喷砂处理

Normally some coarseness will happened after sandblast treated ,which help to enhance the adhesive power.

通常喷砂处理均会使金属表面产生一定程度的粗糙度，这对漆层附着力的增强有很大的帮助。

The surface treatment of fiber posts with sandblast or hydrogen peroxide significantly enhanced the bond strength of the composite resin tested.

结果证实喷砂处理和过氧化氢酸蚀处理均能提高纤维桩与树脂粘结材料的粘结强度，而硅烷化处理并不能提高纤维桩在根管内的粘结强度。

Under normal climate, the anti-rust primer should immediately applied within 4 hours after sandblast finished ,otherwise the surface with rusted immediately in few hours.

在常规气候条件下，喷砂处理完的钢铁应在4小时内立即用相应防锈底漆涂饰。暴露在空气中的洁净钢铁表面，很快会在表面形成一薄层锈蚀。

Especially developed touch-up primer on blasted areas both below and above waterline .

特别开发的底漆，通用于水线上下的喷砂处理部位。

The new smooth surface, compact oxidation steel need to be sandblast treatment. Clean the rust completely till reach the standard of GB8923 Sa 2.5, average coarseness should be Rz=40-60 um; finally removed the dirt by constringent air.

新的光滑表面、氧化皮致密的钢板，必须喷砂处理，彻底除锈达到GB8923 SA2.5级标准；平均粗糙度RZ=40~60UM；喷砂后用清洁的压缩空气将灰尘除尽。

Frosted slides are sandblasted on one end of one side.

磨砂的载玻片在一面的一端经过喷砂处理。

Double frosted slides are sandblasted on one end of both sides.

双磨砂面在双面的一端经过喷砂处理。

Double frosted slides are sandblasted on one end of both sides.

磨砂的载玻片在一面的一端经过喷砂处理

Frosted slides are sandblasted on one end of one side.

磨砂的载玻片经喷砂处理以标记标本。

Frosted slides are sandblasted for marking specimens.

磨砂的载玻片经喷砂处理以标记标本。

In the United States, chronic alcoholism and hepatitis C are the most common ones.

在美国，慢性酒精中毒，肝炎是最常见的。

If you have any questions, you can contact me anytime.

如果有任何问题，你可以随时联系我。