喷嘴
- 与 喷嘴 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
I SP* is the vacuum impulse that would be obtained by a sonic nozzle in air-breathing motor work, and thus may be ignored.
i 特*是真空的冲动将得到一音速喷嘴在吸气式发动机的工作,从而可能会被忽略。
-
All moving parts adopt oil-bath method, of which pumping position is centre-feed, easy to be maintain, short air-way, high sensitivity magnetic valves and strong-transmitting nozzles, redcue costs in large-scale.
本机主传动部件都采用油浴方式,其它加油部位采用和具有集中供油,易维修保养。缩短的气道,高灵敏度电磁阀的采用和具有强运纱的喷嘴,大大降低了织造成本。
-
The key point of designing coaxial nozzle is how to acquire the steady airstream, which can be used to control the plasma and protect the molten pool at high temperature at the same time.
同轴喷嘴设计的关键问题在于如何获得稳定均匀的同轴气流,使气流在控制等离子体的同时,又能为钛合金高温熔池提供保护。
-
As a result, low altitude operation is characterized by the appearance of a series of alternating pressure peaks and valleys along the nozzle surface.
因此,低空运作的特点是出现了一系列的交替的压力,高峰和低谷沿喷嘴表面。
-
The process then repeats itself, setting up an alternating series of high- and low-pressure zones on the nozzle wall.
然后,这一进程重演,设立一个交流的一系列高,低压力区的喷嘴墙。
-
The most cost effective are 90 or 95 percent alumina oxide nozzles, which work adequately for lower amperage applications.
最具成本效益的90或95%氧化铝喷嘴,适当降低工作电流应用。
-
Our company besides produces the above standard throttling gear, but also produces the present domestic ordinary application each kind of special throttle, like wing anemography installment, ring-like throttle type flowmeter, double repeated passage hamlet anemography installment, 1/4 round spray nozzle, segment of orifice, dual orifices, Inner Tibet orifice, fast tube Flow sensor, jack-in low damaged due to pressing flowmeter, against wall wind pressure thief and so on 30 many kinds of varieties, 1000 many kinds of specifications, caliber from DN10-3000mm, pressure from PN0.01-32MPa, temperature from negative 260℃- 550℃.
我公司除生产上述标准节流装置外,还生产目前国内普通应用的各种特殊的节流件,如机翼型测风装置、环状节流式流量计、双重文丘里测风装置、1/4圆喷嘴、圆缺孔板、双重孔板、内藏孔板、均速管流量传感器、插入式低压损流量计、防墙风压取样器等30多种品种,1000多种规格,管径从DN10-3000mm,压力从PN0.01-32MPa,温度从负260℃-正550℃。
-
Optimal pressure and flow in high pressure water generating system were selected, and aperture / slenderness ratio of nozzle was calculated.
合理选择高压水发生系统的压力和流量,计算出喷嘴的孔径与长径比。
-
After ten years'leaping development, Chang Yuan spray product Co.Ltd has become a professional factory in terms of domestic large industrial sprayer, industrial sprayer system, filters and depuration equipment appurtenance .
经过10年的发展,昌源喷雾产品有限公司已成为国内大型工业喷嘴、工业喷雾系统、过滤器和净化设备配件的专业性生产厂家。
-
As well, it was planned that different nozzle shapes would be tested.
以及,它的计划是不同的喷嘴形状将受到考验。
- 推荐网络例句
-
I will endeavour to find you some assistance.
我尽力帮你找人帮忙。
-
At first I only know bruck is the idol of American younglings, afterwards I returned back to Taiwan ,even in Beijing last year ,I saw her poster everywhere, I was so surprised at her charm.
起初我只晓得布鲁克雷德丝是美国少男少女崇拜的偶像,后来回台湾,甚至去年在北京,居然也四处看见她的海报,才惊讶她的魅力之大。
-
Ah may dee:You are chinese living in a democratic country.
你是居住在民主国家的中国人吧。