后孔

The results show that, when the fuel supply position is located at the forebody of cavity, the jet flow of fuel supply has certain damage to vortex, and when the fuel supply injection is located at the afterbody of cavity, the jet flow of fuel supply has no damage to vortex.

实验表明，供油位置在凹腔前体，油气掺混孔处的射流对涡有破坏，供油位置在凹腔后体，油气掺混孔处射流对涡没有破坏作用，在不考虑供油方式等因素的情况下，凹腔后体供油优于凹腔前体供油。

The hydraulic angle semi automatic product line is mainly used in punching and printing procedures of equilateral and inequilateral angles with their side length of 160 mm and smaller ones; leaves out lineation on angles and alinement when punching one by one; it only needs to input such parameters as the positions of each hole and of printing; put the angles to be processed on the pincer of the cart; then, automatic consecutive punching can be realized.

本液压角钢半自动生产线主要用于边长160mm及以下各种等边不等边角钢的冲孔及打字工序，省掉在角钢上逐一划线及冲孔时逐一对线的作业，只须按一定程序将各孔位置需打字位置等参数输入计算机，将所需加工角钢装在小车夹钳上后，即可实现自动连续冲孔。

Some of the liquid spills out through the capillary constantly with the rise of the temperature of the content. Wipe away the overflown liquid with a piece of filter paper at any time until the fluid does not overflow anymore. Remove the pycnometer from the water bath rapidly. Proceed as described under method (1), starting from the words "clean off any material on the outside with a piece of filter paper…".

取洁净、干燥并精密称定重量的比重瓶，装满供试品（温度应低于20°C或各品种项下规定的温度）后，插入中心有毛细孔的瓶塞，用滤纸将从塞孔溢出的液体擦干，置20°C（或各品种项下规定的温度）恒温水浴中，放置若干分钟，随着供试液温度的上升，过多的液体将不断从塞孔溢出，随时用滤纸将瓶塞顶端擦干，待液体不再由塞孔溢出，迅即将比重瓶自水浴中取出，照上述（1）法，自"再用滤纸将比重瓶的外面擦净"起，依法测定，即得。

Experiment shows that both the dry plate pressure drop and the wet plate pressure drop increase with the increase of the kinetic energy factor in plate hole but have no influence of the height of cap. The wet plate pressure drop linearly ascends as the clear liquid height increases. Liquid lift-up increases at first then decreases with the increasing of the kinetic energy factor in plate hole, increases with the clear liquid height increasing and the height of cap decreasing, but as the kinetic energy factor in plate hole increased, the influence of height of cap will gradually decreased.

实验表明干板压降、湿板压降均随板孔动能因子的增大而增大，不受罩体高度变化的影响，湿板压降随清液层高度的增大而增大，成正比关系；液体提升量随板孔动能因子的增大先增大后减小，随清液层高度的增大而增大，随罩体高度的增大而减小，但随板孔动能因子的增加，罩体高度的影响逐渐变小；漏液量随板孔动能因子的增大迅速减小，随清液层高度的增大而增大，但接近漏液点时清液层高度的影响不明显。

Pore structure analysis shows that micropores can be adjustably generated on the mesopore wall of mesoporous carbon by post activation at high temperature using KOH as an activating agent.

孔结构测试表明，采用KOH后活化法可以在介孔炭的孔壁上控制性地生成微孔。

The method comprises the steps of dipping and mixing the mipor asphaltic base globular active carbon prepared by the traditional method with an inorganic metal salt solution by a certain ration; heating under an inert atmosphere to 600 to 1200 DEG C at a temperature increasing rate of 1 to 20 DEG C/min for the secondary carbonization; using acid to wash off the remaining metal inside the carbonized material, so as to obtain the asphaltic base globular active carbon with a high mesoporous rate and narrow distribution of mesoporous spertures.

本发明提供了一种浸渍金属盐二次炭化制备中孔沥青基球形活性炭的方法，该方法是将传统方法制备得到的微孔沥青基球形活性炭按一定比例与无机金属盐溶液浸渍混合，然后在惰性气氛下以1～20℃/min的升温速率加热到600～1200℃下进行二次炭化，炭化料经酸洗除去内部残留的金属后，可制得中孔率较高、中孔孔径分布窄的沥青基球形活性炭。

Some of the liquid spills out through the capillary constantly with the rise of the temperature of the content. Wipe away the overflown liquid with a piece of filter paper at any time until the fluid does not overflow anymore. Remove the pycnometer from the water bath rapidly. Proceed as described under method (1), starting from the words "clean off any material on the outside with a piece of filter paper…".

取洁净、干燥并精密称定重量的比重瓶，装满供试品（温度应低于20°C或各品种项下规定的温度）后，插入中心有毛细孔的瓶塞，用滤纸将从塞孔溢出的液体擦干，置20°C（或各品种项下规定的温度）恒温水浴中，放置若干分钟，随着供试液温度的上升，过多的液体将不断从塞孔溢出，随时用滤纸将瓶塞顶端擦干，待液体不再由塞孔溢出，迅即将比重瓶自水浴中取出，照上述（1）法，自&再用滤纸将比重瓶的外面擦净&起，依法测定，即得。

Methods:The clinical data of 84 patients with renal cyst underwent retroperitoneal laparoscopic unroofing by three ports were analyzed retrospectively,and the method of directly expanding retroperitoneal space during laparoscopy with three ports was evaluated.

回顾分析我院为84例肾囊肿患者用三孔法行腹膜后腹腔镜肾囊肿去顶减压术的临床资料，并评价三孔法腹膜后腹腔镜手术中直接扩张后腹膜腔的方法。

An original Jarlan-type perforated wall breakwater consists of a perforated front wall, a solid back wall and a wave absorbing chamber between them. In practice, the Jarlan-type perforated breakwaters are usually constructed with perforated caissons.

Jarlan型开孔墙式防波堤的基本结构形式包括前开孔直立墙、后实体墙以及前后墙之间的消浪室，在工程应用中经常是将沉箱的前墙开孔，建成开孔沉箱式防波堤。

Durng the construction of continuous underground wall, after the hole is drilled by special drilling machine to set depth, grout is first pressed via the core tube of drilling rod to the hole, sealing device and the reinforced bar cage are then set in the hole, and concrete is finally deposited with the displaced grout is recovered.

本发明涉及一种地下连续墙的施工方法，用专用钻孔机钻孔，达到预定深度后，经钻杆内芯管向孔底压注水泥浆，直至浆面高于易塌孔位置，在注满水泥浆的槽孔中放置封口器，再放钢筋笼，从孔底开始灌注砼，同时由孔中回收被砼置换上来的水泥浆。

Lugalbanda was a god and shepherd king of Uruk where he was worshipped for over a thousand years.

Lugalbanda 是神和被崇拜了一千年多 Uruk古埃及喜克索王朝国王。

I am coming just now,' and went on perfuming himself with Hunut, then he came and sat.

我来只是现在，'歼灭战perfuming自己与胡努特，那麼，他来到和SAT 。