可抵抗的

Due to the fact that the intercarrier spacing in OFDM is relatively small, OFDM transceivers are somewhat more sensitive to phase noise compared to single carrier transceivers. Thus this problem must be carefully considered in designing an OFDMbased system since an accurate prediction of the tolerable phase noise can allow designer to relax system specifications. According to spectrum theorem, two components of phase noise were analyzed: common phase error and intercarrier interference. On the basis of the analysis, the performance of OFDM was given for the case where phase noise has been added to the signal, and an optimal design criterion for OFDM parameters was proposed that allows to improve the phase noise error correcting capabilities in OFDM receiver.

由于采用子载波间相互正交的结构，OFDM系统对于由本地振荡器不稳定性所导致的相位噪声影响非常敏感，针对公共相位误差CPE和载波间干扰ICI两种影响表现形式不同的干扰项，从功率谱密度函数这一独特角度分析了相位噪声对OFDM系统性能的影响，提出了旨在提高接收机抵抗相位噪声能力的OFDM系统关键参数优化与设计准则，可在对所设计OFDM系统性能加以提高的同时，有效降低对接收机前端模拟振荡器件和相位噪声抑制单元的性能指标要求，从而降低接收机硬件实现成本。

rubia cordifolia l can promote the mice capacity of antioxidation and reduce the content of mda, have obvious improve great mouse's sports ability.

补充茜草提取物可显著提高小鼠心肌和肝脏组织抗氧化酶的活性，减轻大强度耐力训练对大鼠心肌和肝脏组织造成的脂质过氧化损伤，具有明显的抵抗脂质过氧化的功能，对小鼠运动能力的提高有良好的作用。

Nevertheless, in these aPproaches the contact intethee are charactered sboly edstiffeess K. and K.' which is not PerfeCt and rigorous in thc vitw of solidmechanics and rather rough for the description of the behavior of the iDtfores. Incollbet, taken as a contact Problem, the principal chatrs of the iDtCthees can bereflected: the cbntact inifore is of shear strength Which imPlies tha a genericpair of contact points on the inidse will displace coincidentally if the tangentialfbrce at this POint has not reahed the 1imit resistance, else, relative s1ide betwee the\ points will occur along the tangental direction.

本论文在对这两种方法进行认真的分析后，说明它们对不连续面的描述并不合理，也无法反映出不连续面的主要力学特性，同时指出，将带有不连续面的岩土工程问题作为接触问题计算更为合理，它可将不连续面受力变形的主要特点反映出来，即：(1)接触面具有相应的&抗剪强度&，即当接触面上某一点处的切向应力小于该点处的抵抗强度时，点对共同变形；达到强度时，则沿切向发生相对滑动；(2)在整个变形过程中，发生接触的变形体不能相互侵入。

Below 300 300 to 1200 Ordinary Portland or Portland blastfurnace Ordinary Portland or Portland blastfurnace Sulphate resisting Supersulphated Sulphate resisting or Supersulphated High alumina Sulphate resisting or Supersulphated High alumina Sulphate resisting or Supersulphated with adequate protective coating High alumina Minimum cement content (kg m-3) Type of cement Maximum size of aggregate 37.5 240 290 240 270 290 290 330 330 330 330 19.0 280 330 280 310 330 330 370 340 370 370 9.5 330 380 330 360 380 380 420 410 420 420 0.55 0.50 0.55 0.50 0.50 0.45 0.45 0.40 0.45 0.35 Maximum water-cement ratio 0.5 to 1.0 1.0 to 2.0 1200 to 2500 2500 to 5000 Over 2.0 Over 5000 Wear

这些气 穴通常由具有格外高能量的水蒸气所填充，与混凝土表面的反复接触导致形成凹陷和孔洞，即气蚀。既然高质混凝土也不能抵抗这种劣化，因此最好的补救是通过制造平滑水流来消除气蚀。在所有必须的地方，关键的面上衬以高抗气蚀性的材料。通常，混凝土抗腐蚀和磨损的能力随强度增加而提高。采用硬韧的集料可改善混凝土的抗磨损性。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。