和电路

This article first introduced designs the high efficiency cocurrent voltage-stabilized source's composition structure and the control principle, and on the power source main circuit, the control circuit, the protection circuit as well as the control system software's design did have analyzed in detail.

本文首先介绍了所设计的大功率直流稳压电源的组成结构和控制原理，并就电源主电路、控制电路、保护电路以及控制系统软件的设计做了详细地分析。

The diagram schematics are figured out by using commonly-used chip named 555 timer and 74LS90 conter, tests are given on the simulation in every unit, simulation effect of circuit can be observed in a direct and clear way.

使用常用的芯片555定时器和74LS90计数器设计了电路原理图，对电路的每个单元进行了仿真实验，可以直观地观测出电路的仿真效果。

This product is applicable to coal mine where has explosible dangerous gas and coal dust,It is used for controlling direct starting stop and reversion of three-phase squierrel cage type asynchronous motor whose rated current up to 400A in system of AC50Hz rated voltage 1140V or 660V, Meanwhile it protects the electromotor and relative circuit, The starter can be combined with firedamp sensor and used to test the consistency of mining working area,the starter will trip when it exceed the limit ;adopt intrinsic safety type circuit for the control circuit; possess the function of local control and remote control by single set and multi sets procedure control; display working voltage current and gas consistency can remember fault parameter

该产品适用于具有爆炸性危险气体和煤尘的矿井中，在交流50Hz，额定电压为1140V或660V ，控制额定电流只400A的三相鼠笼式异步电动机的直接起动，停止及反转，同时对电动机及有关电路进行保护，起动器可与甲烷传感器相连接用于检测才掘工作面的甲烷浓度，当其超限时起动器跳闸；控制电路采用本安型电路；具备单台就地控制与远方控制及多台程序控制功能，能显示工作电压、电流、瓦斯浓度，并能记忆故障参数。

Along with development of electronic technology, especially VLSI and mixed signal circuits,where there are physical or functional blocks and subnetworks which are indiscerptible in the network, it shows its practical value.

随着电子技术的发展，特别是超大规模模拟电路和模数混合电路发展，对于电路中存在着物理上或功能上具有不可分割的功能块或子网络时，该方法更显其工程实际意义。

With the current mode logic structure, the input buffer and the predriver circuit have the capability of transmission and amplification of high speed data. By employing MOS-HBT cascode structure as the output stage, the laser diode driver exhibits very high speed and efficiency working at the 10 Gb/s data rate.

输入缓冲、驱动放大电路采用电流模电路，满足高速数据传输和放大的能力，输出级电路结构采用新型的MOS-HBT共源共栅结构可以降低米勒效应减小输入电容，从而使激光驱动芯片工作在10Gb/s时也能达到良好的性能。

In this paper, based on analysis the characteristic of direct-drive WPGS and other devices, the main circuit structure, which composed of three-phase full bridge rectifier, sepic chopper and single-phase full-bridge inverter, is presented.

本文在详细分析直驱风力发电系统特点和已有逆变装置的基础上，确立了三相不可控整流桥+SEPIC变换电路+单相全桥逆变电路的逆变装置主电路结构。

The whole PWM circuit contains two subcircuit, the front-end is PWM module that make up of the counter that based on nine MOSFET True-Single-Phase-Clock D flip-flop; the back-end is demodulated module, which is consist of a three order Chebyshev low-pass filter used trans-conductor capacitor. All the subcircuits are simulated. At last, an approving simulated result of the whole circuit is given too.

在调制部分，利用九管单相时钟D触发器构成计数器，并由此组成了脉冲宽度调制电路，同时给出了在典型温度下的仿真结果；在解调部分，介绍了低通滤波器从无源到有源的设计方法，设计了三阶切比雪夫低通跨导电容滤波器，同样给出了相应的仿真结果；最后，作为将脉冲宽度调制电路和滤波器作为整体电路，以脉冲调频波为输入进行了仿真，取得了令人满意的结果。

Experimental results demonstrate the effectiveness of the proposed on-line testable and repairable design, with unconspicuous performance degradation of the functional circuit.

文献[3-7]的方法借鉴了数字电路中冗余设计和校验的思想，针对开关电容滤波器的串联结构，将被测电路划分为多个模块，在电路中设置一个冗余的可编程模块，可以在测试

multi-channel correlators are widely used in traditional pseudo-random code cw radar,which makes the ranging system more complicated.this paper proposes a method of digitalizing the return signal directly and then convoluting the signals on dsp,which can replace multi-channel correlation in analog circuit.but the computation of convolution is too huge for the dsp to fulfill.to solve this problem,this paper analyzes five fast algorithms including fft,and then chooses one according to the characters of prc-cw radars.the digital method and fast algorithm have been verified by simulated signal and real signal.

一种提高空间伪码扩谱测距精度的实用。。。摘要：传统的伪码调相连续波雷达采用多路模拟相关电路实现对回波信号的相关接收，通过多路试探搜索各距离单元的目标，电路复杂。提出的数字化方案，对回波信号直接数字化，利用高速dsp实现数字卷积，可替代多路模拟相关电路。但是直接卷积的运算量过大，dsp无法承受。本文对此进行了研究，分析了包括fft在内的五种快速算法，结合prc-cw雷达的具体情况，确定了一种适于dsp实现的快速卷积算法。仿真和实测数据证实了数字化方案及快速算法的正确性。

multi-channel correlators are widely used in traditional pseudo-random code cw radar,which makes the ranging system more complicated.this paper proposes a method of digitalizing the return signal directly and then convoluting the signals on dsp,which can replace multi-channel correlation in analog circuit.but the computation of convolution is too huge for the dsp to fulfill.to solve this problem,this paper analyzes five fast algorithms including fft,and then chooses one according to the characters of prc-cw radars.the digital method and fast algorithm have been verified by simulated signal and real signal.

摘 要：传统的伪码调相连续波雷达采用多路模拟相关电路实现对回波信号的相关接收，通过多路试探搜索各距离单元的目标，电路复杂。提出的数字化方案，对回波信号直接数字化，利用高速dsp实现数字卷积，可替代多路模拟相关电路。但是直接卷积的运算量过大，dsp无法承受。本文对此进行了研究，分析了包括fft在内的五种快速算法，结合prc-cw雷达的具体情况，确定了一种适于dsp实现的快速卷积算法。仿真和实测数据证实了数字化方案及快速算法的正确性。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。