口上的
- 与 口上的 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The notch in the end of an arrow that fits on the bowstring.
箭上的凹口箭末端的 v形凹口,用来搭弓弦
-
The proximal and distal nerve stumps were sutured l cm apart, in an end-to-side fashion like "π", to the epneurium windows, opened by removing the epineural sheath on the intact tibial nerve trunk with 1 mm long.
方法将大鼠右侧腓总神经在胭窝处剪除约5mm后,将断裂的腓总神经近端和远端分别就近与同侧胫神经上的外膜窗施行端侧吻合,吻合口间距约10mm;动物存活24个月后,将手术侧近端吻合口以上胫神经剪断,再将辣根过氧化物酶注入远段腓总神经干内,72h后取材并经四甲基联苯胺显色显示脊髓L3-6节段神经元和L4、L5脊神经节细胞,同时取腓总神经远段行电镜观察神经纤维再生状态。
-
Full of strange oaths and bearded like the pard,jealous in honour, sudden and quick in quarrel,even in the cannon's mouth. and then the justice
然后是一个军人,满口发着古怪的誓,胡须长得像豹子一样,爱惜着名誉,动不动就要打架,在炮口上寻求着泡沫一样的荣名。
-
SPRUE HOLE: A hole located in sprue gate which is created by a void in the sprue.
直浇口:位於直浇门上的由注入口内的空泡引起的洞。
-
METHODS:Two hundred and seventy-one eyes of 219 patients with hard nucleus cataract, grading level IV or V, were operated with anteroposterior interceptive chop method for splitting the nucleus, and then with phacoemulsification. RESULTS:The hard nucleus of the 271 eyes were successfully routed. The average phaco time was 57.4 s.
对219例(271眼)级以上硬核白内障采取前后夹击劈核法,经充分水分离和水分层,吸除硬核前的皮质及软核后,乳化头退至前囊口上缘,劈核器轻压核下方,停止灌注让核上缘随前房变浅脱出囊袋口,乳化头顺势抵住核上缘,灌注加深前房后,乳化头滑入核后面,劈核器置核前面,前后夹击将核劈碎乳化吸出。
-
The heart of fools is in their mouth: and the mouth of wise men is in their heart.
愚人的心在口上,明智人的口却在心里。
-
It use two disparting surface,and its frame is fast.It use point moulding gob,so,it can fall off automatism.When it is pulled out ,the pulling pole pull the product and accomplish the pulling of its side concave . The design project is divided into two parts. The first part is about the working theory and application of a plastic injection mould, the principle of designing and the introduction of the production about plastic mould.
它采用双分型面分型,结构紧凑;采用点浇口,且浇口可以自行脱落;顶出时,由推杆和斜顶杆顶出制品并完成制品内侧凹的抽芯;模具定模上的水道以多支回路分别冷却,动模一侧的型芯由三组水道分别冷却。
-
It use two disparting surface,and it's frame is fast.It use point moulding gob,so,it can fall off automatism.When it is pulled out ,the pulling pole pull the product and accomplish the pulling of it's side concave . The design project is divided into two parts.
它采用双分型面分型,结构紧凑;采用点浇口,且浇口可以自行脱落;顶出时,由推杆和斜顶杆顶出制品并完成制品内侧凹的抽芯;模具定模上的水道以多支回路分别冷却,动模一侧的型芯由三组水道分别冷却。
-
Hole in a platform on a mast through which a sailor can climb without going out on the shrouds .
在桅杆平台上的一个口,通过此口,海员可以不必用桅杆的左右支索就能自动上升。
-
MODEM used if the interface is USB port, then plug into USB port on another try, If it is really found that there is a hardware failure, then the suppliers had no choice but to repair or replace the hardware.
如果MODEM用的接口是USB口,则插到另一个USB口上试试,如果发现真的是出现了硬件故障,那么只好到供应商处维修或更换硬件了。
- 推荐网络例句
-
I didn't watch TV last night, because it .
昨晚我没有看电视,因为电视机坏了。
-
Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.
今年以来,在北京的很多小区里,电梯液晶电视被撤了下来。
-
I'm running my simile to an extreme.
我比喻得过头了。