可解决的
- 与 可解决的 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Thus, it is an important environmental problem to control the acid rain and soil acidification for advancing the sustaining development.
因此,控制酸雨和土壤酸性化是可持续发展进程中必须解决的一个重大环境问题。
-
However, the key is to turn the shopper insights into actionable solutions.
然而,关键是要把顾客眼光变成可行动的解决方案。
-
The analytic hierarchy process and fuzzy set theory are applied to build the model.
这样可解决评估过程中存在的不确定性变量,使评估结果更加趋于合理。
-
The research contents mainly include: First, the influence of foundation constraint condition to the temperature stress is analyzed, the temperature stress formula of ultra-long concrete anchor plate is deduced, then the influence of length to structure crack can be gotten from the formula. Second, a breathing method is set up to solve the problem of temperature stress in ultra-long concrete constructions. By setting the sliding floor, a breathing system is built up and the temperature stress reduced distinctly. Third, the effect of prestress technique in the control of temperature stress is analyzed, it is simulated and calculated through FEA to get the right way to apply the prestress. Forth, the delay of temperature field and unsteady conduction is considered, the temperature field of ultra-long concrete structure with later poured band is simulated, then temperature stress distribution after casting the concrete is calculated, finally the effect of later poured band to temperature stress of ultra-long structure is analyzed.
本文的研究内容主要包括:(1)分析了基础约束对超长混凝土结构温度应力的影响,推导了超长混凝土地基板温度应力公式,从而得出长度对结构裂缝的影响;(2)针对超长混凝土裂缝问题,提出了一种可呼吸的解决方法,通过设置滑动层,使结构成为一种"可呼吸"体系,从而有效的降低温度应力;(3)分析了预应力技术在控制超长结构温度应力中的作用,通过有限元模拟计算,得到合理的预应力施加方式;(4)考虑温度场的滞后效应及不稳定传导,对带后浇带超长混凝土结构浇注后的温度场仿真模拟,计算浇注后的温度应力分布,分析后浇带对超长结构温度应力的影响。
-
This problem can be solved by applying a bactericidal and anti-corrosive coating on the walls of the wells.
采用在井壁涂刷杀菌防腐涂料的办法可解决8t t t 8。 c o m这一问题。
-
The educational model may solve the problem that the teaching theory and the teaching practice come apart.
教学模式可解决教学理论和教学实践相脱节的问题。
-
There will always be a market for some basic data capture and integration solutions.
这并不是说你们将会被淘汰,收集基础数据和寻求解决方案总是有市场可循的。
-
When changing diaphragms in most drivers the new diaphragm may not be 100 % concentric to the old one, and the only way to align it in the magnetic gap is by removing the iron pole from the driver and loosening the screws holding the center pole piece, then and only then the diaphragm can be aligned with the center pole piece and rubbing or touching of the voice coil with the pole pieces in the gap is avoided, this may happen at certain frequencies only, producing a very harsh sound, even passing a static or a dc diaphragm test , therefore the claim that the diaphragms are replaceable in the field is not in many cases true, only when the driver has adjustable screw and dowel locating pin the alignment is possible without getting inside the driver and when alignment of the diaphragm is needed, the plate holding the pole pieces and assembly needs removal, by doing so the pole piece may be well set and aligned but the magnetic field will weaken significantly by such a procedure and solving one problem leads to another one, in this case the driver needs to be re magnetized in order to perform well.
当改变隔膜在大多数司机的新膜片不得100 %同心旧的,只有这样,才能使其在磁场的差距是通过消除铁柱从司机和松动的螺丝中心柱举行一块,然后才是膈肌可配合中心极片和摩擦或触摸的音圈与极片的差距是可以避免的,可能会遇到这种情况只有在特定的频率,产生了非常严厉的声音,甚至通过一个静态或直流隔膜测试,因此声称隔膜的更换在外地不是在许多情况下,真实的,只有当该名司机已可调螺丝和销子定位销调整是有可能没有得到内部的驱动器和调整时,膈肌是必要的,举行的板极件和大会需要搬迁,这样做极可能是一块很好设置和调整,但磁场将削弱显着这样的程序和解决的一个问题导致另一次,在这种情况下,司机必须重新磁化,以表现良好。
-
This issue is addressed by an inrush current limiter device for limiting inrushing current to a connectable load comprising: at least one switchable IGBT-based limiter unit for selectively limiting the inrushing current, having at least one current limiting conductor element for a limited leading of current and at least an IGBT-based switch whereby the IGBT-based switch is used as well as a controlled current limiter and as a by-pass element, and at least one control device for controlling the IGBT-based switch, whereby the control device comprises at least one IGBT-based switch supply and means for realizing smooth flanks of an output signal at the selected conductor element.
该问题通过用于限制针对可连接负载的浪涌电流的浪涌电流限制器设备解决,该浪涌电流限制器设备包括:至少一个可开关的基于IGBT的限制器单元,用于选择性地限制浪涌电流,其具有至少一个限流导体元件,用于有限引导电流,和至少一个基于IGBT的开关,其中基于IGBT的开关用作受控电流限制器和旁通元件,和至少一个控制设备,用于控制基于IGBT的开关,其中控制设备包括至少一个基于IGBT的开关电源和用于实现选定导体元件处的输出信号的平滑侧面的装置。
-
A method is hence proposed to prevent the fault by setting a surge arrester at inlet side of circuit breaker,or setting a surge arrester with gap at line terminal tower if there isn't a position for setting the arrester within substation.
探讨了断路器的性能、现行有关标准和规程的适用性,得出解决故障可采取的措施:在断路器的进线侧安装避雷器,如变电站内无安装位置的话,可在线路终端塔上安装带间隙的线路避雷器。
- 推荐网络例句
-
But we don't care about Battlegrounds.
但我们并不在乎沙场中的显露。
-
Ah! don't mention it, the butcher's shop is a horror.
啊!不用提了。提到肉,真是糟透了。
-
Tristan, I have nowhere to send this letter and no reason to believe you wish to receive it.
Tristan ,我不知道把这信寄到哪里,也不知道你是否想收到它。