含金属的

The preventive measures for the harmful defects of alkali metals are as follows: 1, reducing the alkali metals content in the raw materials; 2, increasing the MgO content of the sinter , decreasing the basicity of slag , decreasing the Si content of the pig iron, increasing relative slag volume; 3 , introducing prereduced ore pellets or partly reducted sinter; 4increasing the ability of coke resisting alkali metals; 5, using refractories that have the ability of resisting corrasion of alkali metals; 6 , cleaning the blast furnace periodically. The above recommendations are necessary for decreasing the circulation and accumulation of alkali metals effectively in blast furnace, reducing the harmful influence of alkali metals on blast furnace, increasing the smelting intensity, decreasing the coke rate, improving the gas permeability.

基于碱金属对高炉冶炼的上述危害，本文结合湘钢高炉的实际生产情况，通过理论分析、计算以及其他钢厂防治碱害的经验，提出防治高炉碱害的措施：1、减少入炉原、燃料的碱金属含量；2、提高烧结矿中的MgO含量、降低炉渣碱度、降低生铁含硅量、适当增加渣量；3、采用预还原的金属化球团或部分还原的烧结矿；4、提高焦炭的抗碱能力；5采用抗碱侵蚀的耐火材料；6、周期性性洗炉，以有效地减少碱金属在高炉内的循环富集，降低碱金属对高炉的危害，提高高炉的冶炼强度，降低焦比，改善高炉透气性。

The preliminary chromatogram data were resolved with Mallat algorithm of wavelet analysis theory. This method that resetting the high frequency signals, reconstructing low frequency and then correcting the background signals in the original signal was to avoid the data skewness with negative digital points after background correction and achieve the baseline correction; according to the study and analysis of simulated data including curve background and real data of the needle-plate and free metal partials insulation defects, the method is effective; the best wavelet function of the background correction is Db5 and the best resolution times of the background correction is 8 for chromatogram data of SF_6 decomposition products, based on the calculation with different wavelet functions and resolution times.

在初步获取的气相色谱数据基础上，运用小波分析技术中的Mallat算法对色谱数据进行小波分解，采取将高频信号置零，重构低频背景信号，再用原始信号扣除背景信号的方法，并对背景信号进行纵向平移以避免扣除后出现负数据点造成色谱峰失真的题目及达到色谱图基线校正的目的；通过对含曲线背景信号的模拟色谱数据和针-板、自由金属微粒缺陷下的真实数据的计算研究表明，该方法的应用是有效的；并通过对不用小波函数和不同分解次数的背景扣除计算，确定了SF_6气体放电分解组分色谱背景扣除所选用的最佳小波函数为Db5小波和最佳分解次数为8次。

The fluorinated carbon film will be a potential material as the IC isolation medium, and it is becoming one of the rivalrous candidate medium dielectric constant materials to instead of the SiO2 for the higher density and higher speed IC in the future because of its lower dielectric constant and good thermal stability, the film will increase the speed and efficiency of IC.

含氟碳膜是一种很有应用前景的集成电路用介质材料，其低的介电常数和较好的热稳定性使它可以取代传统的SiO_2作为致密、高速集成电路的金属互连线间的绝缘隔离层，从而提高集成电路的速度和效率。

In this project, the selection criteria of matrix and reinforcement for obtaining composites with high strength and toughness are determined. The as-cast and aged microstructures of composites reinforced with particles of different strength are observed, and their metallurgical conditions and stabilization mechanisms are analyzed. The aging precipitation behaviors and mechanisms are studied. Some characteristics of nano-materials (micro-distortion areas) are found in 150nm- Al2O3p/Al composites and their formation mechanisms are expatiated. The "flexible" restriction to the deformation of the matrix by low strength AlN particle is observed by in-situ TEM and SEM techniques, and the mechanisms of its resist on cracks propagation and its contribution to composite strength are revealed. The high temperature deformation behaviors of Al2O3p/Al composites are studied. A rare-earth coating is established on sub-micron Al2O3 particles, leading to an improvement in wettability between coated Al2O3 and liquid aluminum and a decrease in infiltration pressure. The strength and ductility of coated particles reinforced composite are also increased. The interfacial characteristics, bonding structures and their formation mechanisms are studied, and the crystal orientation relationships between reinforcement particles and aluminum matrix are investigated. Finally a lighter composite with better balance of strength and damping properties is reinforced with hollow ceramic microballoons of ultra-lower strength.

