均匀粒状的

Homegeneous fine granulate of the product can be rest assured by tile instananeous drying process.

这里由于在瞬间完成干燥。产品能保持均匀的细小粒状。

Physicochemical properties of CPC/BMP compositeUnder scanning electron microscope the CPC/BMP composite was found to consist primarily of platy crystals, granular crystals and some small rod-like crystals with micropores about 5-50 urn in size.

一、CPC/BMP复合人工骨的理化特性通过扫描电镜可见CPC/BMP复合物由不规则的扁平状、颗粒状和棒状晶体构成，晶体颗粒互相连接附着，之间充满均匀而又不规则的孔隙，大小约为10～50μm。

In addition, there are bond areas between the new and the primary coverage because of the growing up of the plating coat, which may lead to the emergence of micro crack on the coating owing to such causes as too big or uneven impact during plating process, little distortion of global granular zinc dust inside the plating coat, less tight coalescence of the zinc dust flecks.

由于形成镀层的过程处在酸性环境，在镀层增厚过程中不可避免把酸性溶液包裹在镀层里面，酸性溶液会与金属基体和镀层反应，产生氢气，必然会寻找通道选出，形成微气孔；镀层是逐渐形成的，新生镀层与原有镀层之间存在结合面；镀覆过程由于撞击力过大或者不均匀，镀层内部球形颗粒状锌粉变形较小，球形颗粒与球形颗粒的结合不严密等，这些原因会导致镀层产生微裂纹。

After the alloy being HIPped and annealed, themicrostructure of Ti-45Al-7Nb-0·15B-0·4W alloy is primaryγphase and lamella, and the needle-like and granularβphase precipitates.

经过热等静压和均匀化处理后Ti-45Al-7Nb-0·15B-0·4W合金的基本形貌为初生γ相+层片状晶团，有β相析出，其形貌为针状、点状、颗粒状。

The HUVECs retained spindled shaped or cobblestone appearance and positively stained by anti-CD31. DAPI staining showed that 90％of scaffolds surface was reendothelialized and endothelial cells were distributed evently on the surface forming a confluent monolayer.

脱细胞支架细胞成分完全脱去，胞外基质保存完好；分离的细胞培养一周后，细胞呈梭形或多角形，核仁清晰，大小均匀，呈典型的铺路石样；免疫荧光检测可见细胞胞浆内有颗粒状红色阳性信号，说明Ⅷ因子相关抗原染色阳性；膜表面有蓝色阳性信号，说明CD31抗原染色阳性。

Phase identification and microstructure observation of the composites were performed by X-ray diffraction, Electron Probe Microanalyses and transmission electron microscopy. The results show that ZrB2 phase is equiaxed or near equiaxed, which is hexangular and less 1μm in size. ZrAl3 phase is long strip-shaped. The in-situ reinforcements are distributed uniformly in the matrix and the interface is clean,without any other chemical products.

借助于X射线衍射仪、电子探针和透射电镜对复合材料的物像和增强相进行了观察，结果表明ZrB2颗粒呈等轴或等轴颗粒状，为六方结构，尺寸大部分小于1μm，ZrAl3相大部分呈长条状，两种增强相整体分布较为均匀，且与Al的界面光滑洁净，没有其它界面生成物。

Taking particulate material as an example, the effect of micro-homogeneity of the material on the sampling error was investigated. The variation of the analyte contents with the grain sizes, and the possibility of stratifying the population by the grain sizes were studied.

以粒状物质为例研究了物质微观均匀度及其对取样误差的影响，探讨了被测组分含量随颗粒粒度的变化规律，研究了按粒度对物质进行分层及分层取样的可行性。

By calcining β-FeOOH with NP-4 in the molar ratio of 5, or calcining gelatin of broken emulsion, the dispersed symmetrical square γ-Fe2O3 with enhanced magnetism was observed.

结果得出，对n=5或破乳所得凝胶煅烧，所得样品皆为分散均匀的四方形颗粒状，且为磁性明显增强的纳米氧化铁γ-Fe2O3。

The results indicated that methyl cellulose (MC20) was a suitable surfactant to control the particle morphology of atorvastatin calcium.

研究结果表明：表面活性剂甲基纤维素(MC20)可以有效地控制颗粒形貌；改变溶液浓度及体系温度可以调整颗粒大小；混悬液经喷雾干燥得到的干粉是粒度分布均匀的团粒状类球形颗粒，粒径约为1μm。

Based on the work presented in paper , a new homogenisation method for the analysis of assemblage of elastic contact bodies is proposed in this paper.

基于文献 [1]的工作，给出弹性接触颗粒状组成周期性结构材料宏观力学均匀化分析新方法。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。