在操作中
- 与 在操作中 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Results:Two patients(8.69 %) disagreed with the charge of the treatment and then agreed it after the nurse particularly explained;one patient(4.35%) was discontended with the exsuction of the saliva ;one doctor(4.35%) was discontended with the time control of the selfcuring acrylic resin in once treatment ;two doctors(100 %) and 23(100 %) patients was contended with the result of the treatment.
结果 2例患者(8.69 %)对费用表示异议,进一步为其解释清楚后满意,1例患者(4.35%)对治疗过程中护士的吸唾情况不满意,1位医生对1次配合(4.35%)时自凝塑料的调拌不满意。2位医生(100 %)和23 例患者(100 %)对修复效果满意。结论在口腔临床操作过程中,护士应不断掌握新技术的操作特点,新材料的使用方法。
-
First, for the reduction of the solving scale of the scheduling problem, on the basis of the defined scheduling characteristics—resource conflicting probability, all operations of the scheduling problem are divided dynamically into two kinds in the scheduling process: the first kind of operations with greater probability of the resource conflict, and the second kind of operations with less probability of the resource conflict.
首先,在遗传算法迭代求解过程中,为降低调度问题的求解规模,基于所定义的调度特征量——资源冲突可能性,将所有操作动态划分为资源冲突可能性较高的操作和资源冲突可能性较低的操作,分别直接和间接参与染色体编码。
-
Explain why we used prefix in one and postfix in the other.
解释为什么一段程序中使用前自减操作而在另一段程序中使用后自减操作。
-
C Supports both Firmware Hub and LPC Memory Read and Write Cycles Auto-detection of FWH and LPC Memory Cycles C Can Be Used as FWH for Intel 8xx, E7xxx, and E8xxx Series Chipsets C Can Be Used as LPC Flash for Non-Intel Chipsets Flexible, Optimized Sectoring for BIOS Applications C 16-Kbyte Top Boot Sector, Two 8-Kbyte Sectors, One 32-Kbyte Sector, Three 64-Kbyte Sectors C Or Memory Array Can Be Divided Into Four Uniform 64-Kbyte Sectors for Erasing Two Configurable Interfaces C FWH/LPC Interface for In-System Operation C Address/Address Multiplexed Interface for Programming during Manufacturing FWH/LPC Interface C Operates with the 33 MHz PCI Bus Clock C 5-signal Communication Interface Supporting Byte Reads and Writes C Two Hardware Write Protect Pins: TBL for Top Boot Sector and WP for All Other Sectors C Five General-purpose Input Pins for System Design Flexibility C Identification Pins for Multiple Device Selection C Sector Locking Registers for Individual Sector Read and Write Protection A/A Mux Interface C 11-pin Multiplexed Address and 8-pin Data Interface C Facilitates Fast In-System or Out-of-System Programming Single Voltage Operation C 3.0V to 3.6V Supply Voltage for Read and Write Operations Industry-Standard Package Options C 32-lead PLCC C 40-lead TSOP
0第0页,本页显示记录0-0,共0条记录分0页显示C支持两种固件中心和LPC内存读取和写入周期自动的FWH和LPC的记忆圈C检测可以用于英特尔8xx系列,E7xxx,E8xxx系列芯片组和C可以用作FWH与至于非英特尔芯片组的BIOS应用柔性优化扇区开放16字节热门引导扇区,两个8 - Kbyte的,一个32字节部门,3个64 - Kbyte的C或存储阵列,线性预测编码闪光可分为四个统一为两个可配置的接口擦除的FWH / LPC接口为64 - Kbyte的行业,系统运行C地址/地址多路复用在制造过程中用于编程接口的FWH /线性预测编码界面C与33 MHz的PCI总线时钟 5信号通信接口进行操作,支持字节读取和写入引导扇区的顶部和WP C两硬件写保护引脚:任务型为所有其他部门 5个通用输入的系统设计的灵活性识别的多种设备选型部门登记销锁定为个别部门读取和写保护的A /阿复用界面C 11引脚复用引脚地址和8引脚的数据界面C促进快速系统内或外的系统编程的单电压3.0V至3.6V的操作供应的读取和写入操作业界标准的封装选项电压 32 -引脚PLCC 40引脚的TSOP
-
Along with selecting and transforming, extruding is one of the most common actions when modeling in 3D.
