吸入腔

When gear-driven, the suction chamber side gear teeth withdraw mutually place the space between teeth volume increases gradually, pressure drop, the liquid enters the space between teeth under the differential pressure function.

齿轮转动时，吸入腔侧轮齿相互脱开处的齿间容积逐渐增大，压力降低，液体在压差作用下进入齿间。

The suction chamber with discharges the cavity is gnaws the vanishing line depending on two gears to separate.

吸入腔与排出腔是靠两个齿轮的啮合线来隔开的。

In this way, the liquids are vaporised at the surface thereof, sucked into the chamber without any need for a carrier gas and made to react with the dopant such that the oxide layer forms on the substrate.

这样，这些液体在其表面蒸发，无需任何的载体气体即可吸入腔室中，并与掺杂物反应，从而在衬底上形成氧化物层。

A pair of mutually meshing gears and pump cylinder to separate the suction chamber and discharge chamber.

一对相互啮合的齿轮和泵缸把吸入腔和排出腔隔开。

A pair of mutually meshing gears and the pump cylinder to separate the suction chamber and discharge chamber.

一对相互啮合的齿轮和泵缸把吸入腔和排出腔隔开。

The outlet of the introduction passage is located closer to the valve plate than to the wall of the suction chamber.

导入通道出口与阀片的距离比与吸入腔壁的距离小。

A pair meshes mutually the gear and the fluid cylinder and discharge the suction chamber the cavity to separate.

外啮合双齿轮泵的结构。一对相互啮合的齿轮和泵缸把吸入腔和排出腔隔开。

The introduction passage extends from a wall of the rear housing across a discharge chamber to a suction chamber.

导入通道从后部外壳的壁穿过排出腔延伸至吸入腔。

A second portion of the passage bends in the suction chamber substantially perpendicularly and then extends toward a valve plate of a compressor.

通道的第二部分在吸入腔内基本垂直地弯曲，然后向压缩机的阀片方向延伸。

The introduction passage has a first portion extending from an opening portion of the rear housing along a wall of the discharge chamber and along a wall of the suction chamber to the suction chamber.

导入通道具有第一部分，该部分从后部外壳开口部分沿排出腔的壁和吸入腔的壁延伸至吸入腔。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。