变热

In the one half part, according to the strontium nature, thermodynamic calculation of correlative reaction and the principle of the vacuum aluminothermy reduction process, with the laboratory findings of preparation strontium by vacuum aluminothermy reduction compared and analyzed in different parameter conditions, a variety of factors which effect the decomposition rate of SrCO_3 and the percent reduction of strontia are gotten out. The factors include that the decomposition rate of SrCO_3 is influenced by different addition and pressure. They also include that the percent reduction of strontia is influenced by excess coefficient of reducing agent aluminium powder, the particle size of raw material or reducing agent, the pressure of barbecuing, temperature and reduction time. According to those, we can draw the conclusion as follows:(1) Decomposition temperature of SrCO_3 is decreased by adding carbon and alumina in different degree.(2) With quantitative carbon added under the vacuum condition, the decomposition temperature of SrCO_3 is decreased obviously, which can fall 150℃ compared with atmospheric pressure.(3) In keeping 1150℃ of 2.5h, under the 5Pa vacuum condition, the decomposition rate of SrCO_3 nearly keeps in 99% steadily.

在前半部分的真空铝热还原法中，根据锶的性质、相关反应的热力学计算及真空铝热还原法原理，通过对不同参数条件下的真空铝热还原法生产金属锶的实验结果的分析比较，得出了影响SrCO_3的分解率和氧化锶的还原率的种种因素，具体因素包括不同添加剂、不同气压对SrCO_3分解率的影响，还原剂铝粉的过量系数、原料与还原剂的粒度、制团压力、温度和还原时间等对氧化锶还原率的影响，得出具体结论如下：(1)添加碳和Al_2O_3能不同程度的降低SrCO_3的分解温度；(2)真空条件下加入一定量的碳可显著降低SrCO_3的分解温度，比之常压下可降低150℃之多；(3)在1150℃恒温2.5h、真空度达到5Pa的条件下，SrCO_3的分解率几乎保持稳定在99％；(4)氧化锶的还原率随还原剂过量系数的增大而增大，但是趋势越来越小，当过量系数超过25％后，氧化锶的还原率几乎不再增加；(5)氧化锶的还原率随原料与还原剂的粒度的变细而增加；(6)氧化锶的还原率随制团压力的增加而增加，但超过一定值后，氧化锶的还原率反而会下降；(7)氧化锶的还原率随还原温度的升高而增加；(8)氧化锶的还原率随还原时间延长而增加，在本实验条件下，超过2.5h趋于稳定。

Development and application of software and hardware of open type cast iron thermal analysis of cast iron melt inspection have been reported with explanation of each module function of analysing and calculating chemical composition,as-cast mechanical properties and structural characteristics,solidification phase transformation heat,some thermal phisical parameters based on solidifying and cooling curve of samples.

报告了用于检测铁液熔炼质量状况的开放式铸铁热分析软、硬件系统的研制与应用情况，并系统地阐述了根据热分析试样的凝固冷却曲线实现对铁液化学成分、铸态下的力学性能和组织特征以及对凝固相变热和某些热物理量进行分析和计算的各子模块功能。

According to the composition of elements of fuel,thermochemical forms,combustion heat,and time-dependent relations of oxygen concentration acquired during fullscale tunnel fire experiment,the formulae are given for calculating di- mensionless burning rate, released heat rate ,and ratio of medium decalescence.

根据燃料的元素构成、热化学反应式、反应物和生成物的焓变以及燃烧过程中监测到的烟气中氧气浓度随时间变化规律，提出了计算某一时刻燃料燃烧速率、释热速率和介质吸热率的关系式；通过实际规模的火灾试验，对其数据的计算表明，对木质类巷道火灾，最大比燃烧速率为0.193，最大释热速率约为1～3.5 MW，介质的吸热率为22

Aiming at copper cable nigrescence problems in process of producing cable by using white PVC colloid particle,the PVC partiles was tested by TGA ,DSC, TGA -FTIR.

针对使用白色聚氯乙烯胶粒生产的铜质电缆线氧化变黑问题，对PVC胶粒进行了热重分析、差示扫描量热分析、热重-红外光谱联用分析等一系列测试，分析PVC胶粒在规定的加工条件下是否会引起铜质电缆线发黑。

In the paper, the electrode system of the original TL/TSC measurement instrument is improved, which greatly facilitates sample exchange and increased liquid nitrogen's running and cooling speed. Through long time and repeated practice we finally find an effective method to prepare films. We've synthesized a new kind of organic photo-refraction material nitryl azobenzene grafting PVK and characterized it with IR spectra. We've also synthesized 5OCB and found the optimal mass ratio of PVK/5OCB/C60-49.8:50:0.2, and given the two-beam coupling testing result.

