后循环的

Acceptance Criteria After Thermal Cycling, the lamp socket/circuit plate assembly shall meet the requirements of section: Voltage Drop.

6.2.3 。验收标准热循环后，灯泡插座/电路板组件应满足的要求：第压降。

Objective To investigate rule of change and significance of collagen Ⅰ、Ⅲ and the mechanism after blocking lymph of rabbit heart.

目的 观察兔心脏淋巴循环阻断后Ⅰ、Ⅲ型胶原蛋白变化的规律，并探讨其机制。

Methods Six patients underwent aortic reconstructions or partial aneurysm resections and one did hepatic cavernous hemangioma resection in general anesthesia. Cell saver was used for perioperative blood salvage and the washed blood was reinfused to all patients respectively during operation.

6例动脉瘤和1例肝血管瘤手术患者，在全身麻醉下行人造血管置换或动脉瘤部分切除术，在手术开始或体外循环结束时，启用全自动血液回收系统，回收术野的出血或渗血，进行浓缩、洗涤后，再回输入体内，并按回收-浓缩-洗涤-回输程序重复进行。

Effects of hydrogen reduction time, hydrogen content and redox circulation on C O oxidation activities of CuO-CoO/Al2O3 and CuO-Ce2O3/Al2O 3 combustion promotors were investigated.

对 CuO-CoO/Al2O3和 CuO-Ce2O3/Al2O3助燃剂受 H2还原时间、还原 H2 含量，以及多次还原-氧化循环处理后对 CO 氧化活性的影响在实验室进行了研究。

One cycle of operation to take Silo body construction, the construction procedure as follows: steel banding to Silo body gantry beams assembled below -→ one-time pouring concrete 700mm high -→ early slide three trips (that is 75mm high)-→ check off the concrete slipform system appropriate degree and working conditions -→ continue pouring concrete 500mm high -→ then slip trip or three -→ pouring concrete to template missing -→ normal sliding each slide or 500mm high -→ stratified cross - lap steel banding -→ pouring concrete 500mm high -→ Waterloo or 500mm high -→ 4 in accordance with the procedure after Silo body pouring until the completion of cycle.

其中筒身施工采取循环作业，其施工程序为：绑扎筒身钢筋至组装好的门架横梁下面—→一次性浇筑混凝土700mm 高—→初滑三个行程（即75mm 高度）—→检查滑出混凝土合适度及滑模系统工作状况—→继续浇筑混凝土500mm 高—→再滑升三个行程—→浇筑混凝土至模板上口—→转入正常滑升，每次滑升500mm 高—→分层交圈绑扎钢筋—→浇筑混凝土500mm 高—→滑升500mm 高—→按后四道程序循环往复直至筒身浇筑完成。

One cycle of operation to take construction, the construction procedure as follows: steel banding to gantry beams assembled below -→ one-time pouring concrete 700mm high -→ early slide three trips (that is 75mm high)-→ check off the concrete slipform system appropriate degree and working conditions -→ continue pouring concrete 500mm high -→ then slip trip or three -→ pouring concrete to template missing -→ normal sliding each slide or 500mm high -→ stratified cross - lap steel banding -→ pouring concrete 500mm high -→ Waterloo or 500mm high -→ 4 in accordance with the procedure after pouring until the completion of cycle.

其中筒身施工采取循环作业，其施工程序为：绑扎筒身钢筋至组装好的门架横梁下面—→一次性浇筑混凝土700mm 高—→初滑三个行程（即75mm 高度）—→检查滑出混凝土合适度及滑模系统工作状况—→继续浇筑混凝土500mm 高—→再滑升三个行程—→浇筑混凝土至模板上口—→转入正常滑升，每次滑升500mm 高—→分层交圈绑扎钢筋—→浇筑混凝土500mm 高—→滑升500mm 高—→按后四道程序循环往复直至筒身浇筑完成。

At the end of the trench after all the loops have been unrolled, unroll the remaining pipe (return pipe back along the trench to the start.

在战壕后，所有的循环（完已摊开，披其余管道返回到开始沿着壕沟。

Humidity of 90% and keep it for 1 hour. And then transfer it to the box of temperature of 60℃±2℃ and the relative

60℃±2℃的条件下保持1h(转移时间≤10s)，在两温度之间重复保持做32 个循环，结束后将电池置于常温下静

The influence of cyclic heat treatment on the life of punching and shearing dies made of carbon tool steel T8A was studied.

对碳素工具钢T8A采用循环热处理晶粒超细化后对冲裁模具寿命的影响进行了试验研究。

In addition there will be a part of compressor running metal end of the refrigerant itself contains a certain amount of impurities, as the refrigerant in the refrigeration system, circulation changes, which will plug into the expansion valve valve Bellows Seal Valves hole, into the compressor will nap, and scratching the cylinder.

另外压缩机运行后也会有一部分金属末，制冷剂本身也含有一定数量的杂质，随着制冷剂在制冷系统内循环变化，它们进入膨胀阀就会堵塞阀孔，进入压缩机就会拉毛和刮伤汽缸。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。