台架

Andrea—Novel et al(1989),using the wave equation,derived a planar model for a gantry crane around the payload equilibrium position,which ignores the inertia of the payload and thinks of the cable as a perfectly flexible inextensible body.S.

安德里亚-小说的以及其他人(1989)，使用波相等，为起重台架在负载量平衡位置，不理睬负载量的惯性，而且想到作为一个非常有柔性的 inextensible 身体的电缆周围的起重机源自了一个平面的模型。S。

Through digital simulation, half-physical simulation test and real running on the engine test rig, it is veri...

通过数字仿真、半物理模拟及台架试车各阶段的实践，验证了系统结构、设计的正确性，为进一步开展全功能的数字控制的研究提供了实用的经验。

Around 1,300 workers were hired to assemble the tree, constructed from 410 tons of metal scaffolding supported by 11 barges.

这棵圣诞树是用410吨重的金属台架搭成的，整个组装工程动用了11艘驳船，雇佣了大约1300名工人。

With that model, the characteristic of the controllable damper can be worked out based on the characteristic curve of the vane damper and proportioning valve separately.

使得通过减振器的示功图曲线和比例阀的工作曲线，就可以得到可控减振器的特性曲线，大大减少了台架试验的次数。

In the process of experiment 13 transects had been selected.

搭建了叶片进给及转角的测试台架。

The formulation of JG3 synthetic automobile brake oil is explained. It is verified bytest that this product offers super vapour -- lock resistance under high temperature, good lowtemperature fluidity, corrosion resistance, and rubber gasket non -- solvency . The formula canmeet GB10380--89 standard and the bench tester requirement.

叙述了 JG3合成汽车制动液的配方研制过程，试验证明，该产品具有优良的高温抗气阻性、良好的低温流动性、抗腐蚀性，以及对橡胶皮碗的不溶胀性，该配方已达到GB10830—89标准及台架试验要求。

The preparative technique of solid lubricant is cold-press sintering method.The micro-structure , friction surface, lubricant transfer film surface of base material was characterized by SEM; XRD was used to do phase analysis. The degrees of crystallinity of pure PTFE under the different conditions of water cooling, air cooling and furnace-varying cooling were made comparison by XRD. The thermal stability of pure PTFE and solid lubricant was analyzed by DSC-TG; The composition and valence state of elements in the surface of carbon fiber ,solid lubricant before and after friction test and lubricant transfer film were characterized by XPS; The frictional property of solid lubricant was tested by pin and disk test rig .

用SEM表征原料微观结构、摩擦表面及润滑转移膜表面形貌：用XRD进行原料物相分析，及比较水冷却、空气冷却、随炉冷却三种工艺条件下的纯聚四氟乙烯树脂的结晶度；用DSC-TG分析纯聚四氟乙烯树脂及固体润滑剂的热稳定性；用XPS表征碳纤维表面、固体润滑剂摩擦前后表面、润滑转移膜表面的元素组成、价态变化；用销盘式摩擦磨损试验机对固体润滑剂进行摩擦性能测试；采用专用的台架模拟试验机对固体润滑剂镶嵌轴承套与钢轴摩擦副间的摩擦磨损性能进行测定；用莱次偏光显微镜测试固体润滑剂的硬度；用材料试验机测试固体润滑剂的抗压强度等。

The running-in process of the cylinder bore and piston ring of a reciprocation engine has been studied in detail based upon the experiment.

利用真实工况条件下的内燃机台架磨合试验，本文首先对内燃机缸套与活塞环的磨合过程进行了分析研究。

The laboratory based closed cycle diesel test rig was built based on the previous CO_2 experimental research.

在前期CO2 实验研究的基础上，完成了闭式循环柴油机氧气配比、开闭式转换和可视化状态监控系统的设计与实现，在实验室中建立了闭式循环柴油机及其监控系统实验台架，并成功实现了柴油机的闭式循环。

A test-rig for closed cycle diesel oxygen replenishment is developed and the emphasis is focused upon the experimental research on the feedforward compensation for oxygen control.

本文叙述了闭式循环柴油机配氧及监控实验台架，着重进行了前馈控制策略的实验研究。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。