本项目发现了获得高强度和高韧性复合材料的基体、增强体选择依据；观察了各种强度质点增强复合材料的铸态和时效态微观组织，分析其微观结构形成的金属学条件及稳定性机理，研究了其时效析出规律和时效机制，发现了150nmAl2O3颗粒增强铝基复合材料基体中的纳米材料特征，并解释了其形成机理；利用TEM和SEM动态拉伸技术发现了低强度质点AlN颗粒对变形协调的&柔性强化&机制，揭示了其对裂纹扩展的阻碍作用和对复合材料高强度的贡献；研究了中强度质点的Al2O3颗粒增强铝基复合材料的高温变形行为，并对其进行了稀土界面层设计与制备，改善了颗粒与铝合金之间的界面润湿性，降低了复合材料铸造渗透压力，提高了复合材料的强、韧性；研究了多种复合材料界面结构及形成机理，确定了增强体与基体之间的界面结合机制，分析了复合材料界面处的晶体学位向关系；最后制备了含微孔的中空型陶瓷颗粒增强的特种复合材料，得到了强度和阻尼综合性能较好的轻质复合材料。

In this dissertation, at first, the history and present situation of the research related to overheating is reviewed, and then the research works are carried out in following aspects the calculation of radiative properties of coal combustion, the solution of radiative transfer equation in absorbing-scattering media, the analyses of combined heat transfer processes in flue side, the computation method of steam temperature deviation of superheaters and reheaters and the inversion method of their wall metallic temperature in furnace, the numerical simulation of gas-solid two-phase flow, combustion and heat transfer in furnace, the measurement of outlet steam temperature of superheaters and reheaters, engineering reformation of overheating and optimum design of superheaters and reheaters, etc.

本文在综述了与过热器和再热器超温问题有关的研究历史与现状的基础上，在煤粉燃烧产物辐射特性的计算、含散射问题的辐射传递方程的求解、过热器和再热器烟气侧对流与辐射复合换热及汽温偏差的计算和炉内金属壁温的反演、炉内气固两相流动、燃烧、传热过程的数值模拟、过热器再热器炉外出口汽温的测量、过热器再热器超温问题的工程改造及设备的优化设计等方面进行了研究。

Generally the catalysts have high activity and good selectivity. At present the coupling reactions of organoborahes with terminal olefins s acid chlorides and aryl halides play an important synthetic approaches in organoborane chemical. The catalysts can be used by many kinds of organometal compounds such as: irons cobalt nickel ruthenium rhodium palladiums titaniums zirconiums tins indium and lithium organic compounds; The achievement has been amazed in preparing of unsaturated or saturated compounds and in synthesizing of natural products bioactive molecules and chiral compounds.

目前，卤代烃与不饱和烃的偶联反应和有机硼试剂与酰卤和卤代烃的偶联反应已成为有机合成的研究热点，此类反应可用铁、钴、镍、钌、铑、钛、锆、锡、铟、锂等多种有机金属化合物来催化，用于形成含饱和或不饱和C-C键的化合物，并已在天然产物、液晶、具有生理活性物质和手性化合物的合成中应用。

Iron and steel materials to apply a wide range of reasons, first of all, the ingredients can be used to span, and from close to non-carbon content of pure iron to about 4% of cast iron, alloy, in this context, the phase structure and microstructure are great change; In addition, a variety of thermal processing is to process, in particular, metal heat treatment technology, a substantial change in composition and properties of alloys.

钢铁材料适用范围广阔的原因，首先在于可用的成分跨度大，从近于无碳的工业纯铁到含碳4％左右的铸铁，在此范围内合金的相结构和微观组织都发生很大的变化；另外，还在于可采用各种热加工工艺，尤其金属热处理技术，大幅度地改变某一成分合金的组织和性能。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。