变小的

In the past, the high frequency resonance technique is usually applied in the envelope detection for a vibration signal with amplitude modulation. When applying the Hilbert transform in the high frequency resonance technique for the envelope detection of vibration signals, the computing burden is very high. On the other hand, when applying the linear least squares analysis method, the computing burden is lower. When applying the envelope detection in the lowest vibration mode, an accelerometer with the low-pass filtering cutoff frequency at 4kHz should be choose.

在过去的研究方法中，振动讯号之振幅调变通常以高频解调分析法应用於包络讯号侦测，而高频解调方法应用希尔伯特转换的包络分析，所需要的计算量是非常的高，若以线性最小平方分析法应用於高频解调分析法中，则所需要的计算量较小，如果以最低模态来估测包络讯号时，可以适当的选取加速规来代替低通滤波器，而加速规的截止频带必须在4kHz左右。

Because the magnetoelectricity characteristic of TA is not linear, huge short-circuit current or large nonperiodic current may make the TA enter the saturated state, which cause the exportation current of the TA very small, making the busbar differential current very large.

母线区外故障时，由于带铁心TA 激磁电感的非线性特性，强大的短路电流及较大的非周期分量都可能使TA 进入深度饱和状态，此时TA 的励磁阻抗将变得很小，一次电流大部分流入励磁支路，导致TA 输出电流很小，使得母线保护差动电流很大，如果不采取一定的措施，极易发生误动。

The results show that dynamic softening is easy to occur in these ingots and flow stress becomes steady finally; the material constants of hot deformation are procedural parameters that stress-level coefficient α, strain rate sensibility exponent m and deformation activation energy Q are all increased with strain increasing, while stress exponent n is decreased gradually; the values α and m of the alloy homogenized are the biggest and the value n is the smallest, dynamic softening effect of the alloy is the most obvious, which can deform evenly; influence of strain on the value Q of the alloy homogenized is a little and the average value of Q is only 176.5kJ/mol, so the alloy is easy to deform; the alloy matrix shows the regular recrystallization grains when the strain is 50%; dislocation cell structure re-formed in the grains with increase of strain.

结果表明：经不同处理的Al-1Mn-1Mg合金均易发生动态软化并最终呈现稳态流变特征；热变形材料常数是过程量，随应变量的增加，应力水平参数α、应变速率敏感性指数m和热变形激活能 Q 随之增大，而应力指数 n 则逐渐减小；均匀化退火后，铝合金的α和m值最大而n值最小，动态软化效果最明显且变形均匀，在该状态下，铝合金的 Q 值受变形量影响小，平均仅为176.5kJ/mol，易进行热变形；当应变量为0.7时，基体呈现规则的再结晶晶粒组织，随着应变量的增加，晶内重新形成了位错胞结构。

Making use of field matching method,combining with the variational method,the dispersion equation of the ridge loaded ring plane slow wave structure and small signal gain of this type of TWT are presented in this paper.

脊加载环板行波管是一种频带相对较宽的大功率行波管，本文用场匹配和变分原理相结合的方法，研究了脊加载环板慢波结构的导波特性及这种行波管的小信号、大信号特性，讨论了结构的几何尺寸及电子注参量对慢波的传播特性、小信号增益及注波互作用非线性效应的影响。

Dinosaur-motif bedding, round rock- or bone-shaped pillows or primitive beanbags could have rounded out this design.

恐龙主题风格的床上用品，圆形的小岩石或骨形的枕头还有一些简单的游戏用的小布袋，这一切会让这个设计变的更加丰满起来。

The design on the receiver of Strong Current Source TEM and the data collection system. In order to increasing the depth of exploration and enhancing the measure precision, it need to decrease the minimal discriminable voltage, besides increasing the current intensity. 3. the program of interpretation software and precision of interpretation.

强场源瞬变大地电磁系统的接收机及数据采集系统设计问题在加大工作电流的同时，尽量降低系统的最小可分辨信号电平，这就意味着探测深度与精度的相对增大与提高，这对数据采集系统提出了更高的要求，要求数据采集系统动态测量范围大，最小可测电压的能力与信噪比高。

