可弯曲的

Research also shows that in different test condition, sensitivity, accuracy, and stability of bending creep test at 0 C are better than that of bending test at -10C. Thus, bending creep test at 0C can preferably evaluate the crack resistance of asphalt mixture at low temperature.

结果表明，老化过程大大降低了沥青混合料的低温抗裂性能，0℃弯曲蠕变试验比-10℃弯曲试验对不同的试验条件的区分度更大，试验误差更小，稳定性更好，可较好地评价沥青混合料的低温抗裂性能。

The flexural properties were characterized using three point bending tests.

而三点式弯曲试验则可获得复合材料的弯曲机械特性。

The Periscope Drawtube will be bent because of the water resistance in sailing and this bend will cause the error of star measurement. Due to its especial structure, contactless measurement is the only way to measure its bend degree. First this paper introduces the method by linear array CCD based on structure and light path; Second it expatiates linear array CCD work principle and driving scheduling with example of TCD1501C and the driving circuit by CPLD. The output signal of linear array CCD includes common disturbance so the differential amplifier is needed. In order to make the signal adapt to computer processing, a threshold circuit with Schmitt characteristic and the data process following threshold are given. At last, some key problems in application are given.

潜艇潜望镜的镜筒在航行时受到水的阻力会产生弯曲变形，这种变形会造成潜艇对星体测量的误差；由于镜筒结构的特殊性，对其弯曲程度的测量只能采用非接触方法；首先从结构和光路方面介绍采用线阵CCD作为检测元件实现对镜筒弯曲程度的测量；其次以东芝公司的线阵CCD（TCD1501C）为例阐述了其工作原理及驱动时序的控制要点，并介绍了基于可编程逻辑器件的线阵CCD的驱动电路；线阵CCD输出的信号中含有共模干扰，必须采用差分放大器将其抑制；为将信号转化为适合计算机处理的数字信号，文中给出了有一定实用价值具有施密特特性的二值化处理电路及二值化后的数据处理过程；最后阐述了在实际使用中的一些关键问题。

For distorted book image under random twisted status,by comparing its margin-gray-curve data with the stored margin-gray-curves data,a group of multinomial coefficients whose corresponding twisted status is proximal to that of the to be corrected image can be selected out to determine automatically a group of distortion parameters that is suitable for distortion correction.

任意弯曲状态下的书籍扫描图像可以在数据文件中搜索到与其最接近的弯曲状态，并利用对应的多项式系数自动求得最佳畸变参数，用于图像的畸变校正实验，获得了较好的校正效果，最大误差由未校正时的63%下降到了4.4%。这使得在无需人工测量或调整畸变参数的条件下可自动校正书籍扫描图像。

Quantitative measurements also show that the bend sensitivity against the resonant wavelength shift has a periodic distribution along circular directiom.Based on these results,this paper proposes two approaches for sensor desi...

据此提出新型对弯曲不敏感的传感器和可调灵敏度弯曲传感器的设计方案，可望从根本上解决长周期光纤光栅在测量中存在的温度、应变或折射率与弯曲之间的交叉敏感问题

The formula of the minimum relative bending-radius, which is related to mechanical property of the tube and constrained by tensile destabilizing, is concluded...

给出与管材力学性能相关，且受拉伸失稳约束的最小相对弯曲半径的计算公式，可用于工艺计算，并对管材弯曲成形设计和工艺分析具有一定的参考价值。

Lateral crus presented diamond-shaped or long strip,(16.21 ± 2.71) mm in length,(8.45 ± 1.72) mm in width,(1.09 ± 0.18) mm in thickness. Cephalic rim intersected lower edge of lateral nasal cartilage, and slightly covered the lower edge of the lateral nasal cartilage, so that the two were overlapped, but also only the intersection without overlapping. Lateral crus constituted the base of nasal wings. Narrow medial crus formed nasal tip and the frame of front nasal columella, showing posteroinferior curve or S shape,(13.06 ± 2.16) mm in length,(3.79 ± 0.58) mm in width,(1.02 ± 0.18) mm in thickness. The left and right medial crus in the middle were connected by connective tissue, and in the same way connected to the anterior margin of the lateral nasal cartilage.

外侧脚呈菱形或长条形，长(16.21±2.71) mm，宽(8.45±1.72 ) mm，厚(1.09±0.18) mm，头缘与侧鼻软骨下缘相交，并略覆盖侧鼻软骨下缘使二者部分重叠，也可仅相交而无重叠；外侧脚构成鼻翼大部的基础；内侧脚狭细，构成鼻尖和鼻小柱前部的支架，呈向后下的弧形弯曲或S形弯曲，长(13.06±2.16) mm，宽(3.79±0.58) mm，厚(1.02±0.18) mm；左、右内侧脚在正中线借结缔组织相连，并以相同方式连于侧鼻软骨的前下缘。

Analytical formulae are presented for the first time to describe the shift in the resonance wavelength of LPG in response to etching of the fiber cladding or a change in the external refractive index. The accuracy of the formula is confirmed by comparision with numerical simulations and experimental results. We demonstrated that the resonance wavelengths of an etched LPG are more sensitive refractive index than those of an unetched grating. The bending properties of long period fiber grating written in different type fiber are studied experimentally. The transmission peaks and the central wavelength of LPG change with the bending of the fiber. A new peak appears at the shorter wavelength when the fiber is being bent. The changes of the peaks are different for different photosensitive fiber. Those properties have broad application foreground in fiber sensors and tunable filters.

