向轴的

The construction principle of analytical balance style instrument about measuring the center of mass on axial direction and the adjustment method of its sensitivity are described.

本文介绍了天平式轴向质心仪的结构原理及其灵敏度的调整方法；说明了构件轴向质心位置的测量方法及其误差分析。

They are axially guided by the axial sliding areas of the cage or by the lips of machined bearing rings.

它们通过保持架的轴向滑动区或加工过的轴承圈挡边轴向的引导。

Based on Chen's model about axial flow induced vibration of a rod bundle in an unbounded domain, a mathematical model concemed with circular domain is presented, and the expressions for fluid forces are given in detail.

三、基于Chen关于无界域轴向流动中棒束流致振动的模型，推导了有界域棒束轴向流致振动的数学模型，得到了关于流体力的表达式。

The simulation floating zone modelwith zero temperature gradient in the middle of the hot rod is proposed to simulate thehalf part of the full floating zone convection,since the temperature gradient in the middleof a full floating zone approaches zero.

根据加热方式的不同，可以将半浮区液桥分为通常半浮区液桥模型、模拟半浮区模型以及改型半浮区模型。通常半浮区液桥模型，液桥热端材料一般选择为金属材料，使得热端温度分布均匀。液桥产生热毛细对流时，在液桥热端内侧存在较大的轴向温度梯度。而在全浮区热毛细对流中，浮区中间的轴向温度梯度在对称条件下应该接近于零。

Because of the particularity of claw pole structure, the axial magnetic field produced by the stator winding is transformed into the diametric one along the circle of air gap.

当定子绕组通电时，电机中产生轴向磁通，爪极的作用就是将定子绕组产生的轴向磁场转化为沿气隙圆周径向排列的磁场，同时将 1对极转化为 P对极[1] 。

Based on rubbing model of a two-disk rotor-stator system with consideration of both rotor and stator dynamics,a numerical integration program is applied to numerical simulation and analysis of the nonlinear dynamics of this system,such as bifurcation,Poincare section map,trajectory of axes,phase trajectory,frequency spectrum diagram and time response.

基于一新型径向-轴向复合碰摩双盘转子-机匣力学模型，利用数值积分和Poincare映射方法，对转子-机匣系统由于径向-轴向碰摩故障导致的非线性动力学行为进行了数值仿真研究，给出了系统响应随转速和偏心量变化的分岔图和一些典型的Poincare截面图、相轨图、轴心轨迹、幅值谱图和时域响应等。

Effects of the downhole temperature on axial vibration natural frequency of drill string in deep wells is investigated.

分析了井下温度对钻柱轴向振动固有频率的影响，推导出了井下任意温度时钻柱轴向振动固有频率的计算公式。

Along the axis within 2 cm, a hollow gas shell structure is formed.

估算结果为：在轴向2.5~40 mm，径向0~15 mm的区域内，气体分子密度基本在10^16~10^17/立方公分，且在轴向2 cm内基本形成空心的气体壳层结构。

Because of special geometry structure of three-cone bit, the top of formation will form a tri-spine well bottom while drilling with three-cone bit the drill string. It is the tri-spine well bottom that leads to the axial harmonic of vibration when the bit revolves a round and the three concavo-convex heave of bit and formation result in one time (1×rpm),two time (2×rpm), three time (3×rpm) turning table speed.

高岩由于三牙轮钻头的特殊几何结构，钻进过程中在岩层顶部容易形成一个三脊状井底，正是这一三脊状井底，当钻头旋转一周时钻柱轴向三次凸凹变化，由此在轴向产生1倍、2倍和3倍及其更高次倍于转盘转速rpm的谐波振动。

Because of special geometry structure of three-cone bit, the top of formation will form a tri-spine well bottom while drilling with three-cone bit the drill string. It is the tri-spine well bottom that leads to the axial harmonic of vibration when the bit revolves a round and the three concavo-convex heave of bit and formation result in one time (1×rpm),two time (2×rpm), three time (3×rpm) turning table speed.

高岩摘要：由于三牙轮钻头的特殊几何结构，钻进过程中在岩层顶部容易形成一个三脊状井底，正是这一三脊状井底，当钻头旋转一周时钻柱轴向三次凸凹变化，由此在轴向产生1倍、2倍和3倍及其更高次倍于转盘转速rpm的谐波振动。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。