In this paper, the 3-D finite element relocating mesh method is used to calculate the temperature field and the thermal creep stress field of spillway dam and mid level outlet dam in certain roller compacted concrete gravity dam, sensitivity analysis have been down with different parameters, such as placing temperature, the location of cooling pipe, cooling temperature, time for water supply, ascended-layer of concrete, intermissive time and different placing time, and the commendatory construction scheme have been put forward in such analysis; according by the test result on the two scheme of concrete aggregate combination (basalt as coarse aggregate and limestone as fine aggregate, basalt as coarse aggregate and basalt as fine aggregate), simulation analysis on temperature field and thermal creep stress field of the commendatory construction scheme have been down, and analysis have also been down on temperature field and thermal stress field of the two different aggregate combination, the result indicates that the spillway dam and mid level outlet dam which adopted these two aggregate combination can both satisfy the require of design crack resistance in concrete, furthermore limestone as fine is better than basalt as fine aggregate; the effect of summer water storage and winter water storage on the temperature field and thermal stress field have been analyzed, comparing with winter water storage, in summer water storage scheme the maximum tensile stress at abnormal concrete in upstream fill is decreased by 0.1～0.3MPa and there are no evidence change of the maximum tensile stress at other parts, which indicate that summer water storage is avail for the crack resistance of upstream fill; according to the simulation calculating result and comparing temperature simulation calculating results and temperature controlling measures of some similarity projects both completed and construction, synthesis appraise have been carried to the design temperature controlling measures of dam, and the temperature controlling measures of this project have been brought forward, all these have great reference value on the design of temperature controlling measures and the optimization of the construction scheme.

本文采用三维有限元浮动网格法仿真计算程序，对某碾压混凝土重力坝的溢流坝段和中孔坝段分别进行了三维有限元温度场和温度徐变应力仿真计算分析，对浇筑温度、冷却水管的布置方式、冷却水温、通水时间、浇筑升程和间歇时间、不同开始浇筑日期等参数进行了敏感性分析，在此基础上提出了推荐的施工方案；根据两种骨料方案(玄武岩粗骨料+灰岩细骨料方案；玄武岩粗骨料+玄武岩细骨料方案)的混凝土性能试验研究成果，对推荐的施工方案进行了温度场和温度徐变应力仿真计算，并对比分析了两种不同骨料情况下的温度场和温度应力，结果表明溢流坝段及中孔坝段采用上述两种骨料均能满足混凝土的抗裂设计要求，且灰岩细骨料优于玄武岩细骨料；计算分析了夏季蓄水和冬季蓄水对坝体温度场和温度应力的影响，夏季蓄水方案与冬季蓄水方案相比，坝体上游变态混凝土区域最大拉应力小0.1～0.3MPa，其他部位最大拉应力无明显变化，夏季蓄水对坝体上游面混凝土的抗裂有利；根据仿真计算成果并通过比较国内一些已建和在建的类似工程的温度仿真计算成果及采取的温控措施，对大坝的设计温控措施进行了综合评价，并提出了该工程的温控措施，对温控设计和优化施工方案具有重要参考价值。

Firstly, the specific surface area of nano-coated particle is much larger than that of ordinary wollastonite, and the edges formed in comminuting is passivated, which made the slippy crystal surface coarsened. At the same time, the color of nano-coated particle became whiter, which fit for light ware. Secondly, if the coated wollastonite hasn't been modified by coupling agent, the toughness of PP/ wollastonite composite couldn't be improved.

在硅灰石表面包覆上纳米级SiO2小颗粒对硅灰石的应用特性有重要影响：①纳米包覆粒子填料的比表面积比普通硅灰石大，纳米级SiO2小颗粒钝化了由于机械力粉碎造成的硅灰石的棱角，使其平滑的晶体解理面变得粗糙，同时硅灰石粉体白度增大，可应用于浅色制品。

We wanted to make a story on diversity, an amusing story for children. That is why "Spotless" was born, the story of a white fat, ugly dog fallen in love with a wonderful black white-spotted dog lady. To win her love he decides to paint his coat with some black spots, so he turns into the finest dog in Dog Town and he wins her heart over.

那时候，正思索著要写一本大人小孩都可以看的书，於是有了 'Spotless'的诞生，内容在描述一只白色肥肥的、丑丑的小狗，爱上了一只有著黑白斑点的母狗，为此他跑去买一件衣服上面画满黑白斑纹，然后把自己变的很绅士，到了小狗城去赢得这位小姐的芳心。

Secondly, the incisors grow faster, then the beginning of next to no longer permanent, in the "free" environment will, of course, a large growth, but within the next two years to grow permanent incisors on the natural limits; the most important point is that "parents feel that the incisors are the wrong impression", after the permanent teeth will not grow up stereotypes, so on the child's little face, mouth does not match, it appears to "Super", as the children grow up day by day face, bone development, facial development, such as children and adults will face the size of incisors is coordination of the match,"So we say that time will the children from 'ugly duckling' change 'Swan'."

其次，门牙长得快，这时旁边的恒牙都没开始长，在&无拘无束&的环境下当然会生长得大一点，但两年内旁边恒牙长出就自然限制了门牙；最重要的一点是，&觉得门牙大都是家长的错觉&，恒牙定型后不会再长大，所以放在孩子的小脸、小嘴中不匹配，才显得&超级大&，随着孩子脸形一天天长大，骨头发育、面部发展，等孩子成年时门牙就会和脸形大小十分协调、般配了，&所以我们说时间会让孩子由'丑小鸭'变'天鹅'&。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。