和电路

It consists of circuitry that this constant current circuit stabilizes the criteria of a highly precise returned type constant current circuit of operation in another constant current circuit,Furthermore, the voltage amplification with very high stability is realized by adopting this constant current circuit also as the bias circuit of a first rank cascode and the 2nd step cascode, and the 2nd step constant current load intensity.

它由电路，这恒流电路稳定的标准，一个高度精确的返回式恒流电路的运行在另一恒流电路，此外，电压放大具有极高的稳定性，实现了通过这项恒流电路也作为偏见电路的第一级和第二栅栅一步，和第二步骤恒定电流负荷强度。

Then, on the basis of the functional verification, the system architectures of the radio frequency analog front end and the control logic circuit for the passive UHF RFID transponder are studied and designed with low-power design techniques. The RF AFE circuit includes rectifier, matching network, backscatter, regulator, AM demodulator, voltage reference, local oscillator and power on reset circuit, and so on. The control logic circuit contains clock synchronization module, decoding module, coding module, cyclic redundancy checksum module, power management unit, control unit, shift register and memory.

然后，在功能验证的基础上，重点研究了无源超高频射频识别标签芯片射频模拟前端电路和控制逻辑电路的系统架构，并采用低功耗设计技术对其进行了设计，射频模拟前端电路设计包括了整流器、匹配网络、反向散射电路、稳压器、AM解调器、电压参考源、本地振荡器以及上电复位电路等，控制逻辑电路设计包括了时钟同步模块、解码模块、编码模块、CRC校验模块、功率管理单元、控制单元、移位寄存器和存储器等。

In Chapter 4, on the basis of the selected CPU chips, the hardware frame of the embroidery machine control system is determined according to the overall framework. The power circuit, reset circuit, memory interface circuit, keyboard and display circuit, USB interface circuit, serial communication interface circuit and nether electromechanical interface circuit are designed in particular.

第四章根据总体架构，在选好的CPU芯片的基础上确定了绣花机控制系统的硬件框架，详细设计了电源电路、复位电路、存储器接口电路、键盘与显示电路、USB接口电路、串行通信接口电路和下层机电接口电路。

Set off from the function request analysing the instruction fuse, have done more detailed introduction first to it's every ingredient; The design and concrete parameter having followed , carrying out a scheme on the circuit directing fuse power source boosting circuit , host to get angry , electricity basics circuit such as insurance circuit , self-destroying circuit , self-deactivating circuit here on the basis, are chosen; Constitute every circuit optimization finally, having become a overall circuit module

从分析指令引信的性能要求出发，首先对其各组成部分作了较详细的介绍；随后，在此基础上，对指令引信的电源升压电路、主发火电路、电保险电路、自毁电路、自失能电路等基本电路进行了方案设计和具体参数选取；最后，将各电路优化组合成了一个整体电路模块。

The design of accelerometer/angulometer is based on MSP430FW425 microcontroller and ADXL202 accelerate sensor. Protel DXP is used in circuit design, which completes the schematic and PCB design of modules including the clock circuit, the filtering circuit, the power supply circuit, the communication circuit between MSP430 and PC, ADXL202 collecting signal circuit and LCD display circuit.

硬件部分采用Protel DXP开发平台完成了系统的时钟电路、滤波电路、电源电路、MSP430 与PC机之间通信电路、ADXL202传感器电路、LCD显示电路等的电路原理图和PCB板图设计，完成了硬件实物制作。

A A Class 2 circuit as defined in 3.6; b A limited-voltage/current circuit as defined in 3.32; or c An internal circuit not conductively connected to another source of voltage or current (the voltage or current is received through the receptacle or connector), and the circuit and its components comply with applicable requirements of this standard 28 舞台灯标准 for separation from other than Class 2 and limited-voltage/current circuits.

a 二类电路详见3.6内容； b 限流/限压电路详见3.32或 c 内部电路与其它电压或电流不导电。电路和其元件符合分离不同于二类电路和限压/流电路标准的相关规定。

First, it analyses all-around design of the electronic computer-based interlocking system and each module, then from introducing CAN bus, it lucubrates design of the censorial module's software and hardware which is based on CAN bus of signal lamp's stimulant state, then the hardware's circuit of the entire system's censorial module is made up of opsonic circuit, collecting circuit, microcontrolled circuit,circuit of communication, interrupt circuit of overcurrenting and reset circuit.

首先对全电子计算机联锁系统的总体设计及各个执行模块进行全面的分析和研究，然后通过介绍CAN总线技术，着重研究了基于CAN总线的信号灯模拟状态监测模块的软硬件设计，其中整个系统监测模块的硬件电路主要由硬件调理电路、采集电路、微控制电路、通信电路、高过流中断电路、复位电路等部分组成。

The control circuit takes the singlechip computer as the nucleus, its peripheric circuits include data acquisition circuit, pulse width adjusting circuit, waveform chosen circuit, electric machinery circuit and interface circuit.

控制电路部分以单片机为核心，其外围电路包括数据采集电路，脉宽调制电路，波形选择电路，电机控制电路，键盘、指示灯和显示接口电路及串行通讯接口电路。

Based on the analysis of traditional converters, a novel circuit is proposed, what it defers from traditional two switches/phase converter is that it has not dump resistance, and that the rise time and falling time of the phase currents can be effectively reduced, and the torque and output power performance of the system is improved.

在分析了常用的功率变换电路基础上，提出了一种基于双开关功率变换电路的改进电路，该电路与常规双开关功率变换电路的区别在于不需要能耗制动电路，能够利用关断相绕组中储存的能量有效缩短相电流的建立和关断时间，改善SR电机高速运行时输出转矩下降和转矩脉动严重的问题，并且电机的输出功率也得到提高。

An image display apparatus includes a display having data holding function, a vertical drive circuit sequentially and selectively scanning matrix form display elements, and a horizontal drive circuit writing a voltage among binary voltage preliminarily assigned depending upon the digital data of the image signal. The horizontal drive circuit and the vertical drive circuit are operated for performing selective scan of respective display element for at least m times in one frame period. The vertical drive circuit is constituted of n number of sequence circuits and logic operation circuits for outputs of the sequence circuits, where n is smaller than m, a period from inputting to the sequence circuit to outputting from the final stage being less than or equal to half of one frame period, and at least one of the sequence circuits being used with selectively inputting a plurality of inputs.

提供了一种图象显示器，其具有显示部，在矩阵上排列的象素内保有数据保持的功能，根据保持的数据进行显示；垂直驱动电路，对构成显示部的矩阵状显示器以每行按顺序作选择性扫描；以及水平驱动电路，对于由垂直驱动电路选择的行显示器件，根据应显示的图象信号数字数据，从预先分配的二进制电压中写入电压，并利用水平、垂直驱动电路，与应显示的图象信号同步，在1帧期间至少m次对各显示象素进行选择性操作，以此进行多色调显示，垂直驱动电路由满足n＜m的n个顺序电路和其输出的逻辑运算电路组成，顺序电路的输入从最后级输出为止的期间为1帧期间的1/2以下，并且，n个顺序电路的至少一个的输入是切换多个输入系统而使用。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。