唇的

Objective To observe the effect on post-operation of cheilopalatognathus close with two different methods of analgesia.

目的探讨不同镇痛方式在小儿唇腭裂手术后应用的效果。方法择期唇腭裂手术患儿40例。

Bilabial : Sounds which are produced with both the upper lip and the lower lip involved.

双唇 ：声音的生产与上唇和下唇参与。

Open flowers with corolla longer than calyx, tube slender, 2-lipped, lower lip 3-lobed, upper lip erect and 2-lobed; stamens exserted; style longer than stamens. Cleistogamous flowers with corolla shorter than calyx; stamens and style shorter than corolla.

开阔的花具花冠长于花萼，纤细，二唇形的筒部，3浅裂的下唇，和2裂的上唇直立；雄蕊外露；花柱长于雄蕊有花冠短于花萼的Cleistogamous的花；雄蕊和花柱短于花冠。

Corolla blue-purple to pinkish white or greenish, 1.8-2.3 cm, outside pubescent to glabrescent; tube nearly cylindric, gradually slightly ampliate from base to mouth, 1.4-2 cm X 3-6 mm; limb slightly 2-lipped; adaxial lip 2-lobed from near middle, lobes 1.5-2 X 1.5-2 mm; abaxial lip lobes 3.5-5.5 X 2.5-3 mm. Stamens adnate to corolla 5-7 mm above base, 6-13 mm; filaments slender, slightly flattened, glabrous; anthers oblong, 2-loculed, dehiscing longitudinally, connective glabrous; staminode 1, ca. 1.2 mm. Disc ca. 1.2 mm, shallowly 5-lobed to subentire.

花冠蓝紫色到带绿色带粉红色的白色的或，1.8-2.3厘米，外面被短柔毛到后脱落；逐渐，圆筒状的近筒部稍自基部在嘴，3-6毫米的1.4 X-2厘米；瓣片有点二唇形；从近中部，耳垂1.5-2 X 1.5-2毫米2裂的正面的唇；背面的唇裂片3.5-5.5 X 2.5-3毫米雄蕊贴生于花冠超过基部，6-13毫米5-7毫米；花丝纤细，稍扁平，无毛；花药长圆形，2室，纵向开裂，药隔无毛；退化雄蕊1，大约大约1.2毫米，浅5浅裂到近全缘的1.2毫米光碟。

Is the perennial for the orthodon lavandula spica to be often green the cold resistant Asian bush, produces originally in the Mediterranean Sea coast, European each place and the Oceanian chain islands, if French proletariat prosperous Si, latter is widely planted in England and Yugoslavia.

叶互生，椭圆形披尖叶，或叶面较大的针形，叶缘反卷。穗状花序顶生，长15～25厘米；花冠下部筒状，上部唇形，上唇2裂，下唇3裂；花长约1.2厘米，有蓝、深紫、粉红、白等色，常见的为紫蓝色，花期6-8月。全株略带木头甜味的清淡香气，因花、叶和茎上的绒毛均藏有油腺，轻轻碰触油腺即破裂而释出香味。

Calyx ovoid to campanulate, declined in fruit, glandular outside, glabrous or occasionally villous at throat inside, limb 2-lipped; upper lip 3-toothed, middle tooth circular to obovate, margin winged, decurrent, lateral teeth shorter; lower lip 2 toothed, teeth narrower, apex acuminate to spinescent, sometimes approximate.

卵球形的花萼到钟状，在果期下弯，在外面具腺，或偶有具长柔毛在喉部在里面，二唇形的瓣片；上唇具3齿，中间齿圆到倒卵形，具翅的边缘，，侧齿短；狭窄下唇2齿，齿，对具刺，有时紧靠的先端渐尖。

Corolla yellow to red or white, zygomorphic, inside usually glabrous; tube subcampanulate to funnelform-tubular, not swollen, 5-6 X longer than limb, 3-7 mm in diam.; limb 2-lipped; adaxial lip emarginate to nearly entire, extremely short, extending only slightly beyond mouth; abaxial lip 3-lobed, central lobe longer than laterals, apex rounded.

花冠黄到红色的或白色，左右对称，内部的通常无毛；管状的筒部近钟状到漏斗状，不膨胀，5-6 X长于瓣片，3-7毫米直径；瓣片二唇形；对近全缘微缺的正面的唇，极短，只细长在嘴以外延长； 3浅裂的背面唇，中央裂片长于laterals，先端圆形。

Corolla zygomorphic, ventricose funnelform, tube narrow at base, throat wide; limb oblique, ca. 2-lipped, upper lip 2-lobed or entire, lower lip 3-lobed with middle lobe larger.

左右对称的花冠，一侧臌，筒部狭窄在基部，喉宽；大的偏斜，约二唇形的瓣片，上唇2裂的或全缘，下唇3浅裂的具中部裂片。

Methods 49 cases with unilateral cleft lip were repaired on modified Millard's method. These ways include: The improved type"Ⅰ"didn't make cut under the anterior naris;the distinction between the wet and dry vermilion of the lip, and the application in the operation; closed in the wound near at pyriform aperture edge by"L-flap"and"M-flap"; relaxed alae nasi and made a slack cut in the nasal cavity; flexible use for"5～x"back cut and "C-flap".

对49例先天性单侧唇裂应用改良的Millard法修复：改良Ⅰ式不在患侧鼻孔下方作切口，减少了瘢痕形成；利用患侧干燥红唇组织重建健侧唇弓部分的红唇欠缺；利用小瓣&L&、&M&连同唇颊黏膜瓣来参与闭合梨状缘附近的伤口促进愈合；松解患侧鼻翼外侧脚及鼻腔内作松弛切口重建前鼻孔；灵活掌握&5～x&的返切和&C&瓣的旋转推进方向来延长唇高。

To build a large vocabulary lipreading system based on single visual channel,an unitary U-LDCT-KL two-level feature extraction method is presented in this paper.It is based on lip region partition DCT coefficients to be gotten rid off the overlap of those local coefficients by KL.

在建立视觉单通道的大词汇量唇读系统中，提出了归一化的U-LDCT-KL两级唇读特征提取方法，即针对唇区分块的DCT系数进行二级KL（Karhunen-Loeve Transform）去局域参数的交叠。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。