向后倾斜的

The results show that the microstructure of ventra1 scale for python was composed of micro-convex and plank structure that was periodically arranged, it was mensurable and could be described by 9 characteristic parameters. Its surface was different in their forward and backward lean angle. The frictional coefficient of the ventra1 scale had closely relationship with moving direction, it decreased with the increasing load. The value of the frictional coefficient was about 0.07. The frictional coefficient while python moved backward and laterally were equal, and that was 33% more than that moved ahead. The frictional force of the ventra1 scale surface was caused by mechanical tooth function of micro-convex, acting intermolecular force and material's elastic hysteresis. The difference of forward and behind bevel for micro-convex was the anisotropy reason of frictional force.

结果表明：腹鳞表面的微观结构由指状微突体和板结构部分周期排列而成，其结构可用9个特征参数定量描述；腹鳞表面摩擦力由分子作用力、表面微突体的犁沟力、楔形作用力以及材料弹性滞后共同引起；腹鳞表面的摩擦系数在0.07左右并与运动方向有关，摩擦系数随载荷增加而减小；后向运动及左、右侧向运动时摩擦系数基本相等，比前向运动时高33%左右；腹鳞表面微突体不同方向上倾斜角度的差异是引起摩擦各向异性的主要原因。

TO eliminate error caused by the rod being tipped forward or backward, the rodman waves the rod ,or tilts it slowly forward and backward,and the leveler takes the least reading. For less precise leveling, as when rod rcadings for ground points are determined to the nearest 0.1 ft, usually less care is exercised in keeping the bubble centered and the rod vertical,and the observations are no checked.

为了消除所造成的误差棒正在向前或向后，在罗德曼波杆，或倾斜，慢慢前进，后退，和矫直需要至少不到精密水准，如棒为确定地面点到最近的0.1英尺，通常较少照顾行使维持泡沫中心和棒垂直，没有检查。

Finally they had ended back at the tank, Joe straddling the ladder and Katze leaning against it.

最后他们已经在槽向后地结束，跨立对抗它的梯和 Katze 倾斜的乔。

The screw entry point was located at the tip of transverse process. The average inclination angle should be 10°-20° headward and 30°-40° toward neutral line respectively. The screw was inserted and entered into the vertebral body along the external cortex of pedicle. The integrity of cortical bone around screws, the distance to segmental blood vessels and the penetration of cortex were observed after operation to evaluate the accuracy and safety of screw placement. Among 160 thoracic pedicle screws that were implanted in 34 cases, 148 screws (92.5%) were accurately inserted inside the costotransverse unit, and 12 screws (7.5%) were misplaced according to the image of X-ray and CT thin-slice scan.

应用椎弓根外内固定技术2004/2007年在中山大学附属第三医院骨科治疗34例患者，固定前采用CT加密扫描测量进钉点、进钉点至椎体前缘的深度、进钉角度和直径，固定中椎弓根钉入点为横突尖，进钉方向为平均向头侧倾斜10°~ 20°、与中线成角30°~40°，顺椎弓根外侧皮质进入椎体，固定后CT加密扫描观察螺钉周围的皮质骨是否完整、是否靠近节段血管、是否穿透皮质骨，评价置入钉的准确性和安全性。34例患者共置入160枚胸椎椎弓根螺钉，固定后CT加密扫描和X射线片观察到148枚(92.5%)螺钉置入准确，12枚(7.5%)螺钉发生错置。

By analyzing in detail the structural evolutionary history, from Mesozoic to Cenozoic, of different rift belts in western, northern, central and eastern Africa, the authors think that the Mellit area was on the northwestern shoulder of the South Sudan Rift. The rotation of the Mellit block toward northwest was the outward rotation of the northwestern shoulder of the South Sudan Rift during the rifting phase, and the rotation toward southeast was the inward rotation of the rift shoulder during the post-rift thermal sag episode.

经过详细分析非洲大陆西部、北部、中部和东部中新生代裂谷带的构造演化史后发现：Mellit地块实际上位于南苏丹裂谷带的西北裂谷肩上，该地块自晚白垩世初期至中新世初期，向NW方向倾斜是南苏丹裂谷带于裂谷化阶段造成的裂谷肩块体的向外旋转；该地块自中新世以来向SE方向倾斜是南苏丹裂谷带在后裂谷热沉降阶段造成的裂谷肩块体的向内旋转。

Upper and lower incisor both had controlled tipping movement. The crown of incisor moved mesially and had root apex were fixed relatively. The center of rotation was close to root apex. The upper and lower molar moved differently.

结果：唇挡治疗后，SNA、SNB分别增加1.02°和0.97°(P.05)，上下切牙前移均是牙冠向近中倾斜，而根尖相对固定的控制性倾斜，旋转中心接近根尖。

The results of this study indicate that changing the angle of the intake port has a profound effect on the flow field during the intake stroke of the engine cycle. For the case with the intake-exhaust valves canted at zero degree (the so-called vertical valves), the tumble ratio, swirl ratio, turbulent intensity, and turbulent kinetic energy in the direction perpendicular to the bisecting plane of the cylinder are at their highest levels than those obtained for the other cases. This effect is most pronounced after the compression stroke of the cycle. As a result of this study, it is observed that the behavior of the overall flow field from the intake to the completion of compression stroke has a major impact on the effectiveness of the mixing of fuel-air prior to the ignition of the engine cycle.

结果显示，改变进排气阀的倾斜角度对进气期间的流场变化有很明显的影响，其中以垂直阀(进排气阀倾斜0度)所得的 Y轴向(Y方向系垂直於将汽缸对分为二平面的方向)滚流强度、涡漩比、紊流强度、紊流动能等流场强度为最强；若以流体经活塞压缩后的流场特性进行探讨，所得结果显示压缩冲程对汽缸内流场的效应是不容忽视的；因此由进气到压缩过程结束的整体流场现象，才是影响引擎点火前的油气混合程度与燃烧品质的关键。

Place short and long food chips in posterior occlusion of unilateral left side. When the masticated load was 3、5、7 kg, the displacement of abutments was measured by a LB-high sensitive laser transferring detector to calculate displacement, inclination and torsion of the abutment in mesial-distal, labial lingual and vertical and horizontal directions.

分别在左侧后牙区放置长、短食物片的咬合状态下，负载3 kg、5 kg、7 kg咬合力时，用高精度半导体激光位移测量仪测量并计算出同侧基牙在近远中向、颊舌向的水平位移和倾斜、垂直向的位移和水平旋转，统计分析不同牙尖斜度对基牙位移的影响。

Moving a stick 8 forward or backward, or to either side, tilts the vertical shaft 41 in the same direction.

移动坚持8向前或向后，或任何一方倾斜的竖井41个在同一方向。

Sitting on a leg extension machine with your feet under the footpads, lean back slightly, and lift the pads with your feet until your legs are extended.

坐在腿部伸展器上，双脚置于挡板下，向后稍稍倾斜，然后用你的双脚抬起踏板直到双腿伸直。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。