器

If this method failed, and that available to modify your computer's registry, the method: open the "Registry Editor" to find , then select the the right window "OldWorkAreaRects", be deleted; in the "Registry Editor" found , to choose the right window "Window_Placement", be deleted; from the "registered Table Editor ", restart the computer, and then open IE, maximize its window, and click the" Restore Down "button will restore the window, and then click" maximize "button, and finally close the IE window.

如果这方法不灵，那可得改修改您的计算机的注册表了，方法：打开"注册表编辑器"，找到，然后选中窗口右侧的"OldWorkAreaRects"，将其删除；在"注册表编辑器"中找到，选择窗口右侧的"Window_Placement"，将其删除；退出"注册表编辑器"，重启电脑，然后打开IE，将其窗口最大化，并单击"向下还原"按钮将窗口还原，接着再次单击"最大化"按钮，最后关闭IE窗口。

The gateway mainly consists of an admission controller and a request scheduler. To prevent the server from being overloaded while exhausting all resources, AC controls the forwarding rate of requests to the server. To provide proportionally differentiated system time between classes, RS schedules the requests according to three reformed latency-based scheduling algorithms including Waiting Time Priority, Mean Delay Proportional and Proportional Average Delay.

这个闸道器系统主要由许可控制机制与要求排程机制两大部分所组成，其中的许可控制机制透过控制转送要求的速度，除了可以避免网站伺服器过载，还可以尽量的有效运用网站伺服器上的资源；而要求排程机制则依据三种修改过的比例延迟演算法， WTP， MDP和PAD来进行要求排程，以提供不同等级间的整体回应时间比例差别服务。

The results show that there will be slight decrease of the control efforts when the mean absolute value or the root mean square value of the optimal control force is taken as the maximum designed control force, while the maximum control force of MR damper can be decreased by 85% compared with the maximum optimal control force. The decrease in the designed control force can not only significantly increase the capability of MR dampers, but also reduce the dimension of MR dampers for pratical application in engineering.

研究表明，当设计值取最优控制力的平均绝对值或均方根值时，MR阻尼器的最大控制力比最优控制力的最大值降低了85%，而控制效果降低不多，可以满足对结构的控制要求；降低最大控制力设计值后，不但可以充分发挥MR阻尼器的出力性能，而且可以缩小MR阻尼器的设计尺寸，便于工程应用。

Besides the inputting and outputting data, the framework can be divided into four parts: interpolator, measurer, optimizer and transformer.

除了输入和输出数据，整个框架包括四个组成部分：插值器、度量器、优化器和变换器。

The purpose of this research is to measure the different EOG (Electro-Oculography, EOG) signals resulted from eye movements. The measured voltages will be transmitted to VCO (Voltage Controled Oscilloator, VCO), and then VCO will transfer the different voltages to different frequencies of square waveform signals. The square waveform signals can replace the pulse trains generated by circle disk encoder, as the input signal of infra red sensor in the mechanical mouse.

本论文主要研究目的，乃是应用眼电图法(Electro-Oculography， EOG)来量测眼球运动所产生的电压讯号，以EOG方式量测到的电压，再经由电压控制震荡器(Voltage Controled Oscilloator，VCO)转换成不同频率的方波，VCO并将方波讯号传送给滑鼠的红外线感应器，以替代轨迹球滚动时其带动圆盘编码器所产生的脉波。

In the third part of the paper, another novel technology, named as Mould Oscillation-less Electromagnetic Continuous Casting under AMMF was proposed in order to replace the huge mechanical mould oscillation system by AMMF imposing outside the mould in continuous casting.

进行了三种波形高频调幅磁场下的无结晶器振动电磁连铸初步实验研究，实验结果表明：在方波、三角波和正弦波调幅磁场作用下的无结晶器振动电磁连铸过程中，当调制波频率略低于系统固有频率时，弯月面与结晶器壁间断接触距离最大。

The "Interceptor VG-2" is a microwave Receiver used by some police forces to detect signals radiated by the local oscillator of a radar detector, in simple terms it's a "Radar Detector Detector" VG-2 is only used in a small number of countries such as the Canada, France and Switzerland.

VG-2 反雷达拦截器，是利用微波侦测原理，侦测雷达侦测器上振荡器的辐射波，被利于抓取反雷达，又称反反雷达系统，抓谁在使用侦测器喔！

Positioner is used to control or throttle flow by modulating the air to the actuator in response to an external 4-20 milliamp, 0-5 VDC, or 0-10 VDC control signal input which is converted to a proportional 3 - 15 psi pneumatic signal used by the positioner.

当出现4~20毫安，0~5伏直流电，或0~10伏直流电控制信号输入时，将其转换成能用于定位器的3~15 psi线性气动信号后，这种定位器通过调节执行器气源流量来控制或调节阀门的流量。

Research on the behavior of theflow and heat transfer in the continuous casting mould by using mathematical mold playsan important role in the study of this field, which can offer basis in theory for control ofindustrial yield and mould design when the features of steel liquid flow and the distributionof the solidifying shell thickness are known.

用数值模拟的方法对连铸结晶器内钢液的流动和传热过程进行研究是近年来该学科发展的前沿领域，其重要目的是掌握结晶器内钢液流动的特点和凝固壳分布情况，为工业生产控制、结晶器设计提供可靠的理论依据。

The disposable loading unit may have a carrier that supports a staple cartridge therein, an anvil assembly that is movably coupled to the carrier, and an axial drive assembly that is constructed to move in a distal direction from a start position to an end position through the staple cartridge in response to a drive motion imparted to the axial drive assembly from the surgical stapling apparatus.

承载器；支撑在所述承载器中的钉仓；钉砧组件，其可活动地连接到所述承载器，以便能相对于所述钉仓在打开位置和闭合位置之间选择性地活动行进；具有远端部分的轴向驱动组件，所述远端部分被构造成响应从所

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。