可实现的

By means of declinate optical triangulation measuring instrument structure which is firstly proposed, the measured area and resolution of this measuring system are greatly increased, and the high accuracy non－contact measurement of the planeness of a large area plane is realized.

提出的虚拟精密基准的建模与误差补偿技术，解决了在非精密基准上实现精密测量的问题，研制的系统利用现有平台可实现对太阳帆板平面度的高精度测量。

Forbidden-band-width of mono-clinic phase of bismuth vanadate (mBiVO4) is high enough to 2.3-2.4 eV, it could be valence band to carry out entirely that hole band degrade organic pollutants,and the conduction band possesses high oxidizability to make for reduction of photoinduced electron,and oxidation potential of its valence band with 2.4 eV nearby could achieve decomposition of water and degradation of organic pollutants under visible light.

单斜晶相钒酸铋(mBiVO4)的禁带宽度为2.3 - 2.4 eV，它足够高的价带完全可以实现空穴对有机污染物的降解，并且导带位置也有利于光生电子的还原，具有较高的氧化能力，且其价带氧化电位位于2.4 eV附近，可实现在可见光下分解水和降解有机污染物。本文综述了mBiVO4应用于降解污染物、光解水产氧以及光电化学分解水的研究概况，及其在光催化降解有机物等领域的应用前景。

Considering the inconvenience of regulation and difficulty of parameter tunning as AC servo system in practical situation, three ways of intelligent control approach to realize auto-tuning and autorecognization of AC servo system, are proposed, which is a robust controller based on two-degrees-offreedom with no tuning to controller, a auto-tuning controller based on fuzzy reasoning with no inertia recognization but tuning parameter of controller, a strategy recognizing inertia of servo system and tuning parameter or structure of controller automatically. In the same time, these control strategies are analyzed from the theory and reliability. The comparative analysis of three measures on strong and weak points is made by simulation and experiment results.

针对交流伺服系统在实际应用中存在的系统调试不便、参数调整困难等问题，提出了实现交流伺服系统自调整和自识别等智能化控制策略的三条途径：一是具有控制器无调整特点的二自由度鲁棒性控制器；二是惯量无识别但需自动调整控制器参数的模糊推理自调整控制器，三是自动识别伺服系统转动惯量并自动调整控制器参数和结构的方案，从理论分析和可实现性两方面对这些控制方案进行了论述，并通过仿真和实验研究，对比分析了各种方案的优缺点，得到了一些有益的结果。

On the other hand, when the optical filter detunes from the laser wavelength a little, a narrow notch filter with flat passband is realized.

此结构通过调节可调谐窄带滤波器的中心波长可实现高Q与通带相对较平的陷波频率响应的切换。

Aim at the problem of internal quality testing of high-pressure thin-wall welded steel cylinder pipe workpiece,the advantages of the method of using ultrasonic plate wave are obtained through the comparison of five general nondestructive testing methods by the paper.

以高压薄壁焊接钢筒检测为例进行了现场试验，并以X射线检测复测来确认板波检测的可靠性，对比试验结果证明，超声波板波法可有效的发现高压薄壁焊接钢筒焊缝内部缺陷，并可实现快速在线检测，具有广阔的应用前景

In operation, the downhole devices will be laid down with tubings which will move up and down using the operation machine. Since the injection head can rotate in the determined speed, the rotating flow, compared with the conventional stable axial flow, can prevent the sands from depositing in the horizontal annular and washing the screen. The jet from high-efficiency jet nozzle will wash the screen directly with concentrated hydro-power. The working fluid can be clean water, without damage to the formation.

作业时用油管下入该井下装置，利用作业机带动油管上下移动，由于喷头可按照既定速度旋转，返回流体在水平段由常规的平稳轴向流动变为旋转流动，既可实现对防砂管的全方位解堵，又能避免砂粒沉积；高效喷嘴产生的射流直接对着防砂管冲击，能量集中；工作介质为清水，不会对地层带来二次污染。

In operation, the downhole devices will be laid down with tubings which will move up and down using the operation machine. Since the injection head can rotate in the determined speed, the rotating flow, compared with the conventional stable axial flow, can prevent the sands from depositing in the horizontal annular and washing the screen. The jet form high-efficiency jet nozzle will wash the screen directly with concentrated hydro-power. The working fluid can be clean water, without damage to the formation.

