可输入

Density-based clustering algorithms can discover arbitrary shaped cluster, identify noise, and are insensitive to the inputting order of data objects with good flexibility, which have been applied in various fields weightily.

基于密度的聚类算法由于能够发现任意形状的聚类，识别数据集中的噪点，对输入对象的顺序不敏感，可伸缩性好等特点，在许多领域有着重要的应用。

For automatching securities, a QUANTITY greater than zero must be input and SHORTSELL indicator can be changed to Y, M, A, F or N.

对自动对盘股份而言，必须输入一个大过零的数量及沽空指标在需要时，可被设定为Y、M、A、F或 N。

At present, OTA circuit is designed the best circuit with minimum error generally acknowledgedly, and possessed three following advantages at the same time: using single-ended-input OTAs (overcoming the feed-through effect due to the use of differential-input OTAs), using grouded capacitors (absorbing the shunt parasitic capacitance), and using the minimum components and all the parasitic capacitances have the same places as those of all the given capacitors in the realized circuits.

目前为止，OTA电路是被公认设计最佳且误差最小的电路，且同时具备了以下三项优点：(1)使用单端输入的OTA(可免除寄生电容的Feed-through效应)，(2)使用接地电容，(3)使用最少的主动元件，且所有外加电容位置恰好与所有寄生电容的位置相同，吸收了寄生电容，并减少寄生效应对整体电路的影响。

Of ＂Consulting and Diagnostic Computer System on Heredity and Aristogenesis＂ were applied to mark the character of sickness rationally（ to analyse calculation of character contribution rate towards illness and mark）.

通过输入求治者症状和体征的描述资料，可根据提示的相关疾病中得分的高低，作为诊断的参考依据，特别对再发风险估计予以合理解释。

The material balance of technology and one hundred thousandtone stages is accomplished, laying a foundation for industrial experiments of bisphenol A ofpolycarbon-stage with HPA method. The characteristics of the process are shown as follows. Thefirst, using reaction distillation technology to make water and toluene to reach azeotropy andremove them promptly, the reaction rate is increased.

绘制了带控制点的流程图，建立了流程优化模拟计算的数学模型并编制了计算机程序，通过输入工艺设计要求，应用该程序很快就可以完成整个流程的模拟计算，应用该程序也可进行整个流程的优化设计计算。

These antennas can cover GSM900/DCS/PCS/UMTS operation. In the chapter 2, the antenna is designed based on the concept of monopole antenna. Furthermore, the antenna structure have two radiant paths and coupled each other at tail end to do impedance matching. In addition, to raise distance between radiation plane and ground will avoid capacitative effect effectually. In the chapter 3, the antenna is designed based on the concept of planar inverted-F antenna. Furthermore, that the antenna structure have two radiant paths and coupled each other at tail end to do impedance matching is similar to chapter 2. But there is a difference in them. We can choose the short position to change input impedance at this structure. In the chapter 4, the antenna is designed based on the concept of planar inverted-F antenna which takes coupled-fed. It will produce the first mode and high-order mode near the frequency, 900MHz. The feature of this type is to reduce the volume effectually. This antenna can not only cover GSM900/DCS/PCS/UMTS operation but maintain good radiation efficiency. Finally, we will compare three antennas, and develop procedure with industrial view, and propose the prospect of the GSM/GPRS antenna in PND, as a conclusion.

在第二章中，我们使用单极天线设计概念，使用双路径架构并於末端耦合来对天线阻抗做匹配，产生涵盖GSM900/DCS/PCS/UMTS四频操作频带，并提高与接地面的辐射高度，以避免电容效应，使天线具有良好的辐射特性；在第三章中，使用倒F形天线设计概念，使用双路径架构於末端耦合，并於辐射臂上采取适当接地点电感效应作输入阻抗匹配，达成涵盖GSM900/DCS/PCS/UMTS系统的四个操作频带；在第四章中，采用倒F形架构并使用耦合馈入方式，使得长辐射金属臂在低频900 MHz附近产生共振，产生低频基频模态及高阶模态，以达成宽频及频宽涵盖GSM900/DCS/PCS/UMTS频带操作，并有效缩减使用体积；最后，分别比较此三种架构的优缺点，再加以业界角度来思考，研发产品天线的流程及思考方向，以及天线应用於可携式导航装置中未来的展望作为本论文的总结。

The key point of the structure of the utility model is that: the other side of the reducer that is arranged on the platform is provided with a hoisting device; the roller shaft end of the electronic controlled windlass is provided with a hub, a damper brake is arranged outside the hub; the input castellated shaft of the reducer that is arranged on the electronic windlass is provided with duplicate gears that have different amount of teeth.

本实用新型包括标准节，两侧标准节的中间为平台，电控卷扬机的卷绳通过平台上的滑轮同吊盘相连；平台上的减速器的一侧设置有可提升平台的具有卷绳的滚筒，平台上设置有具有滑轮的支架，其结构要点平台上的减速器的另一侧设置有提升装置；电控卷扬机的滚筒轴端设置有轮毂，轮毂外设置有制动闸；电控卷扬机的减速器的输入花键轴上设置具有不同齿数的双连齿轮，双连齿轮之间的凹槽内的拨杆同减速器外的摇把相连。

JS11 Intelligent Straight-line Beveling Machine and a PG10 glass polishing machine, Its Joint-Link adopts chainless ball bearing construction .smooth transmission, high-precision movement , The controlling system adopts PLC, which can be operated manually or automatically. The human-machine interface displays various parameters, such as the glass thickness, bevel width and angel, remaining thickness, and working speed The convey speed adopts speed adjustment of frequency conversion The machine can grind and clean the rear transmitting plate of itself.

JS11玻璃直线斜边磨边机及PG10璃直线斜边抛光机采用无链条轴承滚动链板结构，传动平稳，运动精度高，控制系统采用PLC控制，可自动、手动转换，人机界面清楚显示玻璃厚度、斜边宽度及角度、剩余玻璃厚度和加工速度等各种参数，参数的输入和修改直观、便捷，自动化程度高，传送速度采用变频调速，能在本机上进行修磨后板，并设有后板自动清洗装置。

Aprotinin blood anesthesia can reduce the volume of hemorrhage and transfusion and not influence the coagulable function. It is worth using in the joint replacement operation.

结论抑肽酶血液麻醉可明显减少关节置换外科手术的出血量，减少异体血的输入，且不影响凝血功能，值得推广应用。

A novel combined phase conjugator consisting of a fused silica rod and silica fiber is used in the high repetition laser system to improve the light quality.

提出了一种新型的由熔石英棒和石英光纤组成的复合型相位共轭镜，其可运用于高重复频率激光输入系统中以改善光束质量。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。