可行性研究

The theory and method of measuring the tropopause height with microwave radar is narrated. The feasibility of the method is specified by some contrast experiments.

三、讨论了微波雷达测量对流层顶高度的原理和方法，介绍了Fresnel散射模型，并通过对比研究实验研究了测量方法的可行性。

In this paper, it makes a deep research about the current SMS Voice VAS platform and VAS unified access technology.

本论文深入的研究、分析了短消息语音增值平台的现状，研究了多种增值业务统一接入和集中处理的可行性。

Through researching the mechanism of biological nitrification and denitrification and actual project application of the technology and related literature materials, the obtained results are as follows:(1) Anoxybiosis is effective to the removal of COD; after the anoxic process, BOD/COD of the outflow increases, it shows that the degradation ability of wastewater is improved; anoxybiosis is insensitive when shock loading of inflow wastewater varies greatly;(2) It is demonstrated by the operation of inoculation and cultivating that biofilm takes two weeks to succeed in cultivating on packings and the removal ratios of NH3-N and COD get 50% and 70% respectively, when gas-water ratio is 6:1, HRT is 7.3 hour, water temperature is above 15°C;(3) It is demonstrated that gas-water ratio, hydraulic loading, HRT, temperature, pH etc are important factors which influence the removal effect of pollutants, when the gas-water ratio is 6:1, hydraulic loading is about 0.38kgNH3-N/m~3.d, water temperature ranges from 15°C to 27°C, pH ranges from 7.5 to 8.0, the BIOFOR removal effect of pollutants is the best;(4) The operation indicated that, this technology has strong ability of nitrification and denitrification; it has extremely vital significance for reducing the water body eutrophication;(5) It is confirmed the feasibility and the usability of preanoxic-BIOFOR process to treat L-lactic acid production wastewater. The experiment indicated that the treatment effect of this technology is very good and also shows that the technology has many advantages, such as small volume, high treatment efficiency, good effluent quality and strong endurance to load variation, this technology is a new and economical wastewater treatment process.

通过对生物脱氮机理的研究和该组合技术的实际工程应用，并结合有关文献资料，取得如下结论：(1)预缺氧池对L-乳酸生产废水中的COD去除具有一定的效果；废水中难降解的高分子物质经过缺氧工段分解为易于氧化降解的物质，浮状有机物在水解菌的作用下，将不溶性有机物水解为溶解性物质；预缺氧池具有较强的抗冲击负荷能力；(2)BIOFOR接种挂膜过程表明：HRT为7.3h、气水比为6：1、水温保持在15℃以上，经过半个月生物膜即以形成，NH_3-N和COD的去除率分别达到50％和70％左右；(3)研究表明：气水比、水力负荷、HRT、温度、pH等是影响污染物去除效率的重要因素，在气水比为6：1，NH_3-N容积负荷为0.38kgNH_3-N／m~3·d，温度在15℃-27℃，pH在7.5-8.0之间的条件下，BIOFOR对污染物的去除效率达到最佳；(4)运行表明，该组合技术具有较强的脱氮能力，对于减少水体富营养化具有十分重要的意义；(5)经过半年多实际工程的现场调试与运行，验证了利用预缺氧—BIOFOR组合工艺处理L—乳酸生产废水的可行性和实用性，得出该组合技术具有占地面积小，处理效果好，运行费用省，耐冲击负荷能力强等优点，是一项新型、经济的污水处理技术。

The comparative study on the treatment effects of baclofen and verapamil in treating spastic bladder after spinal cord injury: To investigate the possibility and the effect of medicine treatment of spastic bladder, we were the domestic No.1 to treat spastic bladder with baclofen the international newest products of antispastic drugs for striated muscles.

HBaclofen与异博停治疗脊髓损伤后痉挛性膀胱比较研究：为探讨药物治疗痉挛性膀胱的可行性及其疗效，本研究将国际上最新研制的横纹肌解痉药Baclofen在国内首次应用于痉挛性膀胱的治疗。

Some new results are obtained from the studies: 1 a novel thermokinetic research method, the characteristic reduced parameter method, has been proposed, and the kinetics of oxidation of benzoquinone by hydrogen peroxide has also been investigated with this method; 2 the kinetic mathematical models that the metallomicelles made from the mono-nuclear or dinuclear complexes and surfactants catalyze the phenolic derivant oxidation have been established respectively; 3 the feasibility and mechanism that the metallomicelle, a mimetic model of peroxidase, catalyzes the phenolic derivant oxidation has been discussed.

