和电路

The main contents in this thesis include the following three aspects: the study of reference circuit model based on sub-threshold MOSFETs, the design of reference circuit based on MOSFETs operating in sub-threshold region and the correction of process divagation for reference circuit based on sub-threshold MOSFETs, respectively.

本论文的研究工作主要是包括三个方面的内容，即亚阈值MOSFET基准电路模型的研究、亚阈值MOSFET基准电路的设计和亚阈值MOSFET基准电路的误差修正。

The characteristic of the method is that driving condition and clock pulse for flip-flops are obtained at first hand by means of the state transitio n drawingand that designing asynchronous sequential cir-cuits and synchr onous sequential circuits can be unified.

时序逻辑电路可分为同步和异步，然而采用传统的时序电路的设计方法时，即使是同步时序电路的设计也需要7步[3]，要进行复杂的计算来求状态方程、驱动方程，既繁琐又容易出错；对异步设计就更为复杂了。

In the same time,main circuit figuration and working principle will be given,and worked out the parameter of this circuit S transformer and RCD clamped circuit.

给出了电路的主电路图，在此基础上阐述了此电路的工作原理，并分析计算出了变压器和RCD缓冲电路设计的参数。

First, to optimize imprecise polynomial circuits using arithmetic transformation, implement the design under different error precision bound and considering the case of fixed point and floating point representation., to search the optimized circuits with branch and bound algorithm.

方法首先利用算术变换进行非精确多项式电路优化，给出电路在不同精度界限下的实现，考虑电路的定点和浮点设计表示，然后应用分枝定界方法求解出最终的优化结构。

Two high-voltage circuits have been designed: voltage doubling rectifying circuit and fly-back switching high-voltage power supply circuit.

设计了两种高压产生电路：倍压整流电路和反激式开关电源电路。

This paper analyses fundamental of general thyristor single phase bridge half controlled rectifier and draws work wave of each part. to avoid out of control, the freewheel diode is added, the work wave is analyzed.

本文从常规的晶闸管单相桥式半控整流电路着手，分析其电路工作原理和各部分工作波形，为避免失控，在电路中添加续流二极管，并分析了相应的各部分波形。

I introduced in the paper one kind of VVVF elevator control system, I has used the closed loop velocity modulation regarding the elevator velocity modulation system, and has carried on the detailed design separately to the hardware electric circuit main part,including PLC control section,frequency changer,main circuit and gate and so on.

在论文中我介绍了一种VVVF的电梯控制系统，对于电梯的调速系统我采用了闭环调速，并对硬件电路的主要部分分别进行了详细设计，包括PLC控制部分，变频器，主电路和门电路等。

The peak time detecting circuit which is composed of full-wave rectification circuit and differential circuit can detect the reach time of echo signal accurately.

采用时间增益补偿技术，补偿超声波在空气中的衰减，减少回波信号的起伏；由有源全波整流电路和微分电路等组成峰值时间检测电路，可正确检测回波的峰值到达时间。

The article makes a comparison among different types of bus, bus transmission signal and several familiar topologies of front-end converters and load-end converters. Finally, the half bridge converter with full-wave rectifier based on the high-frequency parallel-type AC bus bar is chosen as circuit structure and optimized. The working mode under different condition of the circuit is analyzed and a mathematical model is set up under continuous current mode. Simulation result is used as comparison.

通过对比不同类型的母线、母线传输信号以及各种常见的前端变换器拓扑和负载变换器拓扑，确定了基于并联型高频交流母线的半桥变换器加全波整流作为电路拓扑，并优化了电路的结构，分析了基于不同工作状态下的电路结构并建立电流连续模式的数学模型，并与软件仿真结果进行对比。

Feedback is from the cathode circuit to the grid circuit via the capacitive divider C2 and C3. C3 is variable, to allow exact tuning to 1.00 MHz.

阴极到第一栅的回授电路是通过C2和C3组成的电容分压电路实现的。C3用可变电容以似的电路能在1MHZ上准确震荡。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。