回动器

The position of executer unit in case of the contact rapidly backing to normal position to action contact position.

触点从动作接触位置迅速跳回正常位置时，操动器的位置。

The effect of Reynolds number on rudder hydrodynamic performance is also analyzed. Up to the stall angle the computed lift and drag agree well with measurements and other author's calculations, whereas stall angle, lift and drag beyond the stall angle are slightly under-predicted. The solver is used to investigate laminar and turbulent separated flows around a 6: 1 prolate spheroid at high incidence angles and their effects on hydrodynamic forces. The second separation flows are successfully identified in both laminar and turbulent flow simulations.

应用所开发的求解器，以6：1长椭球体为算例计算了回转体在大攻角下定常斜航运动时的三维粘性流场及水动力，对层流流动和湍流流动分别进行了计算，分析了层流与湍流分离流动和涡旋产生的特点及其对水动力的影响；计算结果与他人的试验和计算数据比较，吻合程度良好，表明应用本求解器能够正确模拟这种以层流／湍流分离流为主的复杂粘性流动，得到相当精确的水动力，检验和验证了该求解器精确模拟回转体在大攻角下的粘性分离流动和计算水动力的能力。

The solver is used to investigate laminar and turbulent separated flows around a 6:1 prolate spheroid at high incidence angles and their effects on hydrodynamic forces. The second separation flows are successfully identified in both laminar and turbulent flow simulations. The computations are shown to agree well with available experimental and numerical data and the physics of 3D large-scale flow separations and vortex shedding are confirmed.

应用所开发的求解器，以6：1长椭球体为算例计算了回转体在大攻角下定常斜航运动时的三维粘性流场及水动力，对层流流动和湍流流动分别进行了计算，分析了层流与湍流分离流动和涡旋产生的特点及其对水动力的影响；计算结果与他人的试验和计算数据比较，吻合程度良好，表明应用本求解器能够正确模拟这种以层流/湍流分离流为主的复杂粘性流动，得到相当精确的水动力，检验和验证了该求解器精确模拟回转体在大攻角下的粘性分离流动和计算水动力的能力。

In this paper ,to overcome the shortcomings in 3MK133 Groove Grinder's hybrid spindle system that the shallow slots of the throttler are easy to be blocked and difficult to be disassembled to clean,we use the throttler which is put on the big-side surface of the conical bearing to replace the traditional throttler, change gap throttling to capillary throttling, and adjust the taper of the conical bearing , oil return way , seals and sealed mode.

针对 3MK133沟道磨床动静压主轴系统中，节流器浅沟容易堵塞及拆卸清洗不便等缺陷，提出采用端置式节流器替代原有的内置式浅沟节流器，变间隙节流为毛细管节流，并相应调整了主轴系统中圆锥轴承的锥度、回油通路、密封装置及密封方式。

Recently,with the higher requirement for isolation control specifications and introduction of novel actuators,researchers have already recognized the difficulty and challenge of the problems resulting from dynamic and nonlinear characteristic of actuators when design and synthetize the controller.Among nonlinearities,hysteresis is the most mathematically intractable one.

近年来，随着隔振控制要求的提高以及新型作动器的出现，作动器动态特性及非线性问题给控制器设计与综合所带来的困难与挑战已开始被国内外学者所重视，其中滞回非线性是最为棘手的一类非线性。

When the timer in the back goesoff, your mouth will be permanently ripped open. Think of it like a reverse bear trap.

当后面的计时器到点后，你的嘴就会永久性撕开，就象一个回动式捕熊器。

When the timer at the back goes off...your mouth will be permanently ripped open.Think of it like a reverse bear trap.

当后面的计时器到点后，你的嘴就会永久性撕开，就象一个回动式捕熊器。

When the timer at the back goes off...your mouth will be permanently ripped open.Think of it like a reverse bear trap.

当后面的计时器到点后，你的嘴就会永久性撕开，就像一个回动式捕熊器。

Voltage Source and Current Source, Thevenin Theory, Trouble Shooting, Characteristic Curve of Diode, Diode Models, Rectifier Circuits, Input Filtering Capacitor, Voltage Multiplier Circuits, Limiter and Clipper Circuits, DC Clampers and Peak-to-peak Detectors, Zener Diode, Zener Diode Rectifier, Photoelectric Devices, Collector-Emitter Junction, Transistor Characteristics of common-emitter, Base Bias, LED Dirver, Establishing a Stable Q-point, PNP Transistor Biasing, Transistor Biasing, Coupling and By-Pass Capacitors, AC Emitter Resistance, Common-Emitter Amplifier, Other Common-Emitter Amplifiers, Cascaded Common-Emitter Amplifiers, AC Load Line, Emitter Follower, Class B Push-pull Amplifiers, JFET Characteristic Curve, JFET Biasing, JFET Amplifier, VMOS Circuit, Differential Amplifier, Operational Amplifier, Non-inverting Feedback, Negative Feedback.

电子学实验( S0704)(1，1)/应用电子学实验( S0472)(1，1)电压源和电流源、戴维宁定理、故障排除、二极体特性曲线、二极体近似模型、整流电路、电容-输入型滤波器、倍压电路、限制器电路和峰值检测电路、直流定位器与峰对峰检测器、齐纳二极体、齐纳二极体整流器、光电元件、集射极接面、集极特性曲线、基极偏压、LED驱动器、建立一个稳定的工作点 Q 、 PNP 电晶体偏压、电晶体偏压、耦合及旁路电容、交流射极电阻、共射极放大器、其他 CE 放大器、串接共射极放大器、交流负载线、射极随耦器、 B 类推挽式放大器、 JFET 特性曲线、 JFET 偏压、 JFET 放大器、 VMOS 电路、差动放大器、运算放大器、非反向电压回授、负回授。

The basic concept of FOP can be summarized as to further optimize effective prescription according to the standard of curative effects and with the aid of modern science and technology and theories of traditional Chinese medicine.

其基本内涵可概括为：以确有疗效的中药复方为研究对象，以现代科学技术和传统中医药理论为技术支持，以该复方所治病证的药效响应为评价标准，以优化重组疗效更优的新复方为研究目的。

Ever since our world has been a world, native forests have been indiscriminately exploited by man.

自从我们的世界一直是世界原生森林被任意剥削人。