吸附了的

In this study, sorption characteristics including adsorption kinetics and sorption isotherm of sodium caseinate films were carefully investigated.

作者以大豆蛋白酪蛋白酸钠膜为对象，从吸附动力学和水分吸附等温线研究了蛋白膜的水分吸附特性。

Reticulated vitreous carbon is used as an adsorbent for cesium in this work.

以网状玻璃体碳为吸附剂，用中子活化分析法研究了在静态条件下，吸附温度和吸附时间对铯在RVC和液态钠中分配的影响。

The results obtained from fit of response curve were agreement with mechanism of chemisorption.

吸附曲线拟合的结果证实了特异性吸附属于化学吸附。

In addition, some modifications on several computational methods are also presented. Using LMTO method the electronic structure of several systems are studied, and some results are obtained. They are: The ideal Nb (100) surface has three surface states, the multi-layer relaxed surface has two surface states. The surface energy of the ideal surface is higher than that of the relaxed surface, that means that the multi-layer relaxed surface is more stable than the former one, which supports the LEED results. The mono-layer relaxed Ag (111) surface is the most stable one among several" stable surface models"presented by several researchers. The surface energy of Ag (111) surface is higher than that of surface Ag (001), which supports some experimental results such as different reaction rate at different surface orientations for the same material. The surafce states of Si (111) surface not only locate near the Fermi level, but also in the valence band, which agrees well with Cohen's conclusion. Si (111)-H is an effective model for analysing the surface states and H adsorbed on the back surface is a good method for improving the convincingness of the results obtained on thinner slab models. The surface stability depends on three different kinds of MoSi〓(001) surfaces, the surface with mono-layer Si is the most stable one, and the surface with Mo at the first layer is the most unstable one among them. These are consistant with the Kemoda's experimental results. The valence bands of clean or K adsorbed CdTe (111) surface agrees well with the synchrotron radiation studies. The surface of CdTe (111) consists of four kinds of surface models which show different surface electronic structures and different surface structure stabilities. The conclusion agrees well with Wu's experimental work. The different absorbed alkali metals on the CdTe (111) surface give different adsorption characteristics which have relations not only with the valence electrons, but also with the core ones of the alkali metals. The electonic structures of Si-C alloys are different from that of Si-Ge alloys, and the energy band gaps of Si-C alloys do not increase linearly with Carbon concentration, our conclusion supports Alexander's results, but conflicts with Soref's one.

现分述如下： LMTO方法及其应用方面：1）通过对Nb（100）表面电子态分析发现清洁理想表面有三个表面态，多层弛豫表面有两个表面态；表面能大小说明多层弛豫表面更稳定，支持了LEED结果。2）通过对采用不同方法获得的几种不同Ag（111）表面稳定结构的表面能计算分析，给出了单层弛豫表面为Ag（111）表面的最稳定结构；从Ag（111）单层弛豫表面和Ag（001）表面的表面能比较，发现了Ag（001）表面表面能要比Ag（111）小的，表明了同种物质不同表面取向将表现出不同物理、化学性质，这是与实验中得出的结论是吻合的，3）通过对Si（111）表面态分析，不仅发现了Si（111）表面不仅具有居于费米能级附近的悬挂键所对应的表面态，而且还有很多表面态位于价带能量范围内，与Cohen等结果一致，H饱和slab模型背表面相当于增加了slab层的厚度，是一有效的变相增加slab层厚的方法，弛豫表面较清洁理想表面价带谱们低能端的少许移动，预示着总能降低，说明弛豫表面较清洁理想表面稳定。4）MoSi〓具有三种表面，从费米能级上态密度值大小得到单层Si表面最稳定，Mo原子为表层原子的表面最不稳定，双层Si原子表面居中的结论，这与Kemoda等人实验结果是一致的。5）通过对CdTe（111）表面表面电子态、表面结构稳定性及表面H、碱金属吸附的电子结构系列研究，不仅得出了CdTe（111）清洁及碱金属K吸附价带谱与同步辐射光电子谱相吻合的结果，而且发现了CdTe（111）表面具有四类不同原子近邻特征，表现出四类不同的表面结构及电子结构特征：不同表面态分布、不同的表面结构稳定性（表层原子与次层原子成三键有一悬挂键的表面要比表层原子与次层原子成一键有三悬挂键稳定（与Wu等人实验结果一致））、不同的H吸附特性。

As a result, electrostatic interactions and hydrogen bond were identified to contribute to the affinity interaction, while hydrophobic interaction contributed little. Moreover, the importance of electrostatic interactions and hydrogen bond to the affinity changed with pH value.The effect of rate of mobile phase on the retention of insulin was researched and the dynamic adsorption isotherm was got by analyzing the breakthrough data with Langmuir equation.

通过调节流动相的pH值和离子强度，并使用尿素和乙二醇分别对吸附蛋白进行洗脱，详细研究了吸附效果最好的目标蛋白质与肽配基之间的亲和吸附机理，发现静电作用和氢键是二者之间产生亲和吸附的主要作用力，而疏水相互作用对该亲和几乎没有贡献。

The balance time and isotherm equation for the adsorption of HPW12 on the carrier are determined.

吸附实验确定了HPW12在载体上的吸附平衡时间及吸附等温线方程。

In order to displace and accelerating release coalbed methane, a series of underground experiment of nitrogen injection in coalbed were also completed in Shigang coal mine of Yangquan Ming Group.

