在增加

The content of anhydrite and calcite is lower. The content of anhydrite will increase with the addition of flux CA while the content of calcite will decrease.

煤中添加助熔剂CA后，煤灰中硬石膏含量增加，并且随着助熔剂CA量的不断增加，方解石含量在不断减少，硬石膏含量在不断增加。

With the increasing of the concentration of alkali, the content of insolubility of the product reduces initially but increases later, the DS of product increases initially then reduces later. The product has good solubility and high DS at 10% content of alkali. The insoluble product reduces at initially and then keeps stability later with the time of basification extending. With the increasing of the content of water in system, theinsolubility of the product reduces initially and then increases later.

随着碱浓度的增加，产物中水不溶物含量先降低后增加，取代度先上升后下降，在10％时，水溶性最好，取代度最高；延长碱化时间，产物中水不溶物含量下降，之后趋于稳定；提高反应体系中水的含量，产物中水不溶物含量先降低后增加，在7％时，水溶性最好，延长分散时间，产物中水不溶物含量下降，取代度提高；醚化剂以少量多次的方式滴加，产物水溶性好。

After comparison of 30 and 50℃ treatments, AQDS were added into 3 kinds of microorganism biocoenosis from Jiling, Tianjin and Sichuan paddy soil, and it showed that AQDS could accelerate the reduction of Fe 10%-288%, meanwhile, temperature could accelerate the reduction of Fe 6%-17%. In axenic culture treatment of 6 kinds of bacterial strains from Sichuan and Jiangxi paddy soil, the maximum accumulation amount of Fe reduction rate was constant, the maximum reaction rate and ferric reduction rate of ferric strain JX-a08 all increased as temperature rose, which showed that bacterial strain JX-a08 were suitable to 50℃.

在30和50℃培养温度下，来源于吉林、天津和四川的3种水稻土微生物群落添加AQDS可使Fe还原的反应速率常数增加10%~288%，而温度变化的增加幅度仅为6%~17%；对分离自四川和江西水稻土中的6株铁还原菌的纯培养试验发现，菌株JX-a08的Fe最大累积量、还原速率常数、最大反应速率及铁还原率均随培养温度的升高明显增加，表明菌株JX-a08更适于在50℃下生长。

The results showed that plastic deformation at both -70℃ and 180℃ made the dislocation density of AISI304 stainless steel increase with the increase of deformation. Martensite phase transformation was induced for deformation at -70℃, whereas it was not at 180℃. As the dislocation density increased, the breakdown potential of AISI304 stainless steel's passive film became a little more positive. As martensite phase content increased, it became more negative and pitting corrosion resistance decreased.

结果表明：加热180℃和低温-70℃条件下塑性变形均使AISI304不锈钢中位错密度随变形量增大而增加，AISI304不锈钢在-70℃条件下塑性变形时部分奥氏体相转变为马氏体相，而在180℃条件下塑性变形时不发生马氏体相变；位错密度的增加使AISI304不锈钢钝化膜的击穿电位略微正移，而马氏体相的增加使击穿电位呈负移趋势，材料耐孔蚀性能降低。

Methods of measuring the input components, their prices and output elements are given. We put forward some new methods in measuring components, including composite depreciation rate, equality working hours, and proxy of input resources. Using the mature methods of efficiency measurement and decomposition available, we make a detailed investigation into 4 listing companies of oil industry with a span of 12 periods. Basic conclusions we draw include: labor inputs affects oil field output mostly in China; China oil fields operates in a low technical efficiency level average of 0.61; Increasing difficulties with expanding output has the greatest influence on cost; Cost efficiency of China oil fields averages at 1.47; Total factor productivity of China oil fields averages at 10%, accounting for 79% of the total output growth rate of 12.6%; Frontier technology progress contributes the most to TFP of China oil fields with 17 percentage points.

本文沿用了已有文献中关于效率计量与分解的成熟方法，对我国三家油田上市公司与一家上市石油公司12个时期的技术效率与成本效率进行了详细的计量、分解与分析，得到的基本结论有：劳动力投入是影响我国油田上市公司产出的最重要的影响因素；油田的平均技术效率仅为0.61；产出项是影响成本的显著因素，这说明随着产出增加而出现的开采难度增加是导致开采成本增加的重要因素；油田的平均成本效率为1.47；全要素生产率的增长平均在10％左右，占到了产出平均增长率12.6％的79％，表明我国油田的生产率的提高主要是依靠全要素生产率的提高而实现的，只有21％左右的产出增长是依靠要素投入而实现的；前沿技术进步是油田全要素生产率增长的主要源泉，在2001～2004年期间，前沿技术进步对油田生产率的贡献高达17个百分点。

