向轴的

End-suction centrifugal pumps, rating 10 bar with bearing bracket - Nominal duty point, main dimensions, designation system; German version EN

带轴承座和 PN10轴向端口的离心泵。额定功率。主要尺寸。标识系统

It is suggested that the axial location clearance of bearing outer ring should be minimized provided the assembly reliability can be reached.

对於采用卡环定位轮毂轴承，在满足可靠装配条件下，应尽可能减小轴向的配合间隙。

It is suggested that the axial location clearance of bearing outer ring should be minimized provided the assembly reliability can be reached.

对于采用卡环定位轮毂轴承，在满足可靠装配条件下，应尽可能减小轴向的配合间隙。

Now, to make everything movable I am going to include two shafts that the bottom plate slide up and down on thus moving the scopes.

现在，让一切动产我要包括两轴，该底板投影片向上和向下移动，从而对的范围。

Actually, downhole casing is cemented at its bottom, and fastened by casing head at its top, so the axial tension caused by internal pressure does is not loaded by the casing, instead, by well bottom and the casing head, etc..

实际井下套管下端被水泥固定，上端被套管头固定，此时套管承受内压所产生的轴向拉力，并不作用在套管上，而作用在井底和上端约束上。

A bar or cylinder in the arm of a crank to which a reciprocating member or connecting rod is attached.

传动杆可摆动的杠杆，与引擎之活塞相连，用以向机轴传送能量

The product that is form a complete set of east wind commercial vehicle basically has assembly of gimbal cross axle, rain to blow implement bearing of car of assembly of assembly, a powerful person of apply the bra......

为东风商用车匹配的制品主要有万向节拾字轴总成、雨刮器总成、制动阀总成、吃重轿车轴承等。据晓，自1997年以来，万向钱潮已经接连着8年被东风轿车评为年度杰岀供给商。

The single factor orthogonal turn-milling experiments have been done. The influence rule of cutting speed vc and axial feed fa on residual stress of workpiece surface was researched and analyzed theoretically, when orthogonal turn-milling was done on steel 65#.

通过单因素正交车铣残余应力实验，研究了车铣加工65#钢时，分别改变切削速度vc和轴向进给量fa两个切削用量对已加工件表面残余应力的影响规律，并进行了理论分析。

The potential measurement method is compared with the displacement current method.

针对微型ECT传感器受限于应用场合，电极轴向长度过短的实用局限，提出采用电势测量方法。

An oscillating lever connected to an engine piston rod and used to transmit power to the crankshaft.

可摆动的杠杆，与引擎之活塞相连，用以向机轴传送能量。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。