因数

With the combination of lighting, cooling and heating under daylighting, the study on the effect of the key characteristic parameters on total energy consumption is provided. The validation of the comparability of daylight distribution for building antetype and model is made through theoretical analysis and simulating calculation in the thesis. Due to the variable sky condition, daylighting factor is used for experimental validation instead of illuminance. The error analysis of several testing methods used in the experiment is conducted, followed by the experimental validation of the effect of WWR, sill and transmittance on daylighting factor distribution.

基于天空状态的多变性，提出用天然采光因数替代照度进行实验验证，对实验中的几种测试方法进行了误差分析，并通过实验验证了窗墙比、窗台高和透光率对天然采光因数分布的影响。4 为了更直观地分析各参数对照明节电的影响，提出了"特征点"、"特征线"和"特征距离"等概念；分析了天然采光下的照明节能状况，综合考虑照明、采暖和空调能耗，计算分析了几个主要特性参数对总能耗的影响。

Then, it used fiber friction coefficient analyzer to measure wool antidromic and direct friction coefficient.

同时，利用纤维摩擦因数测定仪测定羊毛纤维的顺逆摩擦因数，以确定改性后羊毛鳞片的去除情况。

Through shrinkage,the lipid containment and the cuticle's shape changes,the results showed that this kind of Azotobacter vinelandi enzyme can efficiently enhance the anti-shrinkage function of wool.

其外表面角质层的鳞片依次叠盖，造成纤维表面逆鳞片方向的摩擦因数大于顺鳞片方向的摩擦因数而产生定向摩擦效应[1]，使羊毛发生毡缩现象。

Shortfin mako sharks are known to feed on adult Cobia and have been seen by fishermen following Cobia during their annual springtime migration in the northern Gulf of Mexico.

滑一些鲨鱼已知成人因数为主食，并已见过的渔民后在北部墨西哥湾他们每年春季迁移过程中的因数。

Typically service brakes are concerned with dynamic coefficient of friction, or the coefficient of friction measured while the vehicle is moving.

典型工作条件下的刹车与动摩擦因数，即当车辆行驶时测出的摩擦因数有关。

Quality factor control technique can control the force sensitivity and imaging resolution by precise adjustment of the microcantilever's quality factor.

在分析品质因数调控技术机理的基础上，分别在一般轻敲模式下和有品质因数调控电路支持的轻敲模式下，利用琼脂糖凝胶作为样品，测得力曲线。

Based on the working principle of the pendulous accelerometer,this article firstly analyzes how the change of temperature influences the scale factor,and then,we set forth the compensation theory and method of the temperature coefficient of the scale factor.

本文根据悬丝支撑的摆式加速度计工作原理，分析了温度变化对标度因数的影响，同时给出了标度因数温度系数的补偿原理和方法，并通过试验进行了验证。

Chapter 3 gives the theoretical analyses to Q-factor of electromagetic open resonator due to the mirror loss、mirror diffraction loss、coupling aperture loss and inserted dielectric specimen loss in detail by means of the incremental frequency rule and the small aperture coupling theory, and obtains the more precise formulae for calculating Q-factor.

在第三章利用电磁开腔的复数源点理论以及频率增量法和小孔耦合理论，分别对电磁开腔镜面反射损耗、镜面衍射损耗、耦合孔损耗以及介质样品损耗引起的品质因数进行了深入的理论分析，得到了电磁开腔品质因数更为精确的计算公式。

Finally, we simulate the relationship of the residuary intensity modulation coefficient and the scale factor stability of fiber-optic gyro by using the Matlab simulation tool.

最后，对所得出的残余强度调制系数与光纤陀螺标度因数稳定性的关系进行了Matlab 仿真，通过仿真结果，更进一步说明残余强度调制对数字闭环光纤陀螺标度因数稳定性的影响。

The results show that in the applied load range of 10250 N, the mass loss rate of coated AZ91D alloy can be identified to three stages, which are related with whether the coating is worn out. Abrasion is the main mechanism for the coated alloy. The friction coefficient of the coated alloy during sliding wear appears oscillation before it reaches a constant value, which is close to the μ value of the matrix alloy. The mass loss rate of coated alloy increases slightly with increasing applied load when the applied load is more than 150 N because of high plastic deformation accommodation on the matrix alloy surface.

结果表明：根据载荷大小，涂层处理后AZ91D镁合金的磨损行为明显分为3个阶段，这些阶段同陶瓷层是否磨穿密切相关；微弧氧化涂层AZ91D镁合金的磨损机理主要是磨粒磨损；受表面状况的影响，陶瓷涂层的摩擦因数在 0.20~0.45 间波动；在较高载荷下，涂层被磨穿后，涂层的摩擦因数趋于基体合金的摩擦因数，涂层合金的表面变形能力提高，该阶段质量磨损速率随载荷增加，趋势变得缓慢。

The labia have now been sutured together almost completely.The drains and the Foley catheter come out at the top.

此刻阴唇已经几乎完全的缝在一起了，排除多余淤血体液的管子和Foley导管从顶端冒出来。

To get the business done, I suggest we split the difference in price.

为了做成这笔生意，我建议我们在价格上大家各让一半。