可电解的

Testing media for 'Mother of Vinegar' in Anolyte systems is not commercially available.

测试媒介为'醋的母亲' 在阳极电解液系统不是通商上可得到的。

Results show that the best value of w is 7~10% and 5~7%, i is 0.08~0.2 A/cm^2 and 0.03~0.05 A/cm^2 respectively, during the electrolysis fluorination of pyridine and tributylamine; the addition of N-butyl mercaptan into the organic mixture can stabilize electrolysis process with its mass fraction 15~20% at best; impulse current polarization work status of low load is helpful to the electrolysis process and reduces corrosion rate of anode; electrolysis temperature is suitable at 0~20℃; electrobath can use electrolyte inner circulation structure, exterior circulation structure or blending structure.

结果表明：吡啶和N-三丁胺电解氟化的最佳值w分别为7%~10%和5%~7%，i分别为0.08~0.2A/平方公分和0.03~0.05A/平方公分；有机混合物中添加N-丁基硫醇可稳定电解过程，其质量分数最佳为15%~20%；采用低负荷的脉冲电流极化工况有利电解过程，降低阳极的腐蚀速度；电解温度0~20℃为宜；电解槽可采用电解液内循环、外循环结构，或其混合结构。

Changes of structural speciation of electrolytic manganese dioxide after discharge and charge were also studied by the X-ray diffraction method.

进一步改善电解二氧化锰的质量和电化学性能[1，2]，以及对电解二氧化锰可充电性的研究[3-5]是当前对电解二氧化锰研究的主要方向。

With the raw material and the particle size of reducing agent narrowed, the percent reduction of strontia increases.(6) With the barbecuing pressure increasing, the percent reduction of strontia increases, after the certain value, the percent reduction of strontia decreases instead.(7) With reduction temperature increasing, the percent reduction of strontia increases.(8) The percent reduction of strontia is increasing with prolonging reduction time. In this experimental condition, it will become steady after 2.5h.

通过实验研究确定以SrCl_2-SrF_2-SrCO_3的纯锶盐体系作为电解质，实验中还采用了我们最新研制的熔盐电解监控仪对电解过程进行测量和系统的研究，得出以下结论：(1)增加电流强度，反电动势亦随之增加，而升高温度反电动势则有所降低；(2)随着电流密度的升高和电解时间的延长，电流效率逐渐增加，达到峰值后稳步下降；(3)延长电解时间，合金中锶的含量逐渐增加，最高可达18.1％；(4)开始电解后，反电动势逐渐增加，但向熔体中加入SrCO_3后，反电动势明显降低，因此认为在正常电解时是SrCO_3在分解。

The synthesis mechanism of Al_(13)in the process of electrolysis was discussed,the effects of electrolysis voltage,the original concentration of Al~(3+),the circulation mixing rate of the electrolyte and the exchanging frequency of the electrodes on the synthesis velocity of Al_(13),ratio of Al_(13)in total Aland the electrolysis time were studied.

本工作对电解过程中Al_(13)的形成机理进行了探讨，并研究了电解电压、Al~(3+)的初始浓度、电解液的循环搅拌速度和阴阳电极的互换频率对Al_(13)的合成速度、Al_(13)占总铝的比率及电解所需时间的影响，得出了电解法制备Al_(13)的最佳工艺条件：电极互换频率为1次·min~(-1)、电解液中Al~(3+)的初始浓度为0.5000mol·L~(-1)、电解电压为12V和0.5L·min~(-1)的电解液循环搅拌速度，在此条件下电解125min可制得碱化度为82.0%，Al_(13)占总铝的比率达91.2%的液体产品。

Preparation of the cathode includes:shaping under the press of 40Mpa, sintering at 550℃for 1 hour and at 900℃for 8 hours and threading with molybdenum bar; Considering the literatures we choose CaCl2 as salt for preparation titanium. Pretreatment of salt is for 1 hour at 100℃and for 2 hours at 300℃. Partial pressure of oxygen which need lower than 5.11×10-7Pa to reduct titanium oxides and hygroscopic property of salt need a sealed equipment to electrolyse. And finally successfully designed a satisfied one and the results show that the equipment can be satisfied the requirment of the experiment. Flow of the inert gas is 1.5L/min, the voltage is 2.8 V, temperature is 850℃and time is 2 hours during pre-electrolysis. Flow of the inert gas is 0.2L/min, the voltage is 3.1 V, temperature is 900℃and time changes with the mass of TiO2 during electrolysis, namely the greater need the longer time; To eliminate influence of salt and other impurities, the products need to wash with distilled water and dilute chlorhydric acid , then wash with dilute hydrochloric acid under supersonic wave assistant. Finally, electrometical properties of the electrolysis of TiO2 is researched by cyclic voltammetry and chronoamperometry, and results show that there are two main reodox steps, namely from TiO2 to TiO and from TiO to Ti.

