后表面

This machine has a highly polish ed large diameter drying cylinder which burnishes the surface in contact to give a high glaze; the underside of the paper is rough.

这机器有一个大直径，表面极度光滑的烘缸。纸面和它接触后，被磨平光滑；纸底则粗糙。

Results The surface microhardness was enhanced distinctively after the treatment with calcifying solution.

低浓度氟化物溶液和氟泡沫处理后釉质的表面硬度无明显改变。

The study result showed that the polyacrylate hydrolyzed and chelated metal ions by its carboxylic group and then,performed as a protection la...

研究结果表明，金属离子首先与聚合物的羧基络合，生成硫化物纳米微粒后，聚合物又包覆在纳米微粒的表面形成保护层。

Heat sintered ZrO_2 ceramic does not react with any acids and bases except HF. It can't be coarsened by the traditional pretreatment process. Through a great deal of experiments, author found a kind of coarsened prescription which can corrode ZrO_2 ceramic, forming many holes and troughs on its surface.

高温烧结后的ZrO_2陶瓷的化学稳定性很高，除HF外不溶于任何酸碱，传统的粗化液对它没有粗化作用，笔者通过大量的实验，找到了ZrO_2陶瓷粗化液的配方，它能在ZrO_2表面腐蚀出大量均匀的微坑和凹槽。

The coarsened long strip-like Cu6Sn5 with a length of more than 80μm growing from upper interface of IMC layer to solder matrix and its length of more than 80μm in the matrix are observed in the solder with 1.5wt-%Cu addition after thermal storage.

在含Cu量大於1.0 wt%时，会有金属间化合物Cu6Sn5在焊料内析出，大小随Cu量的增加而增大，当添加量达最高的1.5 wt% Cu时，焊料在长时间热储存后，从焊料/Cu界面的IMC层上表面向焊料成长的Cu6Sn5长度超过80μm，而焊料内最长的甚至超过100μm。

The results showed that after the adding starch to the sheet, the viscosity of the PVA solution increased, the dissolution time of the sheet got longer, the rate of enlargement in water was smaller, the rate of moisture became smaller, stretch intensity enhanced and the change of shape diminished; also it could be seen from the surface of sheet that the starch existed in PVA sheet as the shape of conglomerating particle.

结果表明，加入淀粉后，PVA溶液的粘度增大，膜的溶解时间变长，水上伸长率变小，含水率变小，扯断强度增强，形变缩小；通过膜表面观察，发现淀粉在膜中以聚集颗粒状态存在。

The thickness of the alloying layer is 80μm in the decarbonizing and then surface alloying, but only 15μm in the surface alloying directly. The content of cobalt which doesn't form carbide doesn't have a great difference in two processes, but that of tungsten and molybdenum make a great difference.

在两种渗金属条件下，表面合金层的非碳化物形成元素Co含量差别不是很大，而强碳化物形成元素W和Mo的含量却有着显著差异，直接渗金属的，表层W和Mo含量几乎为零，而脱碳后渗金属的，表层W和Mo总量最大达到6%左右。

SEM and FTIR were used to characterize the morphology and chemical composition of the degummed fibers.

用FTIR、SEM对联合脱胶后大麻的表面形态结构和化学成分进行分析。

The anisotropic bonded NdFeB magnets were prepared by die-upsetting process and the effect of surface residual magnetization of anisotropic bonded magnets which were demagnetized by alternating current demagnetization and heat demagnetization process on the quantity of magnetic powder attracted on the surface was investigated.

采用模压成型方法制备各向异性粘结NdFeB 磁体，并研究了其经交流退磁及热退磁后磁体的表面剩磁大小对磁粉吸附程度的影响。

The purpose of the study was to evaluate quantitatively PDLC attachment and proliferation to periodontally diseased human cementum and dentin after demineralizing with minocycline- HCl and EDTA.

以往关于用四环素族药物处理根面的研究，均是以牙本质为载体，而临床上牙周手术后与牙周膜细胞接触的界面主要是牙骨质表面。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。