台面

Simulation results of the table a variety of movements, control the movements of each table will trigger a certain event.

模拟台面各种动作的结果，台面上每个控件的动作都会触发一定的事件。

Right : The kitchen table should be based on different regional design work different altitudes, such as washing area, the higher will be more comfortable position, and some water may increase 5CM; lower position will be better used, if the user likes to do pasta, then used to produce pasta at the control desk could be reduced 10CM.

RIGHT：厨房台面应尽可能根据不同的工作区域设计不同的高度，如洗涤区，位置较高时会比较舒适，水池可以调高5CM；而有些台面位置较低时会更好，如果使用者很喜欢做面点，那么常用来制作面点的操作台可以将高度降低10CM。

To tie the room together the existing Formica countertop was torn up and replaced with countertop to match the new countertop in the new space and on the island.

要栓屋子现有的胶木工作台面一起撕毁并且用工作台面替换匹配新的工作台面在新的空间和在海岛。

After grinding the joint sides, use knife to remove the marks made by pencil. Then, mix the glue with the hardener. According to our experience, a half-cup of glue should be mixed with hardener of half spoon. Then, properly mix them.

对接台面打磨好后，先用刀片刮去铅笔的痕迹，再调配胶水、固化剂（根据经验一般是半纸杯台面胶水加上半矿泉水盖固化水，然后搅拌均匀。

The results of simulation make clear that the platform is incapable of colliding knightheads, and the variation rate of length of tightwire to obliquity of platform comes near to linearity, when the obliquity of platform varies form 0° to 300°.

仿真结果表明，台面倾角在0°～300°变化时，台面不碰撞立柱，且柔索伸缩长度与台面倾斜角度接近于线性变化。

The invention concerns an artificial block comprising a central core (1) having first (11) and second (12) opposite surfaces each provided with an anvil-shaped side leg (21, 22) with a table (21A, 22A), two sloping sides (21E, 21G; 22E, 22G) and two side surfaces (21B, 21C; 22B, 22C), the tables of said side legs being arranged parallel to said first and second opposite surfaces of the core, the inclined sides of said side legs resting on third (13) and fourth (14) exposed opposite surfaces of said core, said core having fifth (15) and sixth (16) surfaces each provided with side legs and front legs shaped like a truncated pyramid with four side surfaces and one front surface (33) parallel to said fifth and sixth surfaces of the core and to the side surfaces of the side legs.

一种保护层块料，包括一个中心核体(1)，有相对的第一面(11)及第二面(12)，每一面上各有一个砧状侧凸起(21，22)，这两个侧凸起各有一个台面(21A；22A)、两个斜面(21E，21G；22E，22G)和两个侧面(21B，21C；22B，22C)，所述台面相互平行，而且平行于所述中心核体的相对的第一面及第二面，所述侧凸起的斜面支撑于所述核体的相对的可见的第三(13)和第四面(14)。所述核体还有相对的第五(15)和第六面(16)，其上各有一个锥台状的前凸起，该前凸起有四个侧面和一个前表面(33)，该前表面平行于所述核体的第五和第六面，还平行于侧凸起的侧面。

Fair play"... It was typical that Baldwin should have resigned in 1929, although the elections gave no party a majority, on the ground that it would have been "unsporting not to have done so.

陈水扁的死皮赖脸决不会发生在英国，因为这里的政客台面下再不要脸，台面上还是要讲究一些"体育精神"的。

Kenneth was good friends with the homeowners, and replaced the countertop with a glossier, but much more functional, intact Carrara marble.

设计师肯尼斯与房主是好朋友，他用表面光滑带有鲜艳图案的台面来取代原来厨房的工作台面，这样的设计有更多的实用性，保护大理石的工作台面不受损伤。

Adjustment of the countertop with the seams of the wall: when the benchmark side of the countertop joints with the jointing side, in case the clearance between splash back of the countertop and the wall is larger than 5MM, use the following method to adjust.

台面与墙面缝隙的调整：接驳台面基准边与对接边合拢后，对于非直角墙体，如台面挡水与墙体面缝隙超过5MM，我们可以通过下面的方法调整，将两块台面紧靠墙，将两块台面的后挡水边靠拢在一起，这时两块台面的前端有间隙，就用卷尺测量前端间隙的尺寸，在后挡水处按间隙尺寸做标记，连接前端点和后面的标记划线。

Adjustment of the countertop with the seams of the wall: when the benchmark side of the countertop joints with the jointing side, in case the clearance between splash back of the countertop and the wall is larger than 5MM, use the following method to adjust. Place the two countertops tightly against thewall and put the two splashes back together. In this way, the two countertops will have clearance at the front side. Measure the clearance of the front and mark the clearance dimensions at the splash back. Mark along the front end and marks at splash back. Cut along the line.

台面与墙面缝隙的调整：接驳台面基准边与对接边合拢后，对于非直角墙体，如台面挡水与墙体面缝隙超过5MM，我们可以通过下面的方法调整，将两块台面紧靠墙，将两块台面的后挡水边靠拢在一起，这时两块台面的前端有间隙，就用卷尺测量前端间隙的尺寸，在后挡水处按间隙尺寸做标记，连接前端点和后面的标记划线。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。