可计算

According to the characteristics of the gray projection curves, a pair of maximum and minimum points are found near the central position of each gray projection curve. The differences in position are calculated respectively and the scale change parameter is obtained as the ratio of both differences.

此时，可根据尺度变化下图像灰度累积投影曲线的特点，分别计算参考帧和当前帧的投影曲线上一对极大—极小值点的坐标差值，以它们的比值作为缩放系数，实现实时求取。

But when the cholesterol was substituted by its oxide result, the membrane life time extended to nearly 60 hrs ;besides the diameter of the hole on which the membrane exists 、temperature、PH value cause great effects to the life time of the membrane, and the diameter was the most important element. When the diameter larger than 3mm it is almost no way to form a membrane on the hole under experiment condition. Between 1mm and 3mm it has a better result by change the prescription of the membrane. when it is 0.5mm all the membrane can last more than 40 hrs ,and the prescription like Och : phosphatidylcholine / cephalin＝4:1; 3:1; 2:1; 1:1; 2:3 need the request of the experiment basically, when cooperate with multi hole structure it is very to detect the concentration and found the model.

研究结果说明，成膜在普通胆固醇/磷脂配方下不能达到满意的结果，无论如何改变外界条件成膜始终超不过7小时，而将胆固醇换成氧化胆固醇再和磷脂按照一定配比的时候，成膜时间则大大延长，可达60h左右；另外除成膜配方，成膜孔径、温度、PH值等因素对成膜有着很重要的影响，成膜孔径对膜的影响最为关键，在3mm以上的孔径时成膜比较困难，在1－3mm适当提高成膜液浓度可以改善，孔径为0.5mm左右成膜比较稳定基本都能达到40h以上，合适的几个配方如卵/脑磷脂：氧化胆固醇＝4：1；3：1；2：1；1：1；2：3基本满足实验要求，配合一板多孔结构，可以保证单位时间的离子传输量的检测和计算。

Article 2.2.2 provides for an alternative calculation method that can be employed precisely when the method contemplated by the chapeau cannot be used.

当起首条款中预设的方法不能适用时，条款2.2.2规定了一个可供选择的计算方法。

The status of the flow in manifold systems will directly affect the efficiency and security of an exchanger. With the help of discrete model, the characteristic of the flow in manifold systems will be got.

流体在并联管组换热器中的流动状况将直接影响到换热器运行的效率和安全性，通过离散模型计算方法可得到流动工质在并联管组内的流动特性。

In order to reduce the computer time for solving the block-matrix equations, the characteristic matrix transformation is used.

采用特征向量变换，可在保证原方程组离散化精度的条件下使计算大为简化。

Having analyzed the axial damping characteristic of the rolling strip mill, the scale of axial damping factor is established.

还可对一些特殊轧机，如PC轧机、CVC轧机、HC轧机等进行辊系特性的分析，是对轧机研究理论和计算模型的丰富和发展。

Through above study, the theoretical analysis of the inherent fault tolerance of feed-forward neural networks has been extended from hard-limit activation functions to differentiable activation functions; 2. By using above method, fault tolerance of discrete Hopfield feedback neural networks have been also analyzed. It means that the above method can be applied not only for feed-forward neural networks but also for feedback neural networks; 3. For the feed-forward neural network with the Sigmoid activation function, Chebyshev Inequality method was presented.

这项研究将以前仅限于对硬限幅作用函数前向神经网络固有容错性能的理论分析推广到具有可微作用函数的前向神经网络； 2 针对离散型Hopfield反馈神经网络，利用上面提出的方法，对其同样进行了容错性分析，得出许多有用的结论和计算公式，说明上面提出的方法不仅适用于前向神经网络，同时也适用于反馈神经网络； 3 针对具有Sigmoid作用函数的前向神经网络提出了一种切比雪夫不等式法。

For the safety instrumented system,the functional structure,safety life circle and the implementation method of functional safety were analyzed.

对安全仪表系统的功能结构、安全生命周期以及功能安全的实现方法进行了分析，并提出了基于马尔可夫建模的SIS的安全完整性等级计算软件的设计方案，采用VB6.0和Matlab进行了软件的开发实现。

Having elucidated the principles of magnetic stimulation, a macro model of magnetic stimulation of excitable tissue is constructed and a method for systematically computing the magnetic field and the electric field induced by circular coil and 8-shaped coil is put forward.

本文在阐明磁刺激基本原理后，建立了磁刺激可兴奋性组织的宏观模型。系统地推导出圆形、8字形线圈磁场及产生的感应电场的计算方法。

Some tedious calculations of circular functions and matrix were avoided by this algorithm.

使用该算法可避免出现三角函数、矩阵等复杂计算。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。