可加热

The RITA System, a procedure developed by RITA Medical Systems Inc., uses radiofrequency energy to heat tissue to a high enough temperature to ablate it, or cause cell death.

由RITA医药系统公司制造的RITA系统，可通过射频的能量去加热组织，其温度之高足以融化肿瘤，甚至使肿瘤细胞死亡。

Analogous complexes 3a" and 4a"= CpRu(PPh32, Ar = para-C6H4OMe containing methoxy group at the para-position of gem-diphenyl group were similarly obtained from protonation of the corresponding acetylide complexes via formation of vinylidene intermediate. But only complex 3a'= CpRu(PPh32, Ar2 = fluorenyl is stable in solution, and decomposed to unidentified complex when heated to reflux in THF. Deprotonation of complex 4a in the presence of base gives neutral acetylide complex 6a.

在两个相邻位置的苯基对位位置上接有一甲氧基的衍生物3a"和4a"也可利用类似的质子化反应合成，唯有错合物3a'= CpRu(PPh32， Ar2 = fluorenyl 可以稳定於溶液中，不会进行上述反应，如将其溶於四氢呋喃溶液加热至沸腾则会分解产生无法鉴定的化合物。

The retorting process of coals using hot char as solid heat carrier lines up every single process which is needed for the production of CMS.

以灵武煤半焦GLW-72为原料，粉碎至粒度＜160目，混入40wt%的亚硫酸盐纸浆废液成型，将成型物在N〓气保护下，以10℃/min的升温速率加热到900℃碳化45min，冷却到室温所得碳化产品用于变压吸附空分，可获得含N〓96.3vol%的富N〓气体；将上述产品进一步作碳沉积处理，可获得空分性能达98.4vol%的炭分子筛，该结果与在同一空分装置上测得的国外炭分子筛的空分性能（98.23vol%）相当。

Results show that the mullite grogs can be gained by the method at 1700℃ as long as the control of the chemical composition of ingredients(content of Al2O3 and ratio of Al2O3/ SiO2 ,etc.) with apparent porosity＜2.5% and bulk density≥2.75g/cm3; the heating process can be divided three stages, which are formation of primary mullite, secondary mullitization stage and liquid phase sintering stage.Key words bauxite, coal gangue, mullite grogs

结果表明，只要控制好混合料的化学组成（Al2O3含量、Al2O3/SiO2比等），就可采用此工艺制备出莫来石料，其烧结温度为1700℃，所得莫来石料的显气孔率大于2.5%、体积密度大于或等于2.75g/cm3；加热过程可分为一次莫来石形成、二次莫来石化和液相烧结3个阶段。

To invest in China to establish a subsidiary, the main production to CT, PP, OPS, PET, HIPS material, such as one-time environment-friendly plastic food packaging containers, the company has developed a series includes meals together, instant noodles / food, ice cream, Magic dike products, packaging supplies, such as supermarkets and fresh food packaging containers of plastic products, can also be based on customer requirements to develop new plastic food packaging containers, Product Features: can hold microwave heating, can be resistant to cold storage, and environmental protection.

我司是著名跨国塑料食品包装生产厂家--日本中央化学株式会社在中国投资建立的子公司，主要生产以CT、PP、OPS、PET、HIPS等为材质的一次性环保型塑料食品包装容器，公司已开发出一系列包含餐合、方便面/食品、雪糕、魔圩制品、超市生鲜包装耗材等的塑料食品包装容器产品，亦可根据客户要求开发新的塑料食品包装容器，产品特点：可放微波炉加热、可耐低温贮藏、环保等。

The hot compress bag placed in the microwave oven, with microwave heating 3 - 5 minutes (according to various different parts of the salt packet) will be added to the hot salt bag temperature, such as the reheating temperature is too low when the heating time should not exceed 1 minutes followed by analogy (medicine bag and outer bag into the microwave oven do not heat), after the hot compress bag of microwave into the outer bag and then put hot compress parts of medicine packets according to the disease may be a long-term wear, essential oils can be with the hot compress bag or medicine bag according to the disease situation in combination.

