后柱

In order to understand the degree of simulation produced by exercise loads subjected to li zhu-hong during sub highland training to his body, and to grasp sub highland training patterns, the authors tracked and tested conventional uric indexes and some biochemical indexes of li zhu-hong at different training load stages during sub highland training, and revealed the following findings: different exercise loads and intensities have no significant effect on the number of red blood cells; training with high exercise intensities can increase the levels of serum urea nitrogen and creatine kinase, and significantly increase the percentages of testosterone and cortisol, which recovered their normal levels after exercising; there is no significant change in specific gravity of urine, acetone body, nitrite and white blood cells before and after exercise loads; the levels of urine protein, occult blood, bilirubin and urine bladder essence increase after exercising.

马拉松运动员李柱宏为了备战北京奥运会，在海拔1 750 m的兰州愉中亚高原进行了为期4周的针对性训练，为了解李柱宏在亚高原训练中运动负荷对机体的刺激程度，掌握亚高原运动训练的规律，对李柱宏在亚高原不同训练负荷阶段尿常规指标和部分生化指标进行了跟踪检测，结果发现：不同运动负荷和强度对红细胞数无显著影响，大运动量训练可使血清尿素氮和肌酸激酶水平升高，睾酮和皮质醇比例明显升高，运动后恢复正常；运动负荷前后尿比重、酮体、亚硝酸盐及白细胞无显著变化；运动后尿蛋白、隐血、胆红素、尿胆元水平上升。

The conclusions were as follows: theνO-H andνC=O IR absorption maxima shifted towards higher wave numbers after imprinting 17β-estradiol on TFMAA-co-TRIM copolymer with the red shift of theνO-H groups being apparent after precipitation polymerization for 16h while that forνC=O groups being observed after polymerization for 24h. A strong interaction between TFMAA and 17β-estradiol was confirmed by the high selectivity for 17β-estradiol, as indicted by the values of the separation factor of isomers of 17β-estradiol/17α-estradiol (2.28) and the imprinted factor (3.01). Particle diameter of TFMAA-co-TRIM polymer was between 300 nm and 1.5μm, which suited well for solid phase sorbent throughout at low column pressure. The recognition of imprinting TFMAA-co-TRIM polymer for sterol molecules was driven by enthalpy eluted with acetronitile, and low temperature was in favor of the separation of sterol structure analogues on imprinting column. TFMAA-co-TRIM polymer possessed of determinate anti-heat stability, with melting point beginning at 255.84℃, Tp=257.40℃, control TFMAA-co-TRIM polymer and imprinting TFMAA-co-TRIM polymer were respectively decompounded at 267.79℃and 343.11℃, and solid micro-extraction noddle prepared by the special polymerization also showed definite recognition for 17β-estradiol by GC/MS detecting at 270℃. By selection of various washing and elution solvents, elution reagents of close polymerization system were of more advantage in template molecules retention and recognition on molecularly imprinted solid phase extraction column. At a certain extent, progesterone, 17α-estradiol, 17β-estradiol and 4-androstene-3, 17-dione could be intercepted on the MISPE column. Especially, MISPE had high selectivity for progesterone, and imprinting TFMAA-co-TRIM polymer could achieve adsorption balance within 50 min by absorption kinetics test for 17β-estradiol. However, MISPE column showed better selectivity and enrichment property for 17β-estradiol than C18 and CSPE columns according to the data from HPLC and GC/MS analyses. Recovery of 17β-estradiol on MISPE column was up to 85.5% while when prime extracting solution of milk powder was sampled, the recovery of CSPE and C18 columns were 43.7% and 30.7%, respectively.

通过研究阐明：紫外聚合产物TFMAA-co-TRIM中的νO-H振动吸收峰在聚合16h后红移，νC=O振动吸收峰在聚合24h后红移；TFMAA-co-TRIM对雌二醇异构体的印迹因子达到了3.01，α为2.28，优于其它功能单体参与得到的聚合物识别特性；TFMAA-co-TRIM聚合物粒径介于300 nm至1.5μm之间，作为色谱固定相具有良好的通量和低的柱压；在乙腈流动相中，TFMAA-co-TRIM分子印迹固定相的分离过程主要被焓驱动，低温有利于分子印迹固定相分离甾醇结构类似物；TFMAA-co-TRIM分子印迹聚合物在255.84℃时开始熔融，Tp=257.40℃，聚合物CP的降解温度在267.79℃，MIP降解温度在343.11℃，制备的固相微萃取头初步经GC/MS 270℃的耐热性测定；不同的洗提溶剂筛选证明了选择接近聚合溶剂的洗脱体系更有利于MISPE发挥识别效应；分子印迹固相萃取柱对孕酮、17α-雌二醇、17β-雌二醇和雄烯二酮都具有不同程度的保留特性，可作为此类化合物的吸附材料，特别对孕酮强保留的富集特性，可作为孕酮的选择性识别吸附剂，其分子印迹聚合物对17β-雌二醇的吸附动力学测定显示在50 min内基本达到吸附平衡，具有作为传感器核心敏感材料的潜力；对比萃取奶粉中17β-雌二醇性能，MISPE柱比非分子印迹固相萃取柱和C18柱具有更高的保留，回收率依次为85.5%，43.7%和30.7%。

Sixthly, research on seismic performance of repaired HSC column after hightemperatures The nonlinear whole process analysis method of reinforced concrete is used.Programs of moment-curvature and shear force-displacement of repaired HSCcolumn are developed after exposed to four sides and two symmetrical sides fire.Seismic performance of repaired reinforced HSC column after fire is studied. Byanalyzing the calculating results, the corresponding formulas of characteristicparameters of their skeleton curves of repaired HSC column after fire are proposed,and it is compared with corresponding curve of unfired columns.