分别从理论和实验上对长周期光栅的折射率特性以及光纤包层半径对长周期光栅特性的影响进行了研究，首次给出了描述光纤包层半径腐蚀和外界折射率改变与长周期光栅共振波长关系的理论表达式，实验与理论和数据模拟的结果很好符合，利用腐蚀光纤包层的方法可以有效地提高LPG的折射率灵敏度；对不同光纤中写入的长周期光栅的弯曲特性进行了实验研究，LPG的透射峰形状及其中心波长随光纤弯曲而发生变化，并且随着弯曲将在短波方向出现新的透射峰，其透射峰的变化规律因所用光敏光纤的不同而不同，这一特性在光纤传感和可调谐滤波器方面有重要的应用前景。

The results show that space finite analysis results are close to test ones, bottom chords suffer axial force and large in-plane bending, and the max stress is nearby each middle internode. The max stress of node crossbeams occurs in No.2 bottom flange, and that of internode crossbeams happens in ones lying in the middle of every internode. The concrete slab is in tension at the longitudinal direction, and also suffers bent at vertical loads. The degree of completely-composite model taking part in the combined actions is about 55%, while that of semi-composite model is 42%-43%. The combination of concrete slab and bottom chord increases the degree of floor system taking part in the combined actions, lightens the burden of bottom chord, and reduces out-of-plane bending of node crossbeams especially the ones near bridgehead. Stress and displacement of main truss can be evaluated by a equivalent plane rigid frame in preliminary design, and effective stiffness of bottom chords are composed of original ones and concrete slab, and the concentrated load from deck can be translated into uniform load.

研究结果表明：空间有限元分析结果与试验结果较吻合；下弦杆受到轴向拉力和较大的面内弯矩作用，各节间最大应力出现在节间中点附近；节点横梁最大应力发生在横梁2的下翼缘，节间横梁最大应力发生在位于端节间中部的小横梁上；混凝土板顺桥向整体受拉，并在竖向集中荷载作用下产生弯曲变形；全结合模型大部分节间内的桥面板参与主桁共同作用的程度为55%左右，半结合模型桥面板的参与程度为42%~43%；桥面板与下弦杆结合能够增加桥面板的参与程度，减轻下弦杆荷载，减少节点横梁尤其是靠近桥头横梁的面外弯曲；对桥梁进行初步设计时，主桁杆件的位移与内力可按照1个等效的平面刚架计算，下弦杆的等效刚度由原下弦杆截面和混凝土桥面板截面组合而成，桥面荷载可转化为均布荷载施加。

Switch can be adjusted back up hand-held point of view (maximum 80 degrees) and leg drop angle (100 degrees);◆ foot bed lowest point from the ground 130mm, the highest point of the bed from the ground 680mm; also elevated bed of different heights;◆ bed in back with plexiglass plate, the user can seat on the bed for X-ray;◆ aluminum fence, can also choose to use push-pull PP flip rail or fence;◆ lift back, the waist angle of tilt, to prevent the sliding body;◆ by about 2 degrees of seat angle;◆ foot can be bent 100 degrees and can easily get out of bed from the bed and sat up and on;◆ foot horizontal position may rise higher than the height of 120mm;◆ with quiet casters with brakes and can be locked and lifted;◆ durability, operational quality, improved operating performance moving bed;◆ equipped with ABS headboard can be instantly demolished;◆ electric device of high quality fully enclosed permanent magnet DC control system;◆ low noise, high safety, long life;◆ new materials with polyester fiber mattresses;◆ can also choose to use low-rebound double-foam mattress or mattress waterproof material;◆ has good air permeability and durability.

可用手持开关任意调节背部上升角度（最大80度）和腿部下降角度（最大100 度）；◆脚部床面最低处离地面130mm，床面最高处离地面680mm；还可升高床面不同高度；◆床体背部采用有机玻璃板，使用者可以座在床上进行X光检查；◆采用铝合金护栏，还可选择采用PP翻动护栏或推拉式护栏；◆抬升背部时，腰部有一定角度的倾斜，为防止身体的滑动；◆采用了约2度的座角；◆足部可以100度弯曲，能够很方便从床上坐起和上下床；◆足部可上升高度比水平位置高120mm；◆采用静音带刹车的万向脚轮，并能进行锁定和解除；◆耐久性、操作性优良，提高了病床搬运的作业性能；◆配有ABS床头板可瞬间拆卸；◆电动装置采用优质永磁直流全封闭式控制系统；◆噪音低、安全性高、使用寿命长；◆配有聚脂纤维新材料床垫；◆还可选择采用低反弹的双层海绵床垫或防水材料床垫；◆具有良好的透气性和耐用性。

This brought fixed cost, but it also is meant at the same time use a source to won't make you singlehanded assume a problem.

这带来了一定的成本，但它同时也意味着使用开源不会让你独力承担问题。

He gained a small fortune in real estate.

他在房地产上发了一笔小财。