将热敷袋放置微波炉中，用微波加热3--5分钟（根据各种不同部位的盐包）将盐袋加至烫手的温度。如温度过低二次加暖时每次加暖不得超过1分钟依次类推（中药包和外袋请勿放入微波炉加暖）。将微波后的热敷袋放渗透外袋中然后放置暖敷部位，中药包根据病情情况可长期佩带，精油可配合暖敷袋或中药包根秋季的激素水果据病情情况结合使用。

Under atmospheric pressure, binary nanocrystalline sulfides and selenides such as CdS、CdSe、PbS、 PbSe、Cu〓Se、Ag〓S、Ag〓Se、SnSe are obtained at room temperature; nanocrystalline CdTe and PbTe are obtained by heating. Nanocrystalline NiSe〓、CoSe〓 and FeTe〓 are obtained by hydrothermal conditions.

根据硫、硒歧化的碱溶液与碲歧化的碱溶液稳定性的不同，发现在室温条件下可成功获得CdS、CdSe、PbS、PbSe、Cu〓Se、Ag〓S、Ag〓Se、SnSe等二元硫化物与硒化物纳米晶；加热条件下可成功获得CdTe与PbTe纳米晶；而NiSe〓、CoSe〓及FeTe〓的合成则要在水热条件下进行。

The practical example indicates that the method used in complex countercurrent multi-effect evaporation system is fast and accurate.The vapor consumption of three-effect evaporation with condensed water flash is decreased by about 10% for condensation of NaOH solution. Loss of heat energy increases for preheating of feed with fresh vapor or extra vapor withdrawal.

算例表明：模型可用于复杂逆流多效蒸发系统的快速求解；对三效逆流蒸发NaOH溶液系统，采用冷凝水闪蒸可节省加热生蒸汽 10 %左右，节能效果显著；逆流多效蒸发采用生蒸汽或引出额外蒸汽预热原料液不仅不会节能，反而造成热能损失

At present, laser process technology develops fast, since a laser light can obtain many good characteristics such as good direction, high energy density to focus the beam at a micrometer level, small pulse width ranging from dozens of Nanoseconds to dozens of Picoseconds, heating material immediately, decreasing heat effect on materials and so on.

由于激光束具有良好的方向性和高能量密度，可将光束聚焦到微米量级；由于激光束的脉冲宽度可达数十纳秒到数十皮秒，能够快速加热，对材料的热影响效应减小；因此，激光的以上优点为微加工提供了有利的条件，同时也促使激光加工技术迅速发展。

DSC thermo-analysis showed that both of epoxy resins and blended resins had an exothermic peak during the period of thermal-scanning due to the curing reaction. Comparison between different kinds of liquefied wood, blending resins that using the liquefied Japanese cedar of LW-C as the raw material would undergo more degree of cross-linking reaction. They released more reaction heat, and formed a more complete cross-linking structure. However, heat treatment could promote an advanced cross-linking reaction of room temperature cured resins. DSC isothermosetting analyses showed that the curing reaction of both epoxy resins and blended resins conformed to Arrhenius kinetic model. The time needed to achieve 95% of curing reaction was shorter for blending resin than that of epoxy resin.

由DSC热分析显示环氧树脂与掺合树脂在热扫描过程中均出现硬化反应放热峰，其中以液化柳杉LW-C为原料之掺合树脂在硬化过程可进行较多之架桥反应，其反应放热量较大，硬化树脂之架桥结构较完整，而加热可促进常温硬化树脂进一步之架桥反应；由DSC等温硬化性分析显示环氧树脂与掺合树脂之硬化反应均符合Arrhenius动力学模式，添加液化柳杉之掺合树脂达95%硬化率所需时间较环氧树脂短。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