变形

Through the comparison of energy, the asymmetric solution is stable while the symmetric one is revealed unstable.

通过变形发生分岔前后的能量比较发现，分岔后的对称变形是不稳定的，而非对称变形是稳定的。

In order to study the stability of stratified rock slope in Zhu-Cheng road and its reinforcement method, the potential deformation and slipping mechanism of slope were analyzed using insitu-investigation and stereographic projection analysis method. The numerical calculation model for stratified rock slope was founded with UDEC software. The deformation of rock mass was analyzed in the excavation procedure, and the long-short compound bolt reinforcement structure was proposed according to the deformation failure mode of stratified rock slope.

摘 要：为了研究竹城公路层状岩质边坡的稳定性及防治措施，通过现场调查和赤平投影分析边坡潜在变形滑动机理；利用UDEC软件建立层状边坡数值计算模型，分析开挖过程中岩土体的变形情况；根据变形破坏模式提出层状岩质边坡的长短锚杆交替复合支护结构。

Some kinds of culculation methods of elastic deformation of point contact surface are compared.

二。通过编程计算，比较和总结了点接触EHL弹性变形计算的几种计算方法，首次提出了在各层网格上分别采用不同的弹性变形计算方法的思想，以保证在多重网格法求解中变形转换的精度一致，计算时间最少。

This is not a dramatic or theatrical transformation, but a surreptitious transformation.

这种变形不是一种戏剧化或舞台化的变形，而是一种暗中的变形。

Microstructure evolution in eutectoid steel during warm deformation in the temperature range from 600 to 700℃ was investigated by simulating hot compression test, SEM and thermomagnetic measurement. The effects of deformation and subsequent annealing on the spheroidizing of pearlite, refining of microstructure and dissolution of cementite were studied.

利用热模拟压缩变形、SEM和热磁法实验，研究了共析钢在600~700℃变形过程的组织演变规律，探讨了变形及随后保温过程对珠光体球化、组织超细化和渗碳体溶解、再析出的影响。

For giving an explaintion of strong transmogrification but feebleness metamorphism of and their corresponding relation of the Triassic stratum in Songpan-Ganzi area and opening out the temperature and stress condition, this paper summarized study production of predecessors, and put forward 5 conclusions about Songpan-Ganzi area Triassic main lithology(slate, sandrock,and blastopsammitic) through field geological investigation , actual measurement section plane study and combining indoor slice identification , electron probing and fluid enclosure testing analysis:1.Field outcrop strongly transmogrification, and often developed same cleavages(S1) erection or approximately erection 'B'fold and symmetry similituded fold. 2.The metamorphosed mineral combination is simple, and the typical metamorphosed mineral combination is Al+Chl+Ser+Cc+Q, etc. The metamorphosed mineral develops mainly along the cleavages of the territorial cleavages faces(S1), bearing territorial dynamic metamorphism character and belonging to the lawsonite-albite-chlorite face of slightly metamorphism. 3.Territorial metamorphism P-T change focus on T:180～200oC, P:1～2kbar

为了对松潘-甘孜地区三叠系强变形浅变质的特征及变质与变形的对应关系作出解释，揭示变质与变形的温-压条件，本论文总结前人研究成果，通过野外地质调查和实测剖面研究，结合室内薄片鉴定、电子探针和流体包裹体测试分析，对松潘-甘孜地区三叠系主体岩性(板岩、砂板岩、变质砂岩及千枚岩)的变质作用得出5 个认识结论：1、整个松潘-甘孜地区经受了自北向南的强大挤压；2、变质矿物组合简单，除雏晶黑云母外，典型的变质矿物组合为Al+Chl+Ser+Cc+Q等，变质矿物主要沿区域性劈理面(S1)的劈理域发育，具有区域动力变质作用特征，属于低级变质作用中的硬柱石-钠长石-绿泥石相；3、区域变质作用P-T 变化集中在T：180～200oC，P：1～2kbar

Compared with the predictive and real data in practical project,this article analyzes the major factors which influence the deformation and subsidence of bailey trestle s.

本文结合一实际工程的贝雷片支架搭设及使用情况，通过对支架的变形及沉降的预测和实际观测值的比较，分析了影响支架变形的几个主要因素，并提出了减少该类支架变形和沉降的措施。

The CCT curve s under deformed and undeformed conditions were obtained by way of thermal dilation and metallography.

用 Gleeble-1500型热力模拟试验机研究了含钛高强度钢变形奥氏体在连续冷却过程中的相变规律，用膨胀法结合金相法建立了该钢变形和未变形奥氏体的连续冷却转变曲线，并探讨了该钢的热轧可行性。

Using compressed air ,the machine make the polyester ,acrylic,nylon polypropylene and viscose filament be textured yarn.with the same style of the nature fibre the air textured yarnhas extensive use such as knitted fabric,garment,upholstey,vestee,wall decoration fabric,carpet,etc.by the special style,low cost of production and high capacity,more and more producers are interested the aty.

本机是采用压缩空气对各种化纤进行变形加工。经变形加工的变形丝具有仿天然纤维的外观风格，可广泛用于服装、家庭装饰、地毯、墙布等纺织行业。由于其产品风格独特，加工成本低，产量高，已引起行内人士的强烈关注。

It is revealed that in comparison of the rigid wing case, the wing deformation acceleration in the flexible wing case leads to the added inertial effect which causes a lot of change in instantaneous aerodynamic performance of the wing.

由柔性翼和刚性翼的结果比较发现，附加惯性效应是动态变形影响气动性能的主要原因，变形加速率决定了瞬时气动性能改变量的大小，相比之下，动态变形对气动性能时均值的影响则弱得多。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。