阴极制备主要包括40MPa压力下模压成型、两段式烧结(1小时内升至550℃保温1小时，再1小时升温至900℃保温8小时)及烧结后TiO2块打孔用钼棒串接三个主要环节；实验中选用CaCl2作为电解熔盐，并对其进行预处理(100℃，保温1小时； 300℃，保温2小时)；经热力学计算，还原钛氧化物的氧分压至少要低于5.11×10-7Pa，结合电解过程中所用熔盐CaCl2有极强的吸水性的特点，电解装置应有较高的密封性，自行设计了一套密封性可靠的电解装置，便于实验过程中熔盐预处理和氧分压的控制；通过干燥处理预电解过程中Ar流量大约为1.5L/min、电压为2.8 V、温度为850℃、时间为2小时，电解过程中Ar流量大约为0.2L/min、电压为3.1V、温度为900℃，实验结果表明电解时间与TiO2质量密切相关，质量越大需要电解的时间越长；通过自来水冲洗—稀盐酸浸泡、洗涤—在超声波辅助作用下稀盐酸洗涤，可减少熔盐及其它杂质对电解产物检测结果的影响；最后，通过循环伏安法、计时电流法对电解机理的研究，确定电解还原TiO2制备金属钛主要经历了TiO2-TiO-Ti的过程。

Said method uses iron filings microelectrolysis treatment as core, after the pH of NIS waste water is regulated to proper value, said NIS waste water can be fed into microelectrolytic reactor to make iron filings microelectrolysis treatment, then the treated waste water is fed into precipitation tank so as to remove Fe(2 ) and Fe(3 ) introduced in the course of making microelectrolysis.

该方法以铁屑微电解处理为核心，NIS废水调节至适当pH后，进入微电解反应器进行铁屑微电解处理，处理后的废水进入沉淀槽以去除微电解过程中引入的Fe 2 和Fe 3 。经本方法处理后NIS废水中NIS的去除率可达80％。

Analyzing basic characteristics of aluminium electrolytic capacitors we have discussed performances of high-frequency low-impedance poleless aluminium capacitors, have developed new operating electrolyte s and selecting appropriate materials we have made high-frequency low-impedance poleless aluminium electrolytic capacitors with maximum temperature 85℃ and lifetime 3000h.

从铝电解电容器的基本性能分析入手，对高频低阻抗无极性铝电解电容器的特性进行了分析和讨论，开发出新型的工作电解液，并选择合适的材料，研制出了可用于85℃，3000h的高频低阻抗无极性铝电解电容器。

The said new technology will raise the Zinc concentration in the teated liquid to be higher than 30 g/L,and therefore the treated liquid can be reused as a process solution in a Zinc plant.The liquid permeating the membrane,with Zinc less than 0.1 g/L,is neutralis...

电解废水经膜分离处理后，浓缩液中锌浓度可达30 g/L以上，回收后全部进锌冶炼系统，透过液中锌浓度在0.1 g/L以下，用碱调节pH 5~6后可回用于电解工序洗板，实现了废水资源化和车间废水零排放目标，具有显著的经济效益和环境效益。

In the case of decorative zinc electroplatings, a further enhancement of the appearance of such substrates in addition to the corrosion resistance imparted is achieved by the passivate film which ranges from a clear bright to a light blue bright appearance simulating that of a chromium deposit or alternatively, a clear light-yellow appearance simulating that obtained by use of prior art hexavalent chromium solutions.

可选择的治疗方法，可进一步遏制卤化物包括氟离子、氯化物和溴化物离子进一步增加了硬度钝化膜以及一个或多个兼容为实现高效润湿剂接触基板对待。现在的发明特别地可适用但是不限制在碱而产生酸非氰化物的锌的治疗使电解沉积传授对被对待的基体改良的腐蚀抵抗和装饰的外表。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。