吸光度

After hydrolysis γ-polyglutamic acid became aminoglutaminic acid which could shape comoles compound (1:1) in pH 9.6 of borax buffer solution with chloranil. The comoles compound had absorption maximum at 350 nm.

利用γ-聚谷氨酸水解成谷氨酸，在pH 9.6硼砂缓冲溶液中，能与四氯对苯醌形成1：1的络合物，该络合物在波长350 nm处有最大吸收，通过测定其吸光度确定γ-聚谷氨酸含量。

Chemical methods of qualitative assay and quantitative assay to Chufa functional component According to chemical characteristics reactivity of Chufa functional component, chemical method of qualitative assay and quantitative assay to Chufa functional component were built.

功能因子的定性定量化学分析针对该功能因子的化学特征反应，实验选用硫酸显色法、可见光比色法、吸光度测定法和沉淀法对功能因子进行定性、定量分析。

The average optical density of cfos in cochlea was measured with computer image analysis system.

用免疫组织化学染色分析cfos基因在耳蜗的表达情况，用计算机图像分析系统测量耳蜗cfos蛋白的平均吸光度值。

A new and quick method for enzyme activity assay was developed in which the reduction of artificial electron acceptor potassium ferricyanide was measured by monitoring the color change of reaction mixture at 420 nm.

为了便于快速简便的测定IDA氧化酶的活力，还建立了一种以铁氰化钾作为人工电子受体，通过检测酶促反应在420nm吸光度的变化而快速定性定量测定酶活力的新方法。

A method for determinating the activities of pectinase was proposed in this paper. It can produce the red-brown amino compounds when 3,5-dinitrosalicylic acid and aldehyde were heated together. The amino compounds had maximum absorbency at 540nm. In certain range, there was a good linear relationship between the amount of reducing sugar and the color of the reaction mixture.

针对QB1502-92标准测定方法测定高活力果胶酶、固定化果胶酶活力存在的实验误差大，重现性及灵敏度差的缺陷，提出了利用3，5-二硝基水杨酸与醛糖共热产生棕红色的氨基化合物，在一定范围内还原糖的量和含有呈色氨基化合物的反应液颜色深浅成正比的原理，在540nm下测其吸光度，从而计算出果胶酶活力的测定方法，并对测定步骤、影响因素及测定中可能出现的问题进行了试验研究。

To avoid the effect of interaction between the two components on the determination, the column vector of K matrix obtained from the standard mixtures with least squares was used as the pure spectrum of component.

在550 nm～630nm内取41个波长测量7组标准混合溶液的吸光度作为校正集，用最小二乘法求得的系数矢量作为各组分的纯光谱。

Methods: The effects of initial and mature biofilms were measured by crystal violet assay under various concentrations of ampicillin and moxifloxacin.

通过结晶紫染色测定吸光度值的变化，观察不同浓度下两种抗生素对早期及成熟生物被膜的影响。

The prior cycles with higher axial stress and larger strain range greatly restrains ratchetting strain of subsequent cycling with lower ones. Creep behavior plays an important role in the ratchetting strain and its influence on ratchetting behavior can not be neglected. Fracture morphology characteristics of two kinds of materials were investigated by scanning electron microscope. It shows that failure of material A is induced by cavitation and that of material B is induced by decohesion. For material A, with the decreasing strain amplitude the fracture surface shows more larger diameter globular particles under uniaxial loading and can be seen more obvious and deep crack under multiaxial loading. However for material B, with the decreasing strain amplitude fracture surface shows larger and larger scalelike shape and becomes more smooth under uniaxial loading, but fracture surface under multiaxial loading looks like more smooth than that of uniaxial loading, and shows gradually wave-like morphology.

通过扫描电子显微镜研究表明：材料A为空穴引起的失效，材料B为剥离导致疲劳破坏；随着载荷幅值的减小，材料A在单轴载荷下，断口表面浮出更多更大直径的球状颗粒，而多轴载荷下，可以看到很深的裂纹；随着载荷幅值的减小，材料B在单轴载荷下，断口表面鱼鳞片越来越大，表面越来越平整，而多轴载荷与单轴载荷相比，断口表面看上去更加平整，并且随着载荷幅值的减小，断口逐渐呈现波浪形貌；通过微观的傅立叶变换红外光谱分析，结果表明随着应变幅值的增加，无论载荷是单轴还是多轴状态下，橡胶材料吸光度比值随着幅值的增加而增加，这说明体系中的结晶含量也随之增加。

Results The results of I showed that the maximum absorption peak of the Dopa solution to spectra was 480 nm and its change gradually stabilized with the time-increasing.

结果］结果显示，多已溶液的吸收光谱最大吸收峰λ为480nm，随着时间的增大吸光度变化趋于稳定。

Dosimeter absorbances should be read within a short period after exposure to radiation.

剂量计的吸光度要在其暴露在放射中很短一段时间后读取。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。