可实现的

Intensity correlated imaging,which can realize the lensless Fourier-transform,the diffraction tomography and the two-step phase-retrieval algorithm are combined together to realize intensity correlated three dimensional diffraction tomography by using 650 nm pseudo-thermal light.

利用强度关联成像技术可实现无透镜傅里叶变换的特点，并结合衍射层析技术和二步相位恢复算法，使用波长为650 nm的赝热光实现了强度关联三维衍射层析。

The polymeric resin NDA-8 was employed to treat the industrial wastewater from hydrogenated deoxidization process in tolylene diisocyanate production and good performance of adsorption and desorption was shown.

经树脂吸附处理，废水中主要污染物2，4-二氨基甲苯和2，6-二氨基甲苯均得到完全去除，COD由6 300mg/L降为150mg/L以下，达到国家二级排放标准，采用稀盐酸可实现树脂的完全再生，高浓度脱附液经调碱和结晶，可回收2，4-二氨基甲苯和2，6-二氨基甲苯

This design has solved the problem which many wired networks are not easy to realize, For example: But the extension is bad, Transportability inferior question.

本设计解决了好多有线网络不容易实现的问题，如：可扩展性差，可移动性差等问题。

Results indicate:(1) The newly developed simulation technology can form fairly average and easily controllable back pressure downstream the inlet, so it can he used to investigate the back pressure characteristics of hypersonic inlets.(2) By regulating the valve of injection pipe, the simulation technology can realize the switch of hypersonic inlet started state and unstarted state in about 8 milliseconds, so it is suitable to investigate the starting/unstarting/resarting problem of hypersonic inlets.

结果表明：(1)所提出的凹腔喷流技术可在进气道下游形成较为均匀的、可控的背压环境，因此可用于进气道的反压特性研究；(2)适当调节凹腔的喷流总压，并在实验中实时控制阀门的开度，凹腔喷流技术能够在较短的风洞实验时间内（约8s）实现进气道起动、不起动、再起动流态之间的切换，因此可用于进气道的不起动／再起动特性研究。

This article according to the energy conservation to reduce the platoon, the intelligence, multi-purpose is the design idea, take refrigerates to install as the drying system core, the 80C51 monolithic integrated circuit designs one for the control core to satisfy the design requirements, the work stable condensation type multi-purpose to do the closet, can realize does the clothes, the strong effect to do the clothes, the hot blast ordinary fresh, fixed time to do the clothes and so on many kinds to do the clothes function, simultaneously may realize dehumidifies, the heating function, the collection closet, the clothes drier, the humidity reducing set, the heater in a body, can the real-time observation system's running status, and when breaks down can demonstrate and send out the alarm promptly.

本文根据节能减排、智能、多功能为设计理念，以制冷装置为干燥系统核心，80C51单片机为控制核心设计出一台满足设计要求、工作稳定的冷凝式多功能干衣柜，能够实现普通干衣、强效干衣、热风清新、定时干衣等多种干衣功能，同时可实现除湿、供暖功能，集衣柜、干衣机、除湿机、供暖器于一体，能够实时监测系统的运行状态，并在发生故障时能及时显示并发出报警信号。

The two drums transmissions are intercrossed for more reasonable weight distribution, realizing higher compaction quality in operation.3.Dual frequency and amplitudes vibration system may obtain optimal compaction for different quality and course materials.

振动系统：双频率和双振幅设置，保证了整机在压实不同性质、不同厚度的铺层时，均可达到最佳的压实效果；可实现单振、双振、静碾等多种选择振动模式，并可在液压元件长期使用磨损后进行频率的补偿调节。

Keying to achieve the image and fill, and to achieve the integration of multiple images.

详细说明：实现了图像的抠像和填充，并可实现多幅图像的融合。

The leaching rate of Bi and Sb are up to 96%、89% respectively and silver will be enriched 10~12 times in the residue.98% of Bi in the leaching liquid can be recycled in the form of Bi2S3 by sulfating, 92% of Sb can be converted to antimony oxide powder after neutralization by diluted H2SO4 and glycerin can be recycled meanwhile.