The blend has following properties with 10 parts compatibilizer. The tensile intensity and elongation at break reach 35.66MPa and 23.58%, respectively, improving by 26.6% and 65.7% respectively compared with 0 part compatibilizer; The characteristic absorption peak of carbonyl at 1725～1800cm-1 disappear and the characteristic absorption peak of hydroxide at 3438～3440cm-1 increase induce the formation of hydrogen bond; The decalescence peak of blend increase by 2℃compared with the blend containing 0 part compatibilizer near 100℃; Lignin can be dispersed homogeneously to avoid reuniting of lignin particle.

2当共混材料中增容剂含量为10份时，共混材料表现出如下特性：拉伸强度和断裂伸长率分别达到35.66MPa及23.58%，较未加增容剂分别提高了26.6%和65.7%；从1725～1800cm-1范围内羰基特征吸收峰接近消失以及3438～3440cm-1范围内的羟基波数的增加暗示了共混材料中氢键缔合的发生；共混物在100℃附近的吸热峰较未加增容剂时降低了近2℃，相容性得到了提高；木质素在基体中进一步分散，结晶度增加，从而阻止木质素的团聚，增加了两相的相容性。

Normal muscle showed accumulation of glycolytic and oxidatie metabolism capacity with increased age, but this accumulation failed in DMD.

正常肌肉显示随着年龄增加糖酵解和氧化代谢能力逐渐增加，而在DMD病人中TGF-beta 通路明显诱导强化，并且在DMD肌纤维中尚可发现TGFbeta II型受体和凋亡信号调节酶1表达增加。

It showed that the halophile of Kenyu7 were better than Wuming-5;(2)the contents of proline of the two Zea mays varieties increased significantly,and under high NaCl stress(150mmol/L NaCl or above) the increasing amount of the contents of proline of Kenyu7 was higher than Wuming-5 ,so it showed that the injuries of Wuming-5 imposed by NaCl stress was greater than Kenyu7;(3)the activities of CAT of the two varieties were no obviously changed,while the activities of CAT of Wuming-5 were all higher than Kenyu7 under all concentrations of NaCl solution,which hadn't showed the correlation between the activity of CAT and salinity tolerance.

结果表明，随NaCl溶液浓度的增加：（1）两品种玉米生长均受到严重抑制，发芽势降低，芽和根的长度均呈减小的趋势，总体来看，杂交种垦玉7的发芽势、芽和根的长势均好于自交系无名-5；（2）两品种玉米体内Pro含量均增加，且在NaCl浓度超过150mmol/L时，杂交种垦玉7体内Pro含量增加的幅度明显大于自交系无名-5，而使垦玉7对盐的适应能力强于无名-5；（3）两品种的CAT活性变化幅度均不大，但无名-5的CAT活性在各NaCl浓度条件下均高于垦玉7，这可能是由品种间本身差异造成的，而与品种的耐盐性无直接关系。

Under the conditions of keeping other design parameters constant, design thickness of valve flap increases with the mass increment on single wheel spring of the vehicle; throttle gap of oil-air spring is in linear decrement relationship with mass on single wheel spring. For each mass increment of 100kg on tested single wheel spring, design thickness of throttle valve flap will increase by 0.007mm and the throttle gap will decrease by 0.001mm.

在其它设计参数保持不变的情况下，阀片设计厚度随车辆单轮簧上质量的增加而增加；油气弹簧节流缝隙与单轮簧上质量成线性递减关系；试验的单轮簧上质量每增加100kg则节流阀片设计厚度将增加0.007mm，节流缝隙将减小0.001mm。

Since 1958, cutting and felling of bamboo and trees by villages and other cooperative organizations under villages have been included in forestry; value of barnyard manure has been excluded from animal husbandry; self-consumed handicrafts has been excluded from sideline occupations, while the output value of industries run by villages and cooperative organizations under village had been included in sideline occupations and the output value of fish catches by motor fishing boats has been added to fishery.

1957年以前的农业总产值中包括了厩肥和农民自给性手工业（如农民自制衣服、鞋、袜，自己从事粮食初步加工等）。1958年及以后的农业总产值，林业中增加了村及村以下竹木采伐产值；牧业中取消了厩肥产值；副业中取消了农民自给性手工业产值，增加了村及村以下办的工业产值；渔业中增加了海洋捕捞水产品产值。1980年及以后的农业总产值，在副业中增加了农民家庭兼营工业商品部分的产值。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。