研究得到如下新的结果：(1)提出了一种新的热动力学研究法——特征对比参量法，用该法研究了过氧化氢氧化苯醌反应动力学；(2)分别建立了由单核和双核金属配合物与表面活性剂形成的金属胶束催化酚类氧化反应的动力学数学模型；(3)探讨了金属胶束模拟过氧化物酶催化酚类氧化反应的可行性及其机理。

This experiment contrapose the characteristic of this water quality, present situation of the processing and the existent question, studied on the feasibility of the hydrolisis acidification - SBBR process treat with this kind of wastewater, and has conducted the related exploratory experimental study, had determined the operating condition of this process and the interrelated ...

本试验针对此类废水的水质特点、处理现状及存在的问题，研究了水解酸化-SBBR工艺处理该类废水的可行性，并进行了相关探索性试验研究，确定了本工艺的运行工况及相关参数，为其能应用于工程实践提供了一定的理论基础及科学依据。

An innovative process for the production of high molecular weight poly(L-lactic acid) was presented, featuring solid-state polycondensation of L-lactic acid in a closed system with a dehydrant to remove water selectively.

研究在真空密闭、存在脱水剂的条件下聚乳酸固相缩聚工艺的可行性，得到了分子量达25万的聚乳酸；实验研究了催化剂浓度，预聚体粒度和反应时间对缩聚过程的影响，表明降解副反应仍然是控制聚乳酸最终分子量的重要因素。

Compared with the conventional analytic methods, the author studies the feasibility that the elastic bearing model is used to simulate the boundary constraint condition of the enrockment.

引入弹性边界模型，对比传统分析中对边界约束的处理，研究用弹性边界来模拟堆石体边界约束条件的可行性；选用规则典型的坝体，研究面板堆石坝的面板及堆石体的应力应变规律，特别是周边缝的变形规律；分别讨论了岸坡坡比、坝前水深、坝高、河床底宽等几何参数对弹簧系数取值的影响，确定弹簧系数的取值范围，给出了可用于实际工程计算的最佳取值范围；以松山面板堆石坝作为工程实例，验证弹性边界模型的实用性，并为工程建设提供了一定的参考。

This thesis investigates the profile extraction and shape optimization on the result of topology optimization of planar compliant mechanisms. The main context includes the following work:(1) summarizing and analyzing the recent research status, some harvest and unsolved problems;(2) analyzing the conceptual design of planar path-generating compliant mechanisms and its mathematical model and tools;(3) Modifying the method of density contour as the method of profile extraction, and developing a method to optimize the density function in the profile extraction according to the requirement of the design of compliant mechanism;(4) developing a method to abstract the compliant mechanism into a form of links and joints by using the principle of connectivity on topology;(5) developing a method of shape optimization of planar path-generating compliant mechanisms, by representing the profile of the abstracted compliant mechanism as simple curves such as straight lines and arcs, establishing the models of the size optimization of the parameters of these curves, so that the compliant mechanism has a machinable shape;(6) At last, proving the feasibleness and effectiveness of the design method by making simulation design and validating it in FEA software.

主要工作包括：(1)分析了柔顺机构拓扑优化和形状优化的研究现状，分析了目前柔顺机构的研究重点、主要成果和尚未解决的问题；(2)分析了基于SIMP的柔顺机构概念设计方法及其相关工具和模型；(3)针对柔顺机构轮廓提取的特殊要求，提出了密度等值线法的改进方案，对密度函数插值点密度值进行优化，提出优化模型和选择优化算法；(4)根据轨迹输出平面全柔顺机构自身的形状特点，提出了轨迹输出平面全柔顺机构的抽象方法，即应用拓扑学上的连通性原理将柔顺机构抽象成杆件和结点形式，并对相应的数学原理进行了证明；(5)提出了平面全柔顺机构的形状还原和尺寸优化方法，对抽象的柔顺机构进行还原，将其轮廓还原成简单曲线的连接，从而建立尺寸优化模型，对机构进行尺寸优化设计，在得到可加工的机构轮廓的同时又能对关键部位进行特别处理；(6)进行了柔顺机构的数值仿真设计，并将所得设计结果导入商用有限元软件中进行仿真实验，证明了设计方法的可行性和有效性。

In addition, based on a project case under water-inrush hazard, the field experiment has also been carried out; contrasted to other types of grout, such as cement with super fine slag, cement and water glass double grouts, and urea resin harnstoffharz, the applications and advantages of this chemical grout on inrush of high-pressure water controlling has further been proved.

以深部地下工程的加固和高压突水治理为研究对象，对一种新型化学注浆材料的化学反应封堵机制进行了可行性分析，并针对化学浆液的流动性、渗透性、抗冲刷性以及固结体的强度、水质毒理等因素进行了室内试验研究，详细地分析了浆液的物理化学特征，给出了浆液最佳配比值以及相应的性能指标。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。