作业时用油管下入该井下装置，利用作业机带动油管上下移动，由于喷头可按照既定速度旋转，返回流体在水平段由常规的平稳轴向流动变为旋转流动，既可实现对防砂管的全方位解堵，又能避免砂粒沉积；高效喷嘴产生的射流直接对着防砂管冲击，能量集中；工作介质为清水，不会对地层带来二次污染。

The opening and closing of 'Orchid' is achieved through optional means such as resealable tape, semiadhesive latex or labelled stickers.

在开幕式和闭幕式兰花'是通过可选的途径，如可重复密封的磁带，semiadhesive乳胶或贴标签的实现。

In this paper, a dynamically customizable framework for supporting the autonomy of components is introduced. To implement autonomous components, the framework adopts an approach to repacking existing components.

描述了一种动态、可定制的构件自主化的实现手段及运行平台，试图通过对实现自主构件的方法和手段的探索，为开发具有自主性的基于Internet的软件系统提供一定的实践基础和经验。

Specialized introduction: This specialized raise has the electronic technology and the information system elementary knowledge, can be engaged in each kind of electronic installation and the information system research, the design, the manufacture, the application and the development higher project technology talented person Main curriculum: The signal and the system, the digital signal processing, the correspondence principle, the microcomputer principle and the connection technology, the monolithic integrated circuit principle and the application technology, the DSP technology and the application, the EDA technology, the construction of data, embedded Linux using the programming, the feeling measure technical, the electric circuit theory series curriculum, the computer technology series curriculum and so on individual hobby * software and hardware research and development computer correspondence literature ping pong photography The experience and the personal experience * 2006.6.29-7.8 compile the staff management system management system using the C language, its basic service activity includes: The staff information warehousing, the revision, the inquiry, the insertion, deletes the staff information and so on * 2006.7.10-7.20 monolithic integrated circuit curriculum design period completes the stopwatch the design, namely the initialization timer is 99:99, 0 starts using the monolithic integrated circuit timer fixed time, fixed time arrives when 0s to transmit the signal to cause the buzzer bell, and may realize suspends, the continuation and the replacement function * 2007.7.2- 7.8 practises in Luoyang Big dragon Peony Communication facility Limited company, does has liquid crystal display monitor telephone one, simultaneously visited has served under somebody's banner the correspondence company, and studied has simulated the telephone the design electric circuit, had understood its basic principle * 2007.7.4- 7.18 completed the DSP curriculum in the school to design, realizes the FIR numeral filter, namely transmitted 25 from DSPThe height level, after advocates AC01 D/A to transform the simulation square-wave, then passes to again from AC01 carries on A/D to transform, produces the data signal, after the DSP numeral filter, finally produces the sine wave * 2008.8.1-8.15 to practise in the Zhejiang Jiang hua abundant power tool limited company, studies the computer software and hardware maintenance.

专业介绍：本专业培养具备电子技术和信息系统的基础知识，能从事各类电子设备和信息系统的研究、设计、制造、应用和开发的高等工程技术人才主要课程：信号与系统、数字信号处理、通信原理、微机原理与接口技术、单片机原理与应用技术、DSP技术及应用、EDA技术、数据结构、嵌入式Linux应用编程、感测技术、电路理论系列课程、计算机技术系列课程等个人爱好＊软硬件研发计算机通信文学乒乓球摄影实践经验及个人经历＊ 2006.6.29-7.8 利用C语言编写员工管理系统，其基本业务活动包括：员工信息入库，修改、查询、插入、删除员工信息等＊ 2006.7.10-7.20 单片机课程设计期间完成秒表的设计，即初始化定时器为99：99，利用单片机定时器0开始定时，定时到0s时发送信号使蜂鸣器响铃，并可实现暂停、继续和复位功能＊ 2007.7.2- 7.8 在洛阳巨龙牡丹通信设备有限公司实习，做有液晶显示屏电话机一部，同时参观了旗下通信公司，并学习了模拟电话的设计电路，懂得了其基本原理＊ 2007.7.4- 7.18 在校完成DSP课程设计，实现FIR数字滤波，即从DSP发送25个高低电平，经主AC01 D/A 转换成模拟方波，然后再传给从AC01进行A/D转换，生成数据信号，经DSP数字滤波，最后生成正弦波＊ 2008.8.1-8.15 在浙江华丰电动工具有限公司实习，学习电脑软硬件维护。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。