回动

Charging handle is located on the back of the weapon, is fully ambidextrous and does not move when gun is fired.

充电手柄位于回的武器，是完全灵巧和不动时，枪开火。

And then I send out a vagary suddenly , the bus deciding to sit returns to a master station, also can watch once more when going back, location sitting to depend on a window in master station, 8:00 penetrates time of north tetracylie presumedly much again.

心想，就这样走了挺遗憾的，我突发奇想，决定坐车回总站，回去的时候也能看到一次，然后在总站坐个靠窗户的位置，大概8：00多再穿回北四环，于是我做419到了总站，在那里突然发现另一路628也能绕行，就做了这个，还真是不错，628到了健翔桥大概8点，然后开始堵车，四环全是车人，主路车也开不动，车里的人全下来了，还有从辅路跳过护栏的人，这样，我可以在车里挺清楚的看见鸟巢，而且最好的是，在鸟巢正下方的时候赶上了一次放花哈哈

The effect of Reynolds number on rudder hydrodynamic performance is also analyzed. Up to the stall angle the computed lift and drag agree well with measurements and other author's calculations, whereas stall angle, lift and drag beyond the stall angle are slightly under-predicted. The solver is used to investigate laminar and turbulent separated flows around a 6: 1 prolate spheroid at high incidence angles and their effects on hydrodynamic forces. The second separation flows are successfully identified in both laminar and turbulent flow simulations.

应用所开发的求解器，以6：1长椭球体为算例计算了回转体在大攻角下定常斜航运动时的三维粘性流场及水动力，对层流流动和湍流流动分别进行了计算，分析了层流与湍流分离流动和涡旋产生的特点及其对水动力的影响；计算结果与他人的试验和计算数据比较，吻合程度良好，表明应用本求解器能够正确模拟这种以层流／湍流分离流为主的复杂粘性流动，得到相当精确的水动力，检验和验证了该求解器精确模拟回转体在大攻角下的粘性分离流动和计算水动力的能力。

The solver is used to investigate laminar and turbulent separated flows around a 6:1 prolate spheroid at high incidence angles and their effects on hydrodynamic forces. The second separation flows are successfully identified in both laminar and turbulent flow simulations. The computations are shown to agree well with available experimental and numerical data and the physics of 3D large-scale flow separations and vortex shedding are confirmed.

应用所开发的求解器，以6：1长椭球体为算例计算了回转体在大攻角下定常斜航运动时的三维粘性流场及水动力，对层流流动和湍流流动分别进行了计算，分析了层流与湍流分离流动和涡旋产生的特点及其对水动力的影响；计算结果与他人的试验和计算数据比较，吻合程度良好，表明应用本求解器能够正确模拟这种以层流/湍流分离流为主的复杂粘性流动，得到相当精确的水动力，检验和验证了该求解器精确模拟回转体在大攻角下的粘性分离流动和计算水动力的能力。

As KKД-500 gyratory crusher has large nip angle,linear steep crushing chamber profile,different throughputs of cross sections along the chamber height,it has poor crushing performance and short liner service life.Based on the structural analysis of the original crushing chamber,in the design principle of variable nip angle,the curve equations for moving cone lining and the fixed cone lining were setup by multi-stage fitted curves.

针对KKД-500旋回破碎机大啮角、直线陡锥破碎腔型，沿破碎腔高度各个截面的通过能力不尽相同，其破碎性能差，衬板使用寿命短的情况，在分析原旋回破碎腔型结构的基础上，按照变啮角设计原则，采用多段二次拟合曲线分别建立动锥衬板和定锥衬板曲线方程，利用计算机绘制衬板曲线，确定衬板结构，并优化破碎腔型。

As kkд-500 gyratory crusher has large nip angle,linear steep crushing chamber profile,different throughputs of cross sections along the chamber height,it has poor crushing performance and short liner service life.based on the structural analysis of the original crushing chamber,in the design principle of variable nip angle,the curve equations for moving cone lining and the fixed cone lining were setup by multi-stage fitted curves.lining curves were plotted by computer,the lining structure determined,and the...

