可选择的

We have a wide variety of patterns to choose from.

我们有种类繁多的团可供选择。

The problem of test point selection is modeled as searching for the test point subset with the maximum diagnostic information of the set of all accessible test points of the circuit.

将测点选择问题建模为在全体可达测点集合中选取具有最大诊断信息量的测点子集问题，并用遗传算法对最优测点子集进行搜索。

Develop ciculareconomy is the inevitable choice to actualize the strategy of sustainable development.

发展循环经济是青岛市实施可持续发展战略的必然选择。

Some offer easy adjustability and convenient let-off choices, others don't.

一些提供方便可调，方便让小康的选择，其他人没有。

The objectives of this paper were to investigate the simulation and design of continuous multiple-station rolling forming process for a U-Section Steel Bar by CAE software-DEFORMTM Due to the limitation of elements number using a short strip 120mm went through all the stations to simulate the real continuous rolling forming on factory The roller gap was fixed as 0 30mm roll speed was 20 rad/sec and progressive angles were all equal for each rolling process which were the formed angle divided by by the number of station Three rolling processes were selected with 6 9 and 12 stations respectively During simulation processes two cases occurred Case A the strip was through a single station Case B the strip across two stations Because the strip laterals side was stretched and twisted during the process The model of case B closer to the practical process than case A and the calculated stress and strain on the tip of U section for case A were lower than these for case B by up to 15% From the result of case B for each process the stress for 12-station process was smallest 9-station process second and 6-station process next Because less-station can save larger cost and forming time but the bigger stress and strain for 6-station caused wrinkles on lateral sides not found on 9-station and 12-station Therefore 9-station process was a more suitable design than 12-station process smaller stretched and twisted and stress The progressive angles for 12-station was 7 5?

本文主要是以DEFORMTM有限元素软体模拟U型钢片连续道次成型与单一道次成型以确认单一道次模拟的是否可取代连续道次模拟之研究。因DEFORMTM 软体对於网格元素上的限制故使用较短素材120mm通过所有的成型站以模拟工厂实际连续成形方法。辊轮间隙固定为0 3mm；辊轮转速为20 rad/sec；弯曲角度的方法为将成型角度平均除以成型站数。有三种辊轮成型方式被选择分别为6站，9站，与12站。在模拟的过程中有两种现象会产生 Case A，素材通过单一成型站。Case B，素材会通过两个成型站。因为在模拟过程中素材的两端会有拉应力与扭力。Case B的模拟比Case A像实际的制程，并计算应力与应变在U型断面的Tip部中可发现Case A比Case B低约15%。从Case B的每站的结果可以得知，12站的成型应力最小，9站次之，6站最后。

The major findings are:⑴During the intelligence test for the three groups of students, for half of the students or most of the students their scores on the all-including scale, the language scale and the performance scale all increased to various degrees;⑵From the analysis of the relationship between intelligence and reaction time, it is found that the result of this study confirms the existing views that there is a negative correlation between intelligence and reaction time, and the negative correlation is more evident when it is choice reaction time;⑶Different motor skills have different influences upon children with lower intelligence. Though the difference is not large, the average increasing percentages in the sample T tests for the three groups before and after the experiment show that the effect of open motor skill is the best, that of the synthetic motor skill or the open-closed is the better, and that there isn't a marked change in the closed motor skill trainees;⑷While analyzing the result of the experiment, it is found that the scores on the performance scale are higher than the scores on the language scale, especially in the open motor skill group, which tells us that the intelligence improving effect of physical training is realized to a greater extent through increasing their performance abililty.

研究结果显示：⑴相对于实验前测试结果，三个实验组学生的智力水平在实验后测试中不论是在全量表得分还是在语言量表、操作量表得分方面均得到了不同程度的提高；⑵从智力与反应时的相关分析可看出，本研究结果进一步验证了前人观点，即智力与反应时有显著的负相关，特别是与选择反应时有很强的负相关性；⑶不同运动技能对智力落后学生智力影响不同，虽然实验后各组间没有显著性差异，但经各组实验前后配对样本T检验及实验前后各项分数均值提高百分率可看出，开放式运动技能组实验效果最好，综合运动技能组次之，闭锁式运动技能组实验前后在智力测验量表得分上无显著性变化；⑷各组实验前后的操作量表分比言语量表分提高幅度更大，开放式运动技能组表现得尤其显著，这表明了体育活动对改善智力落后学生的智力水平，很大程度上是通过提高他们的操作能力来实现的。

Four 8-bit I/O Ports C Three 16-bit Timer/Counters C 256 Bytes Scratch Pad RAM C 8 Interrupt Sources with 4 Priority Levels C Dual Data Pointer Variable Length MOVX for Slow RAM/Peripherals High-speed Architecture C 10 to 40 MHz in Standard Mode 16K/32K Bytes On-Chip ROM Program T80C51RD2 ROMless Versions On-Chip 1024 bytes Expanded RAM C Software Selectable Size (0, 256, 512, 768, 1024 bytes) C 256 Bytes Selected at Reset for AT87C51RB2/RC2 Compatibility Keyboard Interrupt Interface on Port P1 8-bit Clock Prescaler 64K Program and Data Memory Spaces Improved X2 Mode with Independant Selection for CPU and Each Peripheral Programmable Counter Array 5 Channels with: C High-speed Output C Compare/Capture C Pulse Width Modulator C Watchdog Timer Capabilities Asynchronous Port Reset Full Duplex Enhanced UART Dedicated Baud Rate Generator for UART Low EMI Hardware Watchdog Timer (One-time Enabled with Reset-out) Power Control Modes C Idle Mode C Power-down Mode C Power-off Flag Power Supply: 2.7V to 5.5V or 2.7V to 3.6V Temperature Ranges: Commercial (0 to +70C) and Industrial (-40C to +85C) Packages: PDIL40, PLCC44, VQFP44

