含40％SiC和50％SIC的压坯在燃烧合成过程中发生了SiC的氮化反应。

The TiSi2 reactants in the green compacts with 50% porosity were fully nitrified and the final products were composed of Si3N4, SiC and TiN.

压坯孔隙率为50％时，反应物TiSi2氮化充分，最终产物为Si3N4-SiC-TiN。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。