针对kkд-500旋回破碎机大啮角、直线陡锥破碎腔型，沿破碎腔高度各个截面的通过能力不尽相同，其破碎性能差，衬板使用寿命短的情况，在分析原旋回破碎腔型结构的基础上，按照变啮角设计原则，采用多段二次拟合曲线分别建立动锥衬板和定锥衬板曲线方程，利用计算机绘制衬板曲线，确定衬板结构，并优化破碎腔型。通过对铝土矿的破碎试验表明，采用新型破碎腔型，其破碎性能和破碎产能显著提高。

Recently,with the higher requirement for isolation control specifications and introduction of novel actuators,researchers have already recognized the difficulty and challenge of the problems resulting from dynamic and nonlinear characteristic of actuators when design and synthetize the controller.Among nonlinearities,hysteresis is the most mathematically intractable one.

近年来，随着隔振控制要求的提高以及新型作动器的出现，作动器动态特性及非线性问题给控制器设计与综合所带来的困难与挑战已开始被国内外学者所重视，其中滞回非线性是最为棘手的一类非线性。

The result notes that dynamic triaxial test preferably simulate the actual stress state of grading macadam, and Uzan model which considers the shear performance of material can better reflect stress states of grading macadam. Regression coefficients of the model obviously present nonlinear characteristic with moisture changed, and to further influence dynamic resilient module.More the module is larger, more diminishing rate of maximum tensile stress on pavement Bottom is smaller. To enhance draining function and strength, the gradation should been rigid controlled, and which the content of less than 0.075mm is controlled between 5～7％ and spring-back is controlled between200~300MPa are appropriate.

结果表明，动三轴试验较好地模拟了级配碎石层的实际受力状态；Uzan模型考虑了材料的剪切性能，更能反映了级配碎石在隧道路面中应力状态；随含水量的变化，Uzan模型中回归系数变化呈明显的非线性特征，进而显著影响级配碎石的动态回弹模量的变化；级配碎石模量越大，路面层底的最大拉应力减小率越小；为了兼顾到级配碎石层的排水渗透功能和强度，应严格控制级配，特别是0.075mm以下的含量宜控制在5％～7％，级配碎石的回弹模量宜控制在200～300MPa之间。

For evaluating the risk factors of bleeding in cerebral AVMs in our hospital, we reviewed the clinical histories and selective cerebral angiograms of 56 patients with intracerebral AVMs.

为了研究颅内动静脉畸形出血的危险因子，我们回朔整理56位颅内动静脉畸形出血病人的临床资料及血管摄影检查。

Voltage Source and Current Source, Thevenin Theory, Trouble Shooting, Characteristic Curve of Diode, Diode Models, Rectifier Circuits, Input Filtering Capacitor, Voltage Multiplier Circuits, Limiter and Clipper Circuits, DC Clampers and Peak-to-peak Detectors, Zener Diode, Zener Diode Rectifier, Photoelectric Devices, Collector-Emitter Junction, Transistor Characteristics of common-emitter, Base Bias, LED Dirver, Establishing a Stable Q-point, PNP Transistor Biasing, Transistor Biasing, Coupling and By-Pass Capacitors, AC Emitter Resistance, Common-Emitter Amplifier, Other Common-Emitter Amplifiers, Cascaded Common-Emitter Amplifiers, AC Load Line, Emitter Follower, Class B Push-pull Amplifiers, JFET Characteristic Curve, JFET Biasing, JFET Amplifier, VMOS Circuit, Differential Amplifier, Operational Amplifier, Non-inverting Feedback, Negative Feedback.

电子学实验( S0704)(1，1)/应用电子学实验( S0472)(1，1)电压源和电流源、戴维宁定理、故障排除、二极体特性曲线、二极体近似模型、整流电路、电容-输入型滤波器、倍压电路、限制器电路和峰值检测电路、直流定位器与峰对峰检测器、齐纳二极体、齐纳二极体整流器、光电元件、集射极接面、集极特性曲线、基极偏压、LED驱动器、建立一个稳定的工作点 Q 、 PNP 电晶体偏压、电晶体偏压、耦合及旁路电容、交流射极电阻、共射极放大器、其他 CE 放大器、串接共射极放大器、交流负载线、射极随耦器、 B 类推挽式放大器、 JFET 特性曲线、 JFET 偏压、 JFET 放大器、 VMOS 电路、差动放大器、运算放大器、非反向电压回授、负回授。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。