变热

On the basis of Equivalent Heat Drop Theory of changeful heat quantity, a mathematical description that heating value enters or leaves thermodynamic system by absolute magnitude has been deduced.

在变热量等效热降法理论的基础上，推导出热质进出热力系统的数学描述———纯热量法。

In this paper,the internal energy and heat of the polytropic process ,the adiabatic process and the isothermal processes of the varying mass system are discussed.

讨论了变质量系统的多方过程、绝热过程及等温过程的能量关系，并与常质量系统的多方过程、绝热过程及等温过程的性质进行了比较。

Department of Scientific History and Archaeometry; Graduate University of Chinese Academy of Sciences; Beijing 100049;4.Institute of Archaeology; Chinese Academy of Social Sciences; Beijing 100710; China;The fabrication technologies in terms of phase composition,structure,firing temperature,porosity,density and water permeability of ceramic water pipes and contrastive ceramic tilesexcavated from Anyang Yin Ruins of Shang dynasty were studied by X-ray fluorescence,X-ray diffraction and dilatometer,respectively.It was found that the contents of CaO,K2O,MgO and P2O5 in CWP were relatively higher than those in contrastive CT.The difference was further confirmed by the mass ratio of flux...

采用X射线荧光、X射线衍射、热膨胀等分析手段对比研究了安阳商代陶水管的制作工艺，发现陶水管化学成分中各类熔剂的质量分数均略高于对比陶片中熔剂的质量分数，CaO、K2O、MgO等助熔剂与A l2O3的质量比进一步证实该现象，而这种差异性则外在地表现为陶水管的气孔度低于对比陶片以及陶水管热膨胀曲线中出现玻璃化现象，该结果表明陶水管原料应为一种易熔粘土，或者在沉淀粘土中人为地掺和了草木灰类掺和料，这有利于陶水管烧制与成型，有助于熔剂在熔融状态下，较好地进入陶水管中的空隙，使陶水管变得更加致密，一定程度上有利于防止陶水管的渗水，显示出陶水管制作工艺的特殊性。

An axle or journal box, as on a railway car, that has become overheated by excessive friction.

热轴由于过分摩擦而变得过热的轮轴或轴颈箱，如火车上的

The results of prediction agree well with the experimental ones. It proves that the thermo-mechanical analysis、the neural network models of flow stress and microstructure as well as the numerical simulation system developed combining coupled thermal-mechanical rigid-viscoplastic FEM with BP neural networks are reliable to describe the hot back extrusion process of Ti15-3 alloy truly. The simulation system has good prediction capacity for the microstructure evolution of Ti-15-3 alloy during hot backward extrusion and after solution treatment. It can be used to replace the experiments for predicting the flowing laws and the distribution of microstructure.

由此证明，本文的热力耦合理论分析、流变应力及显微组织的神经网络预测模型以及采用三维热力耦合刚粘塑性有限元与三层向后传播的人工神经网络相结合的方法开发的Ti-15-3合金筒形件热反挤成形的显微组织数值模拟系统是可靠的，能够真实地描述Ti-15-3合金热反挤工艺过程，并对其反挤成形及固溶处理后的显微组织具有很好的预测能力，可以被用来代替预测其反挤成形规律和组织分布情况的试验。

The thermodynamic parameters of thermal and chemical denaturation were determined for bIgG using both methods.

DSC和荧光光谱实验结果表明， bIgG的热变性和热化学变性过程都是较复杂的不可逆过程，这个过程可被看作一个三态变构过程。

It indicates that the raw materials can be stored in temperature of 0-4℃ for 60 days, they must be immersed in clean water for more than one hour before processing, and peeling be carried out in flowing water; that color preserving solution should be 1.0% NaCl+0.2% citric acid+0.5% Vitamin C+110ppm dichloro isocyanuric acid sodium; that combined browning inhibiting solution is conspicuously effective, and immersion time better be around 20 minutes; that sterilization solution ought to be 200ppm dichloro isocyanuric acid sodium+0.5% ascorbic acid+0.3 citric acid, and 10 minutes' immersion will achieve the effect of sterilization and inhibiting browning; and that after 20-21 minutes of quick-freezing in temperature of -31℃~-32℃, the products can be preserved under -18℃ for a whole year.

通过对速冻牛蒡加工过程中原料储存、削皮方法、护色、浸泡时间、无热杀菌、包装形式等参数进行研究表明：原料0-4℃可储存60天，加工前用清水浸泡1小时以上，削皮时在流水中进行，护色液筛选的1.0% NaCl＋0.2%柠檬酸＋0.5%维生素C十110ppm二氯异氰脲酸钠；复合褐变抑制溶液在抑制褐变方面有显著的效果，浸泡处理时间为20分钟为宜；杀菌液为200ppm二氯异氰脲酸钠＋0.5%抗坏血酸＋0.3柠檬酸，浸泡10分钟即可达到灭菌和抑制褐变的作用；经-31℃~-32℃温度下速冻20~21分钟，产品在-18℃条件下可储存一年。

The phenomenon demonstrates that the perovskite is a stable state with low free energy. The (1-x) PMN- x PT system has a morphotropic phase boundary separating the tetragonal and rhombohedral phases. The MPB is located in the vicinity of x = 33%. The PMN-PT ceramics near the phase boundary possesses excellent piezoelectric performance. d33 can reach to 540 pC/N. kt and kp can be up to 0.45 and 0.62, respectively.

在准同型相界附近，PMN-PT陶瓷材料具有较好的压电性能，d33可达540 pC/N，kt、kp分别可达0.45和0.62；在准同型相界附近，极化后的（1-x）PMN-xPT陶瓷材料（0.22 x 0.35）的介电常数在温度诱导FR-FT相变过程中发生突变；PMN-PT陶瓷材料在FR-FT相变过程中呈现出一个热释电峰，反应了自发极化在相变过程中发生了非线性的变化。

It is considered that when temperature begins to fall down under Ms, martensite and the untransformed mother-phase are in a kind of thermobalance. We try to use the equations in marten- site transform to get the mathematical relationship between the dynamics of the microclamp and the temperature, also including some useful results for design and fabrication of the microclamp. We hope these results will form the work principle base for SMA microclamp.

认为在Ms点以下，马氏体与未转变的母相奥氏体处於某种平衡状态，利用变温马氏体相变公式，处理SMA微夹钳的热力学和动力学之间的定量或定性的数学关系，得出一些对於设计和制造有用的结论，从而为深入研究SMA微夹钳的热弹性马氏体相变的工作原理打下理论基础。

Melamine formaldehyde resin was used to encapsulate a phase change material which melt point is 20℃ by in situ polymerization.

采用原位聚合法用三聚氰胺甲醛树脂包覆一种相变点为24℃相变材料A，制得相变储热微胶囊。

With Death guitarist Schuldiner adopting vocal duties, the band made a major impact on the scene.

随着死亡的吉他手Schuldiner接受主唱的职务，乐队在现实中树立了重要的影响。

But he could still end up breakfasting on Swiss-government issue muesli because all six are accused of nicking around 45 million pounds they should have paid to FIFA.

不过他最后仍有可能沦为瑞士政府&议事餐桌&上的一道早餐，因为这所有六个人都被指控把本应支付给国际足联的大约4500万英镑骗了个精光。