本文的主要工作是：首先对传统热发光和热激电流测量装置的电极系统进行了改进，使其在换取样品，液氮流动、冷却速度等方面都有了很大提高；摸索了较适合于热激实验的成膜方法；合成了一种新型的有机光折变材料硝基偶氮苯接枝PVK，并对其做了红外谱表征；合成了生色团物质5OCB，找到PVK/5OCB/C_(60)的最佳配比为49.8：50：0.2，并对该体系做了初步的光学测试。

The results show that dynamic softening is easy to occur in these ingots and flow stress becomes steady finally; the material constants of hot deformation are procedural parameters that stress-level coefficient α, strain rate sensibility exponent m and deformation activation energy Q are all increased with strain increasing, while stress exponent n is decreased gradually; the values α and m of the alloy homogenized are the biggest and the value n is the smallest, dynamic softening effect of the alloy is the most obvious, which can deform evenly; influence of strain on the value Q of the alloy homogenized is a little and the average value of Q is only 176.5kJ/mol, so the alloy is easy to deform; the alloy matrix shows the regular recrystallization grains when the strain is 50%; dislocation cell structure re-formed in the grains with increase of strain.

结果表明：经不同处理的Al-1Mn-1Mg合金均易发生动态软化并最终呈现稳态流变特征；热变形材料常数是过程量，随应变量的增加，应力水平参数α、应变速率敏感性指数m和热变形激活能 Q 随之增大，而应力指数 n 则逐渐减小；均匀化退火后，铝合金的α和m值最大而n值最小，动态软化效果最明显且变形均匀，在该状态下，铝合金的 Q 值受变形量影响小，平均仅为176.5kJ/mol，易进行热变形；当应变量为0.7时，基体呈现规则的再结晶晶粒组织，随着应变量的增加，晶内重新形成了位错胞结构。

Temperature and the Zeroth Law of Thermodynamics, Simple Thermodynamic System, Work, Heat and First Law of Thermodynamics, Kinetic Theory of the Ideal Gases, The Second Law of Thermodynamics, The Carnot Cycle and the Thermodynamic Temperature, Entropy, Phase Diagram of a Pure Substances, First-Order and Second-Order Phase Transitions, Introduction to Statistical Mechanics (including Partition for Canonical Ensemble, M-B 、 F-D 、 B-E distributions), Thermal Properties of Solids.

热物理 ( S0437)(3，0)/热力学( S0434)(3，0)温度及热力学第零定律，简单热力学系统，功，热及热力学第一定律，理想气体动力论，热力学第二定律，卡诺循环与热力学温标，熵，纯物质的相图，一阶与二阶相变，统计力学简介(包括：正则系综的配分函数，马克斯威尔-玻兹曼分布，费米-狄拉克分布，玻色-爱因斯坦分布等)，固体的热性质。

In order to study the thermal evolution of the Barbados accretionary complex,spatial coordinate and material coordinate are combined to handle the problem ofadvective heat transfer produced by tectonic movements.

为研究巴巴多斯增生复合体构造热演化的过程，采用空间坐标系和质点坐标系相结合的方法，在处理构造运动和变形的平流热效应时，并用变网格法及固定网格中的迎风法，成功地对该区域进行了二维有限单元法热模拟。

Single-Event Cracking Temperature of Asphalt Pavements Directly from Bending Beam Rheometer Data Aroon Shenoy1 Abstract: Asphalt pavements under low temperature conditions develop transverse cracks as a result of one or a combination of three distress mechanisms:（1）single-event thermal cracking;（2）thermal fatigue; and（3）load-associated thermal cracking.

单项裂解温度的沥青路面，直接从弯梁流变数据aroon shenoy1摘要：沥青路面在低温条件下，发展横向裂缝是由于一项或多项三名遇险机制：( 1 )单项的热裂解；( 2 )热疲劳；( 3 )负荷相关热裂解。

Approved that the alterative rock information and metallic ore deposit has high relativity.

研究了热液围岩蚀变类型和蚀变条件以及蚀变类型与矿产种类的关系，说明蚀变岩石信息与金属矿床有较高的相关性。

With Death guitarist Schuldiner adopting vocal duties, the band made a major impact on the scene.

随着死亡的吉他手Schuldiner接受主唱的职务，乐队在现实中树立了重要的影响。

But he could still end up breakfasting on Swiss-government issue muesli because all six are accused of nicking around 45 million pounds they should have paid to FIFA.

不过他最后仍有可能沦为瑞士政府&议事餐桌&上的一道早餐，因为这所有六个人都被指控把本应支付给国际足联的大约4500万英镑骗了个精光。