火灾后已修复高强混凝土柱的抗震性能研究利用钢筋混凝土非线性全过程分析方法，编制了火灾后(包括四面受火和双面对称受火)已修复高强混凝土柱截面弯矩一曲率关系和剪力—位移关系的计算程序，对火灾后己修复高强混凝土柱的抗震性能进行了研究，通过对计算结果的分析和整理，给出了火灾后已修复高强混凝土柱M-φ及P-△骨架曲线特征参数的回归计算公式，并将上述曲线与未受火柱的相应曲线进行了比较。

The results indicate that the pillaring process and crystal growing of anatase can be more easily realized by increasing the acid-base ratio of pillaring agents, raising the pillaring temperature and adding proper quantities of alkali. The calcination of Ti-pillared precursor brings the growth of TiO2 grain, at the same time the layer distance is declined. In order to obtain ideal products, the right pillaring conditions are: the acid-base ratio of pillaring agents of 13, pillaring temperature of 65 ℃ and the volume of alkali (2 mol/L) in pillaring liquid of 6 mL.

结果表明：在一定范围内增大柱撑剂酸碱比、提高柱撑温度以及加入适量碱，有利于插层复合反应的进行和锐钛晶型的生长；柱撑前驱物焙烧后TiO2晶粒长大，同时焙烧引起的脱水导致膨润土层间距的下降；为获得较理想的产物，合适的柱化条件为：柱撑剂酸碱比 n n (HNO3)为13、柱撑温度65 ℃和柱撑液加碱量为(2 mol/L NaOH) 6 mL。

Prestressed Subassemblage concrete frame is assembled by precast prestressed beams and columns with tendons in the joints of the frames. These beams and columns are hoisted in site and the tendons are passed through the moire pipes. So prestressing force is brought to the joints of the frame.

预压装配式预应力混凝土框架是采用工厂化生产的预制柱和预制预应力梁，运至现场直接吊装，梁柱就位后，将后张预应力筋穿过梁柱预留孔道，对节点实施预应力张拉预压。

Subassemblage and Prestressed concrete frames are assembled by precast prestessed beams and columns with tendons in the joints of the frames. These beams and columns are hoisted in site and the tendons are passed through the moire pipes.

预压装配式预应力混凝土框架是采用工厂化生产的预制柱和预制预应力梁，运至现场直接吊装，梁柱就位后，将后张预应力筋穿过梁柱预留孔道，对节点实施预应力张拉预压。

1 Contrast unstrengthened square reinforced concrete column and 10 reinforced concrete columns strengthened by circular steel jacket were tested under axial loading .

为研究圆形钢套管加固混凝土柱的基本力学性能，进行了1根未加固的普通钢筋混凝土柱和10根圆形钢套管加固的混凝土短柱在不同加固钢套管厚度及初始轴压比下轴心受压试验，初始轴力通过对未加固试件施加后张预应力来进行模拟；在试验研究的基础上，根据应变协调原则对加固后构件轴压承载力进行了数值分析。

To study the basic mechanical performance of reinforced concrete column strengthened by circular steel jacket,a set of experimental work was carried out.1 contrast unstrengthened square reinforced concrete column and 10 reinforced concrete columns strengthened by circular steel jacket were tested under axial loading.

为研究圆形钢套管加固混凝土柱的基本力学性能，进行了1根未加固的普通钢筋混凝土柱和10根圆形钢套管加固的混凝土短柱在不同加固钢套管厚度及初始轴压比下轴心受压试验，初始轴力通过对未加固试件施加后张预应力来进行模拟；在试验研究的基础上，根据应变协调原则对加固后构件轴压承载力进行了数值分析。

When the protruding part of the cam switch over, the role of force in the spring, the plunger downward movement, the upper plunger space have a vacuum, when the plunger on the end to put the plunger into the After the open hole, filled with oil in the upper body inside pump diesel pump oil through hole into the room, plunger movement to the next stop point, the end into the oil.

当凸轮的凸起部分转过去后，在弹簧力的作用下，柱塞向下运动，柱塞上部空间产生真空度，当柱塞上端面把柱塞套上的进油孔打开后，充满在油泵上体油道内的柴油经油孔进入泵油室，柱塞运动到下止点，进油结束。

The UV and MS qualitative analysis of the eluates in different eluting time showed that the aromatics were basically separated by the Ag-SCX column according to the number of aromatics rings.

实验发现，流动相中的水含量直接影响Ag-SCX柱的活性，严格控制流动相中的含水量可将色谱柱的活性稳定在一定水平，失活后的色谱柱经1：1的苯／四氢呋喃冲洗几个小时后即可恢复其活性。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。