HT5H〗摘〓要：〖HT5K〗实验室研究了山西阳泉无烟煤在30 ℃恒温下注入N2对吸附平衡煤样中CH4的竞争吸附解吸特性，结果表明混合压力高于225 MPa后，CH4吸附量开始下降。

The conclusions were as follows: theνO-H andνC=O IR absorption maxima shifted towards higher wave numbers after imprinting 17β-estradiol on TFMAA-co-TRIM copolymer with the red shift of theνO-H groups being apparent after precipitation polymerization for 16h while that forνC=O groups being observed after polymerization for 24h. A strong interaction between TFMAA and 17β-estradiol was confirmed by the high selectivity for 17β-estradiol, as indicted by the values of the separation factor of isomers of 17β-estradiol/17α-estradiol (2.28) and the imprinted factor (3.01). Particle diameter of TFMAA-co-TRIM polymer was between 300 nm and 1.5μm, which suited well for solid phase sorbent throughout at low column pressure. The recognition of imprinting TFMAA-co-TRIM polymer for sterol molecules was driven by enthalpy eluted with acetronitile, and low temperature was in favor of the separation of sterol structure analogues on imprinting column. TFMAA-co-TRIM polymer possessed of determinate anti-heat stability, with melting point beginning at 255.84℃, Tp=257.40℃, control TFMAA-co-TRIM polymer and imprinting TFMAA-co-TRIM polymer were respectively decompounded at 267.79℃and 343.11℃, and solid micro-extraction noddle prepared by the special polymerization also showed definite recognition for 17β-estradiol by GC/MS detecting at 270℃. By selection of various washing and elution solvents, elution reagents of close polymerization system were of more advantage in template molecules retention and recognition on molecularly imprinted solid phase extraction column. At a certain extent, progesterone, 17α-estradiol, 17β-estradiol and 4-androstene-3, 17-dione could be intercepted on the MISPE column. Especially, MISPE had high selectivity for progesterone, and imprinting TFMAA-co-TRIM polymer could achieve adsorption balance within 50 min by absorption kinetics test for 17β-estradiol. However, MISPE column showed better selectivity and enrichment property for 17β-estradiol than C18 and CSPE columns according to the data from HPLC and GC/MS analyses. Recovery of 17β-estradiol on MISPE column was up to 85.5% while when prime extracting solution of milk powder was sampled, the recovery of CSPE and C18 columns were 43.7% and 30.7%, respectively.

通过研究阐明：紫外聚合产物TFMAA-co-TRIM中的νO-H振动吸收峰在聚合16h后红移，νC=O振动吸收峰在聚合24h后红移；TFMAA-co-TRIM对雌二醇异构体的印迹因子达到了3.01，α为2.28，优于其它功能单体参与得到的聚合物识别特性；TFMAA-co-TRIM聚合物粒径介于300 nm至1.5μm之间，作为色谱固定相具有良好的通量和低的柱压；在乙腈流动相中，TFMAA-co-TRIM分子印迹固定相的分离过程主要被焓驱动，低温有利于分子印迹固定相分离甾醇结构类似物；TFMAA-co-TRIM分子印迹聚合物在255.84℃时开始熔融，Tp=257.40℃，聚合物CP的降解温度在267.79℃，MIP降解温度在343.11℃，制备的固相微萃取头初步经GC/MS 270℃的耐热性测定；不同的洗提溶剂筛选证明了选择接近聚合溶剂的洗脱体系更有利于MISPE发挥识别效应；分子印迹固相萃取柱对孕酮、17α-雌二醇、17β-雌二醇和雄烯二酮都具有不同程度的保留特性，可作为此类化合物的吸附材料，特别对孕酮强保留的富集特性，可作为孕酮的选择性识别吸附剂，其分子印迹聚合物对17β-雌二醇的吸附动力学测定显示在50 min内基本达到吸附平衡，具有作为传感器核心敏感材料的潜力；对比萃取奶粉中17β-雌二醇性能，MISPE柱比非分子印迹固相萃取柱和C18柱具有更高的保留，回收率依次为85.5%，43.7%和30.7%。

Surface complex supports VSiO, which have good engineering character, and supported Pd/VSiO and Cu/VsiO catalysts have been prepared by surface chemical reaction modification and isovolume impregnation method, respectively. BET, TPR, chemisorption-IR chemisorption-TPD and microreaction techniques have been used to study the adsorption activation and partial oxidation reactivity of CO〓 and C〓H〓 on the Pd/VSiO and Cu/VSiO catalysts.

以表面化学反应改性法制备了工程性质优良的VSiO表面复合物载体，并以等体积浸渍法制备了负载型的Pd/VSiO和Cu/VSiO催化剂；采用BET、TPR、化学吸附—IR、化学吸附—TPD和微反技术研究了Pd/VSiO和Cu/VSiO催化剂对CO〓和乙烷的吸附活化和部分氧化反应性能。

Quasiequilibrium measurement of both vibrational spectra and desorption isotherms are presented for NH〓 overlayer on Ag surface with the substrate temperature higher than NH〓 condensation temperature.

利用光声振动谱能够在较高暴露气压下测量的特点，本文研究了120K清洁和预吸附氧Ag表面上，处于吸附和脱附动态平衡之中的物理吸附态NH〓分子的吸附构型。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