和电路

Secondly, the thesis analyzes the design principle of hardware system, and descries the architecture of the solution. It analyzes how to implement AD converter, IDT72V3690 circuit, FPGA chip EP1C2214 design, including RAIDO disk control and application of embedded microprocessor LPC2214.Thirdly, the thesis descripts the design and realization of embedded software of LPC2214. First of all, it brings out the thinking of software layer, and designs the software architecture.

其次，叙述了基于USB总线硬件系统的体系结构及设计原理；详细介绍了如何实现AD转换电路抗干扰以及如何采用嵌入式处理器LPC2214、高速缓存IDT72V3690电路、FPGA芯片EP1C2214等电路设计实现简易RAID0存储阵列；重点叙述了FPGA设计ATA控制器和RAIDO逻辑的过程，介绍了FPGA内部逻辑是如何工作，将数据有序高效地并行存储到磁盘中去的。

The electro-optical device includes, in a peripheral area, image signal lines which run from an external circuit connection terminal to a sampling circuit detouring a periphery of a data line driving circuit, and a vertical conducting terminal which is laid in a second side of the TFT array substrate intersecting the first side in the peripheral area observed from the sampling circuit and which electrically conducts to a counter substrate.

电光装置，在周边区域具有从图像信号端子迂回绕过数据线驱动电路的周围而到达采样电路的图像信号线和在周边区域中从采样电路看在与第1边相邻的一个基板的第2边附近配置的、实现与另一基板侧的电的上下导通的上下导通端子。

Thereinto, the analog receiver, the main body of the UATS preprocessor, conditions the output signals of the receiving transducer, which are amplified and filtered.And the driving circuit implements the low-pass filtering of the D/A converters output signals and offers the result to the power amplifier circuit as its input.In addition, the fathoming circuit acquires the depth information of the underwater electronic equipment cabin to ensure a relatively convenient way to adjust and recover the underwater parts of the system.

其中，模拟接收机完成对接收换能器输出信号的放大、滤波等调理工作，是水声靶标系统预处理机的主体部分；驱动电路实现对D/A转换器输出信号的低通滤波，用以产生功率放大电路的输入信号；测深电路用来获取水下电子舱的深度信息，便于系统水下部分的调整和回收。

Through introduction of improved cofficient and time error that is observed simultaneously the author makes an inductive reasoning of two similar formularies,which can be applied to current regulator tube scanning circuit .

引入了恒流管扫描电路在同一时刻的改进系数和时间误差，归纳了两个近似公式，对几种恒流管扫描电路的性能作了深入一步的研究，并且简化了对该电路的计

This paper amply discusses the investigation and design of conductance cross-correlation flowmeter, it includes the design of the conductance cross-correlation flow sensor, the design of the prompting source circuit, the design of the signal conditioning circuit under the well, the design of the signal incepting circuit on the floor and the design of the software.

论文详细介绍了研究开发的电导式相关流量计，包括电导式相关流量敏感器的设计、激励源电路的设计、井下信号调理电路的设计、地面信号接收电路的设计和上位机软件的设计。

Electronics Of, relating to, or constituting an inducting current, circuit, or coil.

原线圈的：线圈，电路或电流的；和线圈、电路、电流有关的；组成线圈，电路或电流的

Barrier Gate. Unplug on three porcelain inserted into AC power safety plug, the blowing of the bondid, and fusealways have been resulting in phenomena: on the UN-effectual circuit (pulse－width electrocircuit) has no effect, the work will still be able to make its output stability and normal positive and negative 15 volts DC power supply voltage, and make the control circuit is working properly; and on the high current circuits works have a great effect, make it output a serious shortage, and cause the machine to the highest 速增 not.

关闸。拔下配电不活上的三个瓷插式互换电源保障插头查抄，发掘其洋一相的保障丝还来烧不续，并由此变成了此刻的本体：差小电流电路的处事操纵感化，仍可使其输入安定和变态的侧负15不起直流电源电压，并使把持电路的处事变态；而差不小电流电路的处事有很不小感化，使其输入惨重不敷，并导致机不缓增不到最矮不缓的本体。

Secondly,the experimental equipment of electrical life of relay was developed and the arc erosion status of contact s of breaking the inductive load with the four circuits was researched by experiments.

论文首先构建了无保护电路和3种有保护电路模型并给出了电弧能量的计算公式；然后研发了继电器电寿命实验装置并通过实验研究了上述4种电路中继电器开断感性负载时触点的电弧侵蚀情况。

Firstly, the models of one unprotected circuit and three protected circuits were built and the formulas of arc energy for each circuit were given in this paper. Secondly, the experimental equipment of electrical life of relay was developed and the arc erosion status of contacts of breaking the inductive load with the four circuits was researched by experiments.

论文首先构建了无保护电路和3种有保护电路模型并给出了电弧能量的计算公式；然后研发了继电器电寿命实验装置并通过实验研究了上述4种电路中继电器开断感性负载时触点的电弧侵蚀情况。

The two kinds of design methods for the microwave active filters are studied, which involve the negative resistance circuit design method and the network cascade method, and how to translate the lumped parameter circuit into the distributed parameter circuit is given.

同时，给出了集中参数电路转化为分布参数电路的方法，结合设计实例，给出了两种微波有源滤波器的计算机模拟结果和分布参数电路的几何尺寸。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。