回转曲面

Profile modeling ; Curve ; Curved surface ; Motion orbit ; Outside curve

因此，有必要对靠模曲线与曲面轮廓线之间关系做以探讨。以仿形车削回转球面为例，讨

The method is :there are two perpendicular axes whose distance are controlled ,one is the axis of work table, the other is fixed with a microscope for aiming.

该测量方法是：两个相互垂直且间距可调的数控回转轴，一轴与工件的回转中心重合，另一轴上固定可移动的瞄准显微镜，当显微镜瞄准被测孔时，两轴的转角由各自的圆光栅测出，两轴之间的角度位置确定曲面壳体零件上小孔的孔位置，同时采用CCD摄像头，利用图象处理技术实现小孔的尺寸测量。

Some studies based on machining complex ruled surface by means of WEDM and machining spherical parts through WEDM with rotary electrode are carried out to check the correctness of picture simulating results.

为了检验图形仿真结果的正确性，本文对各种复杂曲面电火花线切割加工系统加工复杂直纹曲面零件和回转电极展成电火花加工球面零件的过程进行了实验研究。

By study the method of approximate development of surface of revolution,the mathematiccal model of approximate development,precision analysis and error correction has been gained.

通过对不可展回转曲面近似展开方法的研究，得到了回转曲面近似展开、精度分析和误差矫正的数学模型。

The method proposed in this paper can be referred when measuring area, nicks, abrasion and rust on curved surface.

文章所提出的方法对于利用图像测量回转曲面物体的面积以及划伤、磨损、锈蚀等具有重要的参考价值。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。