向轴的

From energy balanceequation, using micropiece analytical method, heat balance equation for high power fastaxial gas flow CO2 laser tube is established.

从能量守恒定律出发，分析了快速轴向流动激光器放电管中的传热情况。采用微元分析法建立了快速轴向流动激光器放电管的热能平衡方程。

In the thesis, it was shown that the latitude variation of the angular dispersion should mainly depend on square sum of lower degree deduced Gaussian coefficients if the non-axial-dipole component vs. the axial-dipole component is small.

本文证明，如果地磁场非轴向偶极子分量相对轴向偶极子分量为小量，那么VGP角散布的纬度变化主要由低阶约化Gauss系数的平方和决定。

This paper takes the cylindrical boult of the 40 flour mills as the object of study,establishes the corresponding mechanics model ,connects theory to reality,designs the nut conicity,then uses the same conicity offsetting poor alignment between the nut and the cylindrical boult,decomposes reinforcingsteel radia.

以40型面粉机圆筒筛为研究对象，建立相应的力学模型，通过理论结合实际，设计螺母锥度，在螺母与圆筒筛之间采用同锥度错位配合，将钢筋的径向受力通过锥面分解到钢筋轴向一部分，使得钢筋在轴向和径向都保持尽可能小地受力。

The dynamic equations were derived for the vehicle-bridge coupled system with an axial force of bridge based on D Alembert's principle and the assumed mode method. The numerical results were obtained by Newmark-β method. Dynamic responses of the system caused by axial forces of bridge and speed of vehicle were discussed respectively.

应用达朗贝尔原理和振型分解法，建立了在桥梁轴向力作用下车-桥系统的动力学方程，利用Newmark-β方法，对车桥耦合问题进行数值求解，比较分析了桥梁轴向力、车速等对系统动力学响应的影响。

The stability of the n director around the grooves was studied. In one-constant model for each director, the rude condition is that the elastic constant of the n director is the maximum.

研究了双轴向列相液晶在表面沟槽上锚定的稳定性问题；稳定性条件在双轴向列相单一弹性常数近似下为n指向矢的弹性常数最大。

Theobserved strain is 10~2 times as local point strain at the same observed stress.This indicates that macroscopical symmetrical rock is quasi-brittle materialwith microcosmic heterogeneousness and its macroscopical mechanicalbehavior is the results of reciprocity and magnification between microcosmiccharacteristic, not simple sum.(4) The degree of irregularity of strain increases with the number of cycle.But degree of irregularity of transverse strain fluctuates larger at the samecycle. Moreover degree of irregularity of transverse strain is larger than that ofaxial strain. This shows that deformation and failure of rock is process ofevolvement of small crack. Small crack evolves from even and out-of-orderstatus to heterogeneous and ordinal status.(5) Ultrasonic speed decreases with the number of cycle. The decreasecourse is such: Firstly, ultrasonic speed fluctuates in a steady scope in somecycles; And then ultrasonic speed quickly decreases to a certain more smallvalue; Afterwards in succedent cycles, ultrasonic speed fluctuates about thevalue. That is to say, ultrasonic speed fluctuates and decreases at intervals ofcycles. In deformation process of rock, quantitative change and qualitativechange of its small crack evolvement carry through crosswise.(6) Strength and modulus of rock decrease with exponential function asscale of specimens increases.

同一表观应力下，局部点应变与表观应变相差可达2个数量级，表明宏观上均匀的岩石是具有细观特征的准脆性材料，其宏观力学行为是细观特征相互作用、放大的综合结果，而不是简单的叠加；(4)岩样轴向应变不均匀程度和横向应变不均匀程度随循环次数的增加渐进增大，但是在同一个循环内，横向应变离散系数随应力的变化波动较大，且同一循环级别下，横向应变不均匀程度大于轴向应变不均匀程度，表明岩石内部微裂纹的演化是岩石变形破坏的本质特征，这一演化表现为微裂纹从均匀无序分布逐渐向非均匀有序发展；(5)随循环次数的增加，所有岩样内部超声波速会出现衰减，衰减过程表现为在某几次循环内超声波速在某一相对范围内波动，然后急剧减小到某一较小值，在随后的循环内，超声波速又会保持在这一较小值附近波动，即超声波速表现为波动和急剧减小间隔形式衰减，表明从宏观看来平稳的岩石变形过程，内部结构演化过程(微裂纹发展及其相互作用)却表现为均匀量变和突发质变不断交叉进行的现象；(6)岩石强度和弹性模量随尺度增大呈指数函数规律减小。

The average correlative coefficients of linear regression function for isochronous stress- axial strain curve are 3.92% higher than that of average correlative coefficients of linear regression function for isochronous stress- radial strain curve, so nonlinear creep property of the fine sandstone specimen in axial direction is correspondingly weaker than that in radial direction.

应力－轴向应变等时曲线线性回归函数的平均相关系数高出应力－径向应变等时曲线线性回归函数的平均相关系数3.92%，因此其轴向非线性蠕变特性相对于径向非线性蠕变特性更弱。

A large number of real data about axial load, axial displacement and vibration character istics of roll system are obtained.

轴向动载荷系数的确定为合理地分析轴向力对轧辊轴承的作用提供了依据。

The wood structures of Lauraceae were characterized by most diffuse porous; most pores solitary, less multiple and cluster pores; simple and scalariform perforation with few bars; most solitary pore; alternate intervessel pitting; most of rays multiseriate, less uniseriate; all of rays heterogeneous, mostly heterogeneous Ⅲ and Ⅱ type rays; most of axial parenchyma paratracheal type, less banded or marginal type; oil cell and mucilage cell in axial parenchyma cell or ray cell; mostly fiber tracheid and libriform fiber, less septate fiber.

结果表明：除檫木外，其它木材的管孔分布均为散孔材，具较高的单孔率；导管分子穿孔板兼有单穿孔和梯状穿孔2种或者仅具有单穿孔；导管间纹孔式为互列；导管－射线间纹孔式类型丰富，主要为刻痕状和大圆状。木射线有单列和多列射线2种类型，单列射线稀少、短，多列射线数量多；射线组织主要为异形Ⅲ和异形Ⅱ；轴向薄壁组织以傍管状为主，少数有带状或轮界状。油细胞和粘液细胞普遍存在于射线薄壁细胞或轴向薄壁细胞中。木纤维由韧性纤维和纤维管胞组成，部分树种具分隔纤维。

The results show that the growth rate of tetrapod ZnO is controlled by spiral growth and its crystallization is via VLS model. The condensation of tiny zinc droplets in zinc vapor is the key factor of the formation of tetrapod ZnO. The growth steps are formed on the terminated faces as zinc diffuses outwards and the elongation of whiskers continues until zinc inside the droplets is depleted. VS crystallization, which has little effect on the elongation growth, takes place on side faces of the whiskers and consequently makes the whiskers radius increase.

结果表明： T-ZnO晶须的结晶作用是气-液-固方式，晶须生长受螺旋生长机理控制；锌蒸气中产生凝聚生长的锌液滴是制备T-ZnO晶须的关键，锌从液滴内向外扩散在晶须的端面产生生长台阶，随着液滴内的原子向外不断扩散，针体部分就不断地伸长生长，当液滴内的原子全部消耗尽时，晶须便不再发生轴向生长；气-固方式的作用主要是促进晶须棱面生长而使晶须变粗，对轴向生长几乎没有影响。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。