浸出液中98%的Bi可通过硫化法以Bi2S3的形式回收，92%的Sb可加稀硫酸中和得到锑氧粉，同时可实现甘油的再生。

From factorial experiments, it was observed that in conventional extrusion treatment, defatted soy flour, aqueous acidic leached soy protein concentrate and soy protein isolate was able to be texturized, whereas SPC was not.

通过挤压实验可知，在常规的挤压条件下，低温粕、酸法SPC和大豆分离蛋白均可实现组织化，而醇法SPC无法实现有效的组织化。

The paper investigates both block-type pilot linear minimum mean square error algorithm and IEEE802.16 OFDM channel estimation analysis. Simulation results confirm the block-type pilot structure is more suitable for IEEE802.16 system. An optimal pilot setting algorithm, based on space frequency domain, is explored and the pilot chart is presented. The proposed algorithm finds its application in MIMO-OFDM. Simulation results show the algorithm presents a good approximation to the perfect channel state information curve, with about 2dB difference in SNR. The simulation results also demonstrate the algorithm achieves fairly high stability in the environment of fast fading, performance of the proposed algorithm is better that of pilot training channel estimation.3. Taking into account the characteristics of IEEE802.16 OFDM system, OFDM system simulation platform is constructed in Matlab, exploiting simulink as a tool. OFDM modulation and demodulation simulation system are configured on LabVIEW platform. All the system signal processing is simulated, including defining system parameters, designing modulation model, and verifying all the proposed algorithms under different environments, such as white Gaussian noise, multi-path fading, with or without guard interval etc. Bit error performance is evaluated. The research provides valid theoretical basis for practical OFDM system performance evaluation.4. Taking advantage of software radio, the paper designs a hardware platform with both 256-IFFT/FFT and 512-IFFT/FFT OFDM schemes co-existing in one platform. You can predetermine one from the two schemes to carry out almost the same model function with different system performance and parameter setting.5. Referring to IEEE802.16 standard, the paper proposes a design method for generating signals and frames suitable for laboratory investigations implemented in laboratory environment.6. Based on 6701evm digital evaluation card, combined with analogy front-end, the paper designs a DSP software model to deal with baseband signal processing. An overall OFDM scheme, with modulation and demodulation function, is accomplished.

讨论分析了MIMO-OFDM中一种基于空频域的最优导频设置算法，给出了导频图案，通过仿真实验表明，该算法与理想的信道状态信息曲线非常接近，信噪比差距约在2dB左右，并且在快衰落条件下具有较好的稳定性，其性能要优于基于前导训练的信道估计方法。3、根据IEEE802.16OFDM系统特点，论文分别在Matlab中应用Simulink工具构建OFDM系统仿真平台、在LabVIEW平台上实现了OFDM调制解调仿真系统，模拟了整个系统的信号流程，进行了OFDM仿真系统参数的选择和调制模块的仿真设计、论证各算法性能，并根据各种不同的条件：例如高斯噪声、多径衰落、有无保护间隔等，对系统的误码特性进行了评估，为正确评价实际OFDM系统的性能提供了有效的理论依据。4、论文以软件无线电思想作为指导，提出了以256点IFFT／FFT为核心和以512点IFFT／FFT为核心的两种OFDM算法模式并存于同一个硬件平台、且可预选的方案，它们在参数选取和性能指标上有所差异，均实现了相似的模块和功能。5、论文参考IEEE 802.16无线网络标准的参数设置，针对本设计系统的应用环境和系统硬件的性能速率，提出了一种应用于实验室环境的信号结构、帧格式等参数设计。6、论文基于TI公司的6701evm数字评估板卡，结合模拟前端搭建数字中频平台，设计了基带处理的DSP软件模块并进行系统调试，基本实现了一套完整的OFDM调制解调方案。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。