四8位I / O端口C款三16位定时器/计数器 256字节RAM的便笺簿 8中断源4优先级和C双数据指针MOVX在缓变长内存/外设高速架构为C 10至40 MHz的标准模式16K/32K字节的片上ROM程序T80C51RD2无ROM版本片1024字节扩展RAMC软件可选尺寸（0，256， 512，768，1024字节）C选取在重置为AT87C51RB2/RC2兼容键盘中断接口与独立的选择港口小一8位时钟分频器64K的程序和数据存储器空间的改进X2模式的CPU和256字节每个外设可编程计数器5通道的阵列：C型高速输出C比较/脉宽调制器捕获看门狗定时器复位功能异步端口全双工增强型UART的波特率发生器的UART低EMI硬件看门狗定时器电源控制模式空闲模式C掉电模式C断电旗电源：2.7V至5.5V或2.7V至3.6V温度范围：商业（0到+70 C）和工业（- 40C至+85℃）封装：PDIL40，PLCC44，VQFP44

The lens axicon is based on the use of the spherical aberration of the mirror surfaces,which is inexpensive and easy to manufacture into a element with large apertures as compared with diffractive axicons,refractive cone axicons,and earlier lens axicons with aspheric surfaces;the opaque disk can offer the Bessel beams with long non-diffracting distances,and the diameter of the central peak is adjusted by choosing the focal length of the collimating lens;the tunable fluidic conical lens is a new device for generating Bessel beams,which can obtain the Bessel beams with different parameters by varying the refractive indexes of the solution which is filled in the device.

双透镜轴棱锥法主要基于透镜球面像差的运用，与衍射轴棱锥、折射轴棱锥和早期的非球面轴棱锥相比，具有加工简单、便宜，易于制作大尺寸的特点；不透明障碍物法得到的贝塞尔光束具有很长的无衍射距离，其直径可通过选择不同焦距的准直透镜来得到调节；可调流体轴棱锥是一种产生贝塞尔光束的新型器件，它可以很容易地通过改变注入器件的液体的折射率来得到不同参量的贝塞尔光束。

Based on those analyses and conformed international and national economic condition in china and some intrinsic defects of target zone regime, author transform target zone exchange rate regime by dividing two layers and bring forward a new exchange rate regime: double-layer-monitor exchange rate regime, the new model have possessed two merits, one is that the new model make "hollymoon effect" of target zone recurrence,and the merit can alleviate the fluctuation of exchange market;another merit is that the new model is a self-regulation system, that is say, the model can avoid long-term misalignment of exchange rate, those merit have major significance for china economy sustainable development and Chinese financial system more perfection, in paper we also present some fiscal policy and money policy served as a foil to double-layer-monitor exchange rate regime in order to make it work well, at last, we conclude that the new model will be the prior selection of RMB exchange rate regime reform for a long time form now on, and it also can serve as the bridge of RMB exchange rate regime steering to one of bipolar—free float.

在这些分析的基础上，并考虑到当前中国所面临的国际国内经济环境，针对汇率目标区的一些固有缺陷，笔者又对汇率目标区模型进行了分层改造，提出了一个新的汇率机制模型：汇率目标区双层监控模型，该模型有两个主要优势，一是可以使&蜜月效应&得以重现，从而避免外汇市场的过度波动；二是该模型是一个自稳定系统，能够进行自我调整，使实际汇率同长期均衡汇率保持一致，从而避免实际汇率的长期错位。这些优点对于我国经济的可持续发展，对于我国金融的更加完善，有着十分重要的意义。为使汇率目标区双层监控模型良好运行，论文还就相应配套的财政政策、货币政策措施作了探讨。最后得出结论，按照汇率制度&并存继起&假说，今后很长一段时间内，汇率目标区双层监控模型都将是人民币汇率制度的合意选择，另外，它也可作为人民币汇率制度向独立浮动制过渡的桥梁。

The titrant is a mixture of EDTA and sodium fluoride, both mercury film electrode and fluorinion selective electrode are inserted in the titration solution. In a process of titration, both the added volume of titrant and the concentration of mercury ion at each titration point can be obtained simultaneously from the potentials of two electrodes, and then the concentration of each component in the alloy can be obtained from the titration curves by multivariate calibration.

用ED-TA与氟化钠的混合溶液作为滴定剂，被滴定液中同时插入了汞膜电极和氟离子选择电极，在滴定过程中的任一滴定点，溶液中汞离子的浓度和滴定剂的加入体积可由两个电极的电位测定值同时获得，从而可应用多元校正法由相应的滴定曲线求得混合金属中每一种组分的含量。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