挤压操作和选中以及移动操作的结合,是在所有3D建模中最常用的操作。
-
After getting two systems'GLE, absorption experiment was operated in laboratorytype equipment and the operation condition of dibutyl sebacate as absorbent were studied, the relationship of 〓 and the content of maleic anhydride in gaseous mixtures, the temperature of gaseous mixture, the liquid and gases ratio, the temperature of absorbent and the content of maleic anhydride in absorbent were studied respectively.
在获得气液平衡关系后,在自行设计的小型实验设备上分别就癸二酸二丁酯吸收顺酐的操作条件:进塔气中顺酐含量的变化、进塔气体温度的变化、液气比的变化、进塔溶剂温度的变化和吸收剂中顺酐含量的变化等对吸收效率的影响进行了初步探讨,推荐了合适的操作条件。
-
These systems are inherited from an era predating the exponential growth of the Internet and were never envisioned as being scaleable to today's required levels.
创建完成后, Postmark 对文件池进行一系列的事务操作,根据从实际应用中统计的结果,设定每一个事务包括一次创建或删除操作和一次读或添加操作,在有些情况下
-
Then the intellectual control technology of vacuum circuit breaker is discussed particularly. As a control object, the bi-stable permanent magnetic actuator is separated into basic principle so as to determine the nature of the whole. The direct-coupled models of magnetic fields for analysis and for calculation are presented. The static and dynamic characteristics of the models and dynamic behavior analysis and matching analysis for the vacuum circuit breaker with bi-stable permanent magnetic actuator are also discussed. For a further study, fuzzy neural network control technology based on synchronized-closing operation of vacuum circuit breaker is analyzed and the research conclusion is used for realizing the synchronized-closing of vacuum circuit breaker in the future.
论文首先分析了永磁机构的结构和工作原理;然后主要针对双稳态永磁机构真空断路器分析了在开断和关合过程中的静态磁场耦合模型、动态分析数学模型和真空断路器的动态特性,并就永磁机构和真空断路器的匹配进行了分析;最后分析了基于双稳态永磁机构真空断路器的同步操作问题,深入研究了同步操作的模糊控制原理和算法,研究结果为最终实现永磁机构真空断路器的同步操作奠定了基础。
-
Electronic map of MapInfo is introduced into the environment of object oriented by the use of Map X 4.0 module. The operations such as dynamic add, delete and edit of objects can be done real-time dynamically by operators in the environment of object oriented on the present diagram of polder region. At the same time, the spatial-data and attribute-data of irrigation district are managed separately. The spatial-data is used by the file system, whereas, the attribute-data exist in the relevent database. The figures and database are related through the only ID number in order to realize two-way inquiry, so that, the polder region river system planning data are collected automatically. Moreover, this system make the great use of GIS advantage in storing and annalising data to automatically organize files needed in river network calculation , adopt one-dimensional unsteady flow model , so as to lay out height of river levee .
把GIS技术引入水系规划,通过MapX4.0组件把MapInfo电子地图调入面向对象编程环境,使操作人员能在面向对象环境中对圩区现状图进行实时动态操作,包括对操作对象的动态添加、动态删除、编辑等;同时,将空间数据和属性数据分开进行管理,空间数据用文件系统管理,属性数据采用数据库管理,通过建立唯一ID号进行数据联接,将图形与数据库进行关联,实现属性到图形或图形到属性的双向查询,从而实现了圩区水系规划部分数据的自动采集;另外,本系统充分利用GIS存储与分析数据的功能,自动生成河网水力计算所需的文件,采用一维非恒定流模型进行河网水力计算,为确定沟道堤顶高程提供依据。
-
The operation staff should test all the running parts, connection, fixed parts, track and wire rope, etc. everyday before operate the machine, then vacancy load for 3 times to confirm reliable. When using it ,pay attention to the conditions of hoisting machine, sliding wheel, wire rope, hang coop. Make
6.5操作人员应在每天操作前检查各运行部分,各连接,固定部位、轨道及钢丝绳,无异常情况,然后,操作运行空载上下三次,确认安全可靠后,方可使用,使用中要随时注意卷扬机记录,下班时检查各部件,并清扫吊笼内灰渣,锁好护栏门,将总电源关闭
- 推荐网络例句
-
She gently rebuff ed him, but agreed that they could be friends
她婉言拒绝了,但同意作为朋友相处。
-
If in the penal farm, you were sure to be criticized.
要是在劳改农场,你等着挨绳子吧!
-
Several theories about reigniting and extinguishing of the arc have been refered.
本文综合考虑了几种电弧重